查询词典 filler-in

The results show that, using the cement as a filler, there are no impacts on the high temperature performance, neither do the marshell stability and the split strength; nor the residual stability and the TRS are highly improved, even exceed the original mixture, which explains that using the cement as a filler also is used for the asphalt mixture with PR.

试验结果表明，采用水泥替代矿粉作为填料后，对掺加PR.S添加剂沥青混合料的高温性能几乎没有影响，其稳定度和劈裂强度也没有明显提高；而其残留稳定度和劈裂强度比却得到了很大的提高，甚至已经超过了未掺加PR.S添加剂时沥青混合料的对应数值。

Application: It is the most ideal filler material of reburner , reacting furnace, filler furnace on oil and chemical industries.

应用领域：是广大石油、化工行业中转化炉、反应炉、填料塔中最为理想的填料。

It is the most ideal filler material of reburner , reacting furnace, filler furnace on oil and chemical industries.

应用领域：是广大石油、化工行业中转化炉、反应炉、填料塔中最为理想的填料。

As an important parameter measuring the inter-function of mine filler/glue stock, the higher is Wa/γSL, the stronger is the inter-function of mine filler/glue stock. Then the composite material will have a better mechanical property.

作为衡量矿物填料/胶料基体相互作用强弱的一个重要参数， Wa/γSL值越大，矿物填料/胶料基体相互作用就越强，所形成的复合材料就具有较好的力学性能。

The ambient-temperature tensile strength of the joint brazed with Cu-Co-Ti filler metal is slightly higher than that brazed with Cu- Ti filler

两种接头的的室温拉伸强度均较低，但Cu-Co-Ti钎料接头的强度高于Cu-Ti钎料接头。

The effects of brazing temperature on spreadability of series Ni-P filler metal and mechanical property of the stainless steel joint brazed with the filler metal were studied.

中文摘要：研究了钎焊温度对Ni-P系钎料铺展性能及其真空钎焊0Cr13不锈钢接头力学性能的影响。

AgCuTi active filler metal exhibits a good wettability to brazing cBN, joint interface between filler metal and cBN is compact, and a reaction layer is formed between them.

AgCuTi 活性钎料对cBN的润湿性较好，界面结合紧密，并在界面处形成反应层。

Ag-Cu-Ti active filler metal exhibits a good wettability to brazing c-BN, joint interface between filler metal and c-BN is compact, and a reaction layer is formed between them.

Ag-Cu-Ti活性钎料对c-BN的润湿性较好，界面结合紧密，并在界面处形成反应层。

The results demonstrate that welds with good appearances could be obtained when welding with the appropriate processing parameters. The as-welded joint tensile strength without filler wire is 180.7 MPa, while the tensile strength is 190 MPa when welding by one side with the filler wire of AlSi12 or AlMg4.5MnZr.

研究结果表明，在合适的工艺参数下，可以获得表面光洁、正反面焊缝成型良好的对接接头；焊态下，单面焊接不填充焊丝的接头强度为180.7 MPa；单面焊接填充AlSi12，AlMg4.5MnZr焊丝的接头强度最低为190 MPa，且两种填充焊丝接头的拉伸强度无明显差异；双面焊接填充AlMg4.5MnZr焊丝的接头强度达到200.7 MPa，约为母材的90%。

The HA sinter with optimal strength and porosity could be obtained when HA was mixed with 1 of fold sucrose which was used as filler while binder and 1 of fold salt as filler, pressed under 5-45 kgf/cm2 force, dissolved the sucrose at 220°C, and then sintered under 1345°C for 10h.

目前得到，使用砂糖及食盐当作填充剂，以HA比砂糖比食盐为1比1比1，5-45 kgf/cm2的压力压制成形，再以220°C下加热使砂糖溶解，并且在1345°C烧结10小时的烧结物的强度以及孔隙度为最佳。

Cynanchum Lingtai apricot production in the average weight 65 grams, the brightly-colored fruit, juicy rich, sweet-sour taste, sweet from the nucleolus, when the late Qing Dynasty famous Shaanxi, Gansu provinces, the Qing imperial court Tongzhi tribute for years.

灵台生产的牛心杏平均单果重65克，果实色泽鲜艳，汁多味浓，甜酸适口，离核仁甜，清末时就驰名陕、甘两省，清同治年间曾为朝廷贡品。

Chenopodium album,Solanum nigrum, and Amaranthus retroflexus were very susceptible to the herbicides. Polygonum persicaria and Abutilon theophrasti were relatively less susceptible to the herbicides, and Lycopersicon esculentum was not susceptible to it. The relationship between reduction rates of weed biomass and PPM values of weed leaves 2,4, and 6 days after treatment was established.

供试的6种杂草对该混剂的敏感性存在显著差异：红心藜Chenopodium album、龙葵Solanum nigrum和反枝苋Amaranthus retroflexus对该混剂最敏感，ED90值分别为47.65、71.67和29.17g/hm2；春蓼Polygonum persicaria和苘麻Abutilon theophrasti敏感，ED90值分别为96.91、114.20g/hm2；而番茄不敏感。