查询词典 hinge strap

Trough calculation, it is obviously reasonable to ignore the effect of joint bending stiffness and consider it as a hinge joint in calculation.

通过比较可知，在计算中忽略节点抗弯性能对结构的影响，把节点看成铰接是合理的，而忽略节点局部平动刚度对结构的影响，把节点看成理想铰接却引起了较大的误差。

This hinge prosthesis of elbow joint shows good biocompatibility to host, and can relieve pain, improve elbow joint function, and reduce postoperative complication.

国产定制铰链型肘关节与宿主有良好的生物相容性，可以恢复肘关节功能，减轻疼痛，置入后并发症较少。

Joint distribution system is the Nerve network of the chain enterprise. As the basic operation establishment, distribution center that is the nerve hinge of joint distribution plays an important role in joint distribution.

共同配送体系是连锁经营的"神经脉络"，配送中心作为共同配送运作基础设施，构成共同配送活动的神经枢纽，对实施共同配送发挥着重要的作用。

When the boom arms are shut, these cannons still point forward due to a limited hinge joint that locks them into place.

当悬臂收起，一个狭窄的铰键关节将它们锁定在仍旧朝向前方的角度上。

The buckling numerical analysis was made to the rod which is hinge joint and uniform cross section under the axial dynamic loading,basing on the finite element theory.

阐述了动力屈曲分析的Ansys/Ls-dyna有限元理论，基于该有限元程序对两端铰接、等截面直杆在轴向动力载荷作用下的屈曲过程进行了数值模拟和分析。

Bent frame with plane arrangement is considered as the most commom method in practical design based upon the study of hinge joint frame design in monolayer workshop,however,author points out that space influence to side-move distortion and reinforcing of frame pole is more accordant with practical condition.

通过对单层厂房铰接排架的设计分析研究，确定了按平面排架计算是设计人员目前在实际设计中最常采用的方法，指出空间作用对排架的侧移变形及排架柱的配筋更符合实际情况。

The method propose the space hingeconcept to the traditional element joint hinge,which can account for the effects ofresultant interactions at element end and elastic unloading.

此方法赋予了杆端塑性铰以空间铰的概念，它既考虑了杆端处内力间的相互影响；也计及了弹性卸载的影响。

This thesis contains three parts: The first part focused on the simulation of the dynamic buckling for rod impacted by dynamic force and rigid body in axial direction, which is hinge joint and uniform cross section, basing on the ANSYS/LS-DYNA and PAMCRASH.

本文的研究工作主要有三部分组成：第一部分基于有限元程序ANSYS/LS-DYNA、PAMCRASH分别对两端铰接、等截面直杆在轴向动力载荷作用下的屈曲和刚性块轴向冲击作用下直杆的动力屈曲过程进行了数值模拟和分析。

When joint stiffness was outside of sensitivity region, the jointed connection can be regarded as hinge or fixed joint, otherwise the stiffness of connection should be considered specially.

对Eurocode8做了简单介绍，并与我国抗震规范进行了一些对比，以一个装配式预制混凝土框架结构为例，比较采用两种规范进行抗震设计的差异。

Analysis had been carried out on the models of representative deck thickness and hinge joint depth with centre load and side load applied.

分析结果表明，随着桥面板厚度的增加，板梁挠度及板梁底横向拉应力逐渐减小，铰缝内的横向拉应力和竖向剪应力逐渐减小；随着铰缝深度的加大，各板梁挠度差逐渐减小，板梁底横向拉应力逐渐增大，铰缝内的横向拉应力和竖向剪应力逐渐减小；并且随着桥面板厚度的增加，铰缝深度对板梁桥的刚度及受力性能的影响效果逐渐降低。

The second is to cut a mere 100 calories from your diet , which is the equivalent of a tablespoon of butter.

第二个就是从你的饮食中减少一百卡路里，只是相当于一大汤匙的黄油。

This is where the Rorschach test comes in.

现在，罗氏测试就出现了。