查询词典 glide angle

Biomechanics of should joint at the empty out and transition moment: In the instant of leaving of the left foot, the angle between shoulder and hip was 27°, the angle of pull was 150°, the angle of axis between shoulder was -12°; In the instant of touchdown of the right foot, the angle between shoulder and hip was 72°, the angle of pull was 151°, the angle of axis between shoulder was -85°, the speed of left shoulder was 2.43 m/s, the speed of right shoulder was

腾空和过渡阶段肩关节的生物力学指标：左脚离地瞬间肩髋角度为27 ，拉引角度为150 ，肩轴角度为-12 ；右脚着地瞬间肩髋角度为72 ，拉引角度为151 ，肩轴角度为-85 ，左肩速度为2.43m／s、右肩速度为1.37m／s；左脚着地瞬间肩髋角度为58 ，拉引角度为136 ，肩轴角度为19 ，左肩速度为3.49m／s，右肩速度为1.89m／s。

Methods: 48 patients with Angle's Class II,division 2 malocclusion, 60 patients with Angle's Class II,division 1 malocclusion, as well as 15 patients with high-angle and 15 patients with low-angle facial skeletal type in Angle's Class II,division 1 malocclusion were separately compared with 50 patients with Angle's Class I who had normal profile by cephalometrics .

分别选取48例安氏II类2分类错患者、60例安氏II类1分类错患者以及各15例典型安氏II类1分类高低角骨面型患者为研究组，以选取的50例安氏I类正常面型患者为对照组。采用反映面骨关系的一般性测量项目与作者针对唇齿关系设计的测量项目进行比较分析。

The upper movable stand that is fixedly connected with the glide cushion block is glidingly connected with the lower movable stand. The rope adjusting cylinder that is connected with the gliding cushion block is fixedly connected with the lower movable stand. A load transducer is fixedly arranged at the connecting part of the glide cushion block and the connecting rod of the rope adjusting cylinder.

上移动架与下移动架滑动连接，上移动架与滑动垫块固定连接，调绳油缸与下移动架固定连接，该调绳油缸与滑动垫块接触连接，在滑动垫块与调绳油缸连杆的连接处固定连接载荷传感器。

Glide slope is in east of runway, B type waiting line is in glide slope station sideward.

E1、机场下滑台位于跑道的东侧，在下滑台侧方设有B型等待线。

As walk-off angle and acceptance angle of beam limit the conversion efficiency and the tunable wavelength range of difference frequency generation, research include effective nonlinear coefficient, walk-off angle and acceptance angle as functions of wavelength, the relationship between conversion efficiency and acceptance angle, and the impact of crystals length on the process of frequency conversion.

由于光束的走离角、允许角限制了转换效率和差频调谐波长范围，研究内容还涉及了有效非线性系数、走离角和允许角与波长的关系，转换效率与允许角的关系，以及晶体长度在频率变换过程中产生的影响。

Based on force diagram an analytical expression between some factors and splaying angle of the bar is brought forward, pointing out that splaying angle of the bar should be 2 3 degrees, and slitting angle should be 30 degrees approximately, outboard slant angle on the slitting groove should be 45 50 degrees and bite angle should be 7 8 degrees.

为稳定小规格带肋钢筋的三线切分轧制，对涉及棒材张开角的切分孔孔型诸角度进行了分析，通过对轧件受力状态的讨论，提出了诸因素与棒材张开角之间的解析式，指出满足三线切分稳定轧制时的棒材张开角应为 2°～ 3°，相应的孔型切分角为 30°左右，孔型外侧壁倾角应在 4 5°～ 5 0°之间，咬入角可控制在 7°～ 8°之间等。

Under the vertical load, the strength of rock mass is higher when there is only one group of joint and the dip angle is less than 20 or higher than 80; When dip angle is between 20 to 80, the strength of rock mass is much lower, it is smallest when dip angle is about 50, and it is lower when this kind of dip angle is in combination with other angle.

7在铅直向荷载作用下，岩体中只存在一组倾角小于20°或者大于80°时，岩体的强度相对较高；当岩体中存在一组节理的倾角在20°～80°间时，岩体的强度值很小，而且在与其他倾角的节理组合时，岩体的的强度值变化不太大，特别是当节理倾角为50°左右的时候，岩体的强度相对最低。

Exterior Opposite Angle Area : According to one angle area of the triangle, if we extend the two angle lines to the opposite direction, the area formed by the extending lines which like mirror area to the original angle is called here Exterior Opposite Angle Area.

外部对角映射区：针对三角形的一个角，将构成该角的两条相邻线段进行对角方向的虚线，这两条虚线围成的区域就是该三角形一个角的外部对角映射区。

Exterior Opposite Angle Area: According to one angle area of the triangle, if we extend the two angle lines to the opposite direction, the area formed by the extending lines which like mirror area to the original angle is called here Exterior Opposite Angle Area.

外部对角映射区：针对三角形的一个角，将构成该角的两条相邻线段进行对角方外部对角映射区向的虚线，这两条虚线围成的区域就是该三角形一个角的外部对角映射区。

With a dip angle between 15° and 30°, the uplift of an obducted plate during continental collision is much higher, and able to form a high mountain. The uplift is greatest with a dip angle of 15°; whereas with a dip angle between 30° and 45°, the subduction depth of a plate is much deeper, and able to form a deep basin. The subduction depth is greatest with a dip angle of 45°. When the dip angle is equal to or greater than 75°, subduction and obduction movements between two continents become undistinguishable.

当断裂带倾角在15~30°时，两个大陆板块碰撞导致的仰冲板块一侧隆升高度相对更大，利于形成高大的山脉，其中以15°倾角对应的仰冲板块一侧隆升最高；当断裂带倾角在30~45°时，两个大陆板块碰撞导致的俯冲板块的俯冲深度相对更深，利于形成深陷的盆地，其中以45°倾角对应的俯冲陆块一侧俯冲最深；当断裂带倾角≥75°时，两个大陆板块之间的相对俯冲和仰冲作用变得不明显。

Core, self psychology is psychoanalytic, but there are crucial differences in how the patient-therapist relationship is viewed.

自体心理学的核心是精神分析，但在如何看待患者-治疗师关系方面，自体心理学和精神分析有着根本性的不同。

High-performance cars brake drum production costs increase less than 10%.

高性能汽车刹车鼓的生产成本增加小于10％。