查询词典 electric current

The inward current in OHCs was totally inhibited after the superfusion of 100μmolIL and 200μmo1/L linopirdine respectively. The outward rectifier K(superscript +) current I(subscript K was the dominant K(superscript +) current in the whole cell currents in Deiters' cells. In the presence of 200μmol/L linopirdine, the current was not significantly affected.

在细胞外液中，加入100μmol/L利诺吡啶后，OHCs中的四乙基二乙胺敏感的钾电流峰电流成分被抑制，稳态电流幅值减小，且电流的失活时间常数明显延长；在细胞外液中加入100μmol/L利诺吡吮后，OHCs的内向性钾电流I被完全抑制；而细胞外液中利诺吡啶终浓度为200μmol/L时，Deiters 细胞的外向整流性钾电流幅值无明显变化。

After the application of 100μ M linopirdine to OHCs, the peak K+ current was reversibly blocked and the late K+ current was partly reduced. In addition, the decay time constant of the TEA-sensitive K+ current was prolonged in the presence of 100μ M linopirdine. The inward current in OHCs was totally inhibited after the superfusion of 100μ M and 200μ M linopirdine respectively.

结果发现，在正常细胞外液中，单离外毛细胞可记录到四乙基二乙胺敏感的外向性钾电流和静息膜电位附近激活的内向性钾电流（ the K+ current activated at negative potential， IKn）两种钾电流，而单离Deiters细胞中只记录到外向整流性钾电流。

Is coaxial actuates a alternator based on Simens PLC and its the network direct current velocity modulation system by a direct current motor, the direct current motor to actuate with the direct current velometer and to be loaded with revolves the encoder examination rotational speed; The generator electricity generation voltage after the numeral demonstrated the table demonstrated and delivers to the PLC simulation quantity load module.

在工业控制过程中，继电接触器控制系统因其没有运算、处理、通讯等功能，而不能完成复杂的控制方式，20世纪60年代PLC控制系统应运而生，它综合了计算机技术、自动控制技术和通信技术等现代科技，是当今工业自动控制的标准设备之一；70年代以后，又相继出现了集散控制系统DCS、现场总线控制系统FCS，现在以及今后很长一段时间内会是三种控制方式并存的局面，在这一背景下该文分析PLC控制的现状及发展前景。

With this important concept which the reads of wattmeter was equal to the product of the effective value of the voltage across the potential coil, the effective value of the current flowing in the current coil, and the cosine of the phase-angle between the current and the voltage. It was speciled with some examples to determine the phase-angle measured between line voltage, line current in different connection.

围绕有功功率表的读数等于该功率表电压线圈所接电压的有效值、电流线圈所通过的电流的有效值以及电压与电流相位差余弦的乘积这一重要的概念，用实例说明在不同的接线情况下如何利用各电量的相量关系来确定所测的线电压、线电流之间的相位差角。

A A Class 2 circuit as defined in 3.6; b A limited-voltage/current circuit as defined in 3.32; or c An internal circuit not conductively connected to another source of voltage or current (the voltage or current is received through the receptacle or connector), and the circuit and its components comply with applicable requirements of this standard 28 舞台灯标准 for separation from other than Class 2 and limited-voltage/current circuits.

a 二类电路详见3.6内容； b 限流/限压电路详见3.32或 c 内部电路与其它电压或电流不导电。电路和其元件符合分离不同于二类电路和限压/流电路标准的相关规定。

Compared with the current waveform of current regulator parameter unchanged based on linear modal,the overshoot and torque pulsant of current waveform which using current regulator parameter changed control scheme were smaller.

将测得的电流波形与基于线性模型的电流调节器控制下的电流波形比较，采用本文的控制方案测得的电流波形超调量小，转矩脉动小，控制效果良好。

It is 9.40%.In black current,the quantity of K,Na,Cu,Zn and Fe in natural black current is more than in saxifraga,but the quantity of Mn and Mg in black current is less than in saxifraga.In black current,the proportio...

黑加仑中 K，Na，Ca，Cu，Zn，Fe的含量比马林中的含量高，而 Mn，Mg元素的含量却比马林含量低；马林的维生素 C含量为 1 6.2 2 mg/g，黑加仑的含量为 1 0 8mg/g，黑加仑的氨基酸的总量为 1 。63 %，马林为 1 。1 4%。

Shim current calculation When shim coils are excited by appropriate current, they can generate correcting magnetic field to compensate the imaging magnetic field unhomogeneity. Based on the indirect calculation method, we proposed a novel iterative optimization algorithm to calculate shim current. Because there is a direct proportion relationship between FID signal and magnetic field homogeneity, we use the intensity of FID signal as feedback information to the calculation. Shim current can be worked out in less than 3 minutes. This satisfied the requirement that active shimming should be performed in real time.

5匀场电流计算对匀场线圈施加适当的电流后才能产生校正磁场消除成像磁场的非均匀分量，本文在匀场电流间接计算方法的基础上，利用磁共振成像原理中磁场均匀性与系统FID信号强度成正比的关系提出了一种电流迭代优化算法，将系统FID信号强度的变化作为反馈信息，能够快速计算出匀场电流对成像磁场进行补偿校正，平均耗时不到三分钟，满足磁共振成像系统对有源匀场的实时性要求。

Shim current calculationWhen shim coils are excited by appropriate current, they can generate correcting magnetic field to compensate the imaging magnetic field unhomogeneity. Based on the indirect calculation method, we proposed a novel iterative optimization algorithm to calculate shim current. Because there is a direct proportion relationship between FID signal and magnetic field homogeneity, we use the intensity of FID signal as feedback information to the calculation. Shim current can be worked out in less than 3 minutes. This satisfied the requirement that active shimming should be performed in real time.

5匀场电流计算对匀场线圈施加适当的电流后才能产生校正磁场消除成像磁场的非均匀分量，本文在匀场电流间接计算方法的基础上，利用磁共振成像原理中磁场均匀性与系统FID信号强度成正比的关系提出了一种电流迭代优化算法，将系统FID信号强度的变化作为反馈信息，能够快速计算出匀场电流对成像磁场进行补偿校正，平均耗时不到三分钟，满足磁共振成像系统对有源匀场的实时性要求。

In the environment where it is higher than thermodynamics zero degree, current pulse of faitness is produced by the movement electron in the resistance, it forms the noise current of resistance by addition, the higher the temperature in resistance is, the acuter the electron movement will be, the bigger the noise current will be, therefore the resistance of the thermal noise current is formed.

作者单位：（攀枝花学院电气信息工程学院，四川攀枝花 617000）摘要：在高于热力学零度的环境下，在电阻体内存在大量由运动电子而产生的微弱电流脉冲，经过迭加形成电阻的热噪声电流。

It has to be computed by the host for the actual clock rate.

主控制器可以用来计算实际的时钟速率。

Let's see what you got.

让我看看你的东西