查询词典 fault current

It is an effective approach to ensure the non-exceeding of the breaking capacity of line breaker by adopting fault current limiter to restrain short-circuit current when the grid is in fault.

采用故障电流限制器来抑制电网故障时的短路电流是保证断路器遮断容量不致超限的有效方法。

The thyristor and stator winding have different topology architecture when the inductionmotor is controlled by the thyristor. Based on the fault characteristics of the inductionmotor, the current through the thyristor and the stator winding are studied when theshort-circuit or open-phase fault is occurred. The reasonable protection method based onthe different topology architecture is given in the thesis, and the induction motor and theover-current of the thyristor are reliably protected.

在分析异步电动机一般故障特性的基础上，针对采用晶闸管对异步电动机进行节能控制时晶闸管与异步电动机绕组所形成的不同拓扑结构，详细分析了在发生短路、断相等各种故障时晶闸管与异步电动机绕组中通过的电流，为实现晶闸管的过流速断和异步电动机的可靠保护提供合理的保护判据。

The following functions can be realized: Measuerment:the effective values of three phase current and voltage, power frequency, active power, reactive power, power factor etc. Motor control: direct starting, converse starting, star and triangle starting, self-starting. Protection:thermal overload protection, current leakage protection, open-phase protection, three-phase unbalance protection, over voltage protection, loss voltage protection, low load protection and fault warning and fault dates memory. Communication: communication of the computer in control room and the microcomputer monitor in the spots is realized by the interface of RS-485. The motor is not only controlled in the spots but also in control room. The dates, information and some functions are shared by the spots and control room too.

该电动机监控器以80C196KC单片机为核心，通过采样三相电流﹑电压信号来实现以下功能：三相电流﹑电压有效值，电网频率，有功功率，无功功率及功率因数等的测量；对电动机实现直接、正反转、星三角及自起动控制；对电动机实现热过载、漏电、断相、三相不平衡、过压、欠压及轻载保护，对故障进行报警及数据记忆；通过RS-485串行接口与中央控制室计算机实现通信功能，对电动机既可本地，也可远程控制；实现控制现场与控制室之间数据、信息、功能共享。

A new algorithm of discrimination between inrush currentand fault currentof transformer is brought forward based on self- correlation analysis,which is to calculate self- correlation coefficients of variant periods after analyzing the sam pling data and then discrim inate between inrush current and fault current by using the m agnitudes of the calculated coefficients.

提出一种利用数字信号处理中的相关函数的基本概念，对采样数据进行分析，计算采样数据在不同时段上的自相关系数，利用自相关系数的大小来区分变压器励磁涌流和内部故障差流的新方法。

When normal operation the saturated transformer type SSFCL is equivalent to original transformer coupling solid state fault current limiter, but the coupling transformer coil enters deep saturation when short circuit fault occurs. After the SCR bridge withdraws from the system connection, the saturated coil reactance and the leakage reactance of coupling transformer play the role of limiting stable short-circuit current, equivalent to SSFCL with bypass inductance.

饱和变压器型固态限流器正常运行时等效于原来的变压器耦合固态限流器；但在短路限流时允许耦合变压器铁心进入深饱和；在桥路退出系统后，饱和激磁电抗和漏抗起到限制稳态短路电流的作用，等效于带旁路电感的固态限流器。

The most common ratio using current asset and current-liability data is the current ratio, which is current assets divided by current liabilities.

利用流动资产和流动负债数据计算的最常见的比率是流动比率，即流动资产除以流动负债。

Backset current area, the important factor of burner performance was discussed on the basis of carrying on numerical simulation to the cement kiln with three-channel burner by the model of. RNG k-ε. The model that backset current area was divided into center backset current area, interior backset current area, and other backset current area was compared in three-dimensional condition.

在采用重整化群κ-ε模型对水泥窑用多通道燃烧器进行数值模拟的基础上，针对影响燃烧器性能的重要指标－回流区进行讨论，将三维条件下燃烧器的流场分布与传统燃烧器流场进行劝比，提出了三维条件下燃烧器回流区分为中心回流区、内回流区、外回流区3个回流区的分布模型，并分析了影响回流区的直流风和旋流风2个重要因素。

The instantaneous current capacity may demonstrate through the nixietube, provides the craft data reference for the operator.8031If the system the setting value carries on again the current capacity actual value the comparison, calculates the control quantity after the PID adjustment operation vi, again transforms into the electric current output signal, after but controls the silicon-controlled rectifier after the enlargement the breakover angle, the realization adjusts the slippery difference electrical machinery magnetic clutch exciting current the function, thus the adjustment implementing agency slippery difference electrical machinery rotational speed, causes to transport on the leather belt the material current capacity to stabilize as far as possible nearby the setting value, and has the good static target and the dynamic performance.

瞬间流量可通过数码管显示出来，为操作人员提供工艺数据参考。8031系统再将流量实际值与其设定值进行比较，经PID调节运算后计算出控制量vi，再转换为电流输出信号，而后经放大去控制可控硅的导通角，实现调节滑差电机电磁离合器励磁电流的功能，从而调节执行机构滑差电机的转速，使输送皮带上的物料流量尽可能稳定在设定值附近，并具有良好的静态指标和动态性能。问题补充：希望大家不要给机器翻译的答案，我想要人工翻译的，谢谢大家了

Secondly, the discharge characteristics were investigated. As the RF power was switched on and the matching impedance suitably set, a pale-purple glow was initially generated near the wall. With increasing RF power, the pale glow evolved into bright white glow. Analysis of voltage and current wave forms suggested that both the voltage and current wave forms are predominately sinusoidal and discharge cycle was above 100 nanoseconds. Current-voltage curve showed that discharge current increase as voltage increase without any abrupt; The current-voltage phase angle suggested that the plasma evolved from being predominately capacitive to predominately resistive. Discharge mode was essential an abnormal glow discharge plasma.

其次对装置的放电特性进行了分析，从放电的现象看，随着放电功率的提高，放电颜色由开始的暗紫色过渡到亮白色；从电流-电压波形曲线图发现所有的放电电流和电压曲线都是正弦曲线，放电的周期达到上百个纳秒；从电流—电压曲线分析，电流随着电压的增长而增长，并没有发现任何的突变现象；从电压—电流相位角来看，随着电流的增大，相位角基本保持不变，整个电路表现出容性放电性质，但是电阻性成分已经很强，属于反常辉光放电区域。

It consists of circuitry that this constant current circuit stabilizes the criteria of a highly precise returned type constant current circuit of operation in another constant current circuit,Furthermore, the voltage amplification with very high stability is realized by adopting this constant current circuit also as the bias circuit of a first rank cascode and the 2nd step cascode, and the 2nd step constant current load intensity.

它由电路，这恒流电路稳定的标准，一个高度精确的返回式恒流电路的运行在另一恒流电路，此外，电压放大具有极高的稳定性，实现了通过这项恒流电路也作为偏见电路的第一级和第二栅栅一步，和第二步骤恒定电流负荷强度。

If you were not , and OS X just booted normally, have no fear.

如果你没有，和OS X刚刚启动通常，没有恐惧。

I only want to preserve our all .

我只想保存好我们的一切