查询词典 foamer

Foamer as a mobility-control agent for a displacing medium could be properly used in WAG process in order to adjust the water or gas injection profile, improve the productivity and obtain better development effectiveness.

由于泡沫可以作为驱替介质的流度控制剂，如果在气水交替注入方式中采用合适的泡沫，则可以改善吸水剖面，提高油层动用程度，从而显著改善气水交替注入方式的开采效果。

The Liberty 20 Gallon Foamer includes a 12 metre discharge hose assembly with stainless steel ball valve and both a fan nozzle and a zero degree nozzle.

在自由20加仑发泡剂，包括一个不锈钢球阀，都一和零度喷嘴风扇喷嘴12米排放软管总成。

The developing principle of MB gypsum fine foamer which takes compound honey-locust abietic acid anionic surfactant as principal composition,is analyzed in theory.

从理论上分析了以复合型皂角松香酸类阴离子表面活性剂为主要成分的MB石膏微发泡剂的研制原理，详细研究了MB微发泡剂在石膏料浆中的起泡条件、起泡性能及其对硬化后的建筑石膏物理力学性能的影响，MB微发泡剂与现有发泡剂的性能比较，MB微发泡剂在纸面石膏板中的应

The electrical conductivity of PVC/CB foam made from carbon black, PVC and EPDM was studied. The bubble structure and resistivity-temperature characteristic were observed. Influences of carbon black content, crosslinker, foamer on conductive properties of PVC/CB foaming conductive composites were investigated.

以特导炭黑为导电填料，聚氯乙烯和三元乙丙橡胶为主基体制备PVC泡沫导电复合材料，研究该复合材料的泡孔结构和阻温特性，分析炭黑含量、交联剂和发泡剂对复合材料电性能的影响。

The porous architecture can be adjusted by the combination of processingparameters such as the weight of starting mixture used per mold and the ratio ofcomposite to foamer as well as n-HA content in n-HA/PA66 composite.

孔隙率和孔隙结构受单模材料用量，发泡剂比例和复合材料中纳米羟基磷灰石含量的影响。

A series of porous metallic matrix with various porosity and good shapes were manufactured through adjusting the partitioning among Ni-Cr filler, high temperature solid grains and foamer by loose powder sintering. The elastic modulus of the matrix was measured.

以松装烧结方法为基础，通过调整Ni-Cr合金钎料、高温固相颗粒和造孔剂的配比，采用合适的烧结工艺，制备出具有不同孔隙率、形貌较好的多孔金属胎体试样，并测量了胎体试样的弹性模量。

The basis function of the coinjection of Nitrogen and steam is increasing the displacement volume and supply the displacement energy on the basis of Nitrogen, the result of the numerical simulation showed that, after the coinjection of Nitrogen and steam (the optional aqueous Nitrogen ratio was 1: 20～1: 50), the theamal readius increased from 30m to 55m more or less, the recovery ratio increased by 5～10％. The production effect of the high cycles steam stimulation will be improved and the pattern infill will be avoided and the economic results will be improved. 4. The poor result of steamflood is another problem. On the basis of the analysis of the foamer mechanism in the propayation, movement and stabilization, this paper showed that the main meachanism of the increasing recovery of the Nitrogen foam and steamflood was the increasing displacement factor and oil displacement efficiency.

三针对蒸汽吞吐加热半径有限（一般30m左右）而蒸汽吞吐轮次已高达5轮以上的具体情况，将氮气与蒸汽混合（套管环空中注氮气，油管中注蒸汽）进行吞吐可增加加热半径1～2倍以上；在对原油流变性研究基础上，对氮气蒸汽原油体系状态进行了分析，指出了氮气在油藏中基本上是以气相方式存在；热氮混合吞吐的基本作用为扩大波及体积和提供驱油能量；在此基础上所进行的热氮混注数值模拟研究表明：蒸汽中加入氮气后（最佳汽氮比为1：20～1：50），加热半径从30m增至55m左右，采收率可提高5～10％以上，大大改善了高轮次蒸汽吞吐的生产效果，可避免大规模井网加密，提高了经济效益。

Under the effect of air pressure produced by air pump, Electronic Foamer makes the diluted carpet cleanser produceplentiful and high-density foam, which will make the dirt react with the cleanser. When the dirt comes into crystal and suspends on the carpet surface, one wet/dry vacuum cleaner is needed to suck the crystal away until perfectcleaning performance.

利用气泵产生气压的原理使按比例稀释的干泡地毯清洁剂在气压的作用下产生丰富的、高密度的泡沫，使地毯深层的污渍经干泡地毯清洁剂产生化学反应后，污渍微粒会结晶并悬浮于地毯表面上，用吸水或吸尘机吸去即可，从而达到理想的清洁效果。

A polymer particle profile modification agent was prepared using acrylic acid and acrylamide as materi- als,adding foamer A and high temperature resistant monomer B.

针对目前油田普遍存在调剖剂用量大、不经济等缺点，以丙烯酸和丙烯酰胺为原料，通过加入发泡剂A和抗高温单体B，制备了聚合物颗粒调剖剂。

EVA/LDPE/ CB conductive foam was made of EVA and LDPE as matrix,HG-1P CB and ACET CB as conductive filler,AC as foamer and DCP as crosslinker.

文章以乙烯-乙酸乙烯酯和低密度聚乙烯为主基体，特导炭黑(HG-1P)和乙炔炭黑为导电填料，偶氮二甲酰胺为发泡剂，过氧化二异丙苯为交联剂，制备了EVA/LDPE/炭黑导电泡沫复合材料。

If you are unfortunate enough to the lovelorn, please tell me, I will help you out, really, please contact me!

如果你不幸失恋了，请告诉我，我会帮助你摆脱困境，真的，请联系我啦！

China's plan to cut energy intensity by 20 percent and pollutant discharges by 10 percent between 2006 and 2010 is a case in point.

中国计划在2006年到2010间降低20%的能源强度和减少10%的主要污染物排放，就是一个这样的例子。