查询词典 electric current
- 与 electric current 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
For a class of Shunt-wound Active Power Line Conditioner, based on analysis of mathematical model of system and target of control, the algorithm of fuzzy variable structure sliding mode control is presented. The control algorithm can avoid complicated calculation of harmonic electric current in traditional control algorithm, and realize the feedback control of electric current. The algorithm is simple and easily implemented.
针对一类并联型有源电网调节器在分析系统数学模型和控制目标的基础上,提出了模糊滑模控制策略,避免了传统控制方法中复杂的谐波电流计算,实现对电源电流的闭环控制,该算法简单、易于实现,仿真结果证实了变结构滑模控制的有效性。
-
Of electric current, voltage and resistor what can make up programmed control to make electric current, voltage and power is accurate read time use within transient state simulative generator of buy pulse form is successive as laden as pulse job has the synchronism outside complete protective function to spark input higher power can shunt-wound job can make, electronic load is all Agilent Dc that the solution of stand-alone of ideal equipment Agilent of power cell and batteries capacity test offers your place to need all sorts of dynamic and laden application undertook optimizing.
电流、电压及电阻的可编程节制电流、电压及功率的切确读回用于瞬态模拟的内置脉冲形发生器陆续与脉冲负载工作存在完整的保护性能外同步触发输入较高功率可并联工作可使到高达240V的负载可利用单输入或多输入主机箱 3年保修期 Agilent直流电子负载是测试与评估直流电源,功率元件和电池容量测试的理想行动措施 Agilent单机解决方案供给您所需的一切 Agilent dc电子负载为各类动静负载应用进行了优化。
-
Adopt one kind of design plan that PLC controls in the protection the main body of a book has been introduced succeeding an electricity in electric system, that capital is designed time is that the KV circuit imports 10 mainly , change into 380 V voltage grades, before the PLC front and back add front to passage and the queen to passage, change before to passage middle course electric current , voltage a train of, the wave filtering the general is exchanged changing waking up with a start for direct-current, the entering carrying out comparison and switch amounts again , controlling conducting entering PLC, by PLC, The malfunction signal is shown out by lamp light or the alarm signal.
本文介绍了在电力系统继电保护中采用PLC控制的一种设计方案,本次设计主要是将10KV线路输入,转化为380V电压等级,在PLC前后加入前向通道和后向通道,在前向通道中经过一系列的电流、电压转换,将交流转换为直流,进行滤波,再进行比较和开关量的输入,传入PLC,通过PLC的控制,将故障信号通过灯光或者报警信号表现出来。
-
The designed terminal can collect too many electric parameters such as voltage RMS, current RMS, digital waveform of voltage and current, active power, reactive power, apparent power, frequency and current temperature etc.
该终端可以采集三相电压、电流的有效值,三相电压、电流的数字波形,三相有功、无功、视在功率,频率,现场温度等各种电力参数,还可以同时采集3路脉冲量,8路模拟量。
-
The designed terminal can collect too many electric parameters such as voltage RMS, current RMS, digitalwaveform of voltage and current, active power, reactive power, apparent power, frequency and current temperature etc.
该终端可以采集三相电压、电流的有效值,三相电压、电流的数字波形,三相有功、无功、视在功率,频率,现场温度等各种电力参数,还可以同时采集3路脉冲量,8路模拟量。
-
The results indicate that back electromotive force increases with increasing current density and decreases by 0.5 V after adding 2% Li2CO3, the feeding period is 15 min measured by the method of electric potential control. Finally, the Al-Li alloy with the lithium content of 7.93% can be obtained by electrolyzing for 3 h at the current density of 0.62 A/cm^2 and at 680 ℃, and the current efficiency can reach 74.1%.
结果表明,反电动势随电流密度增加而增大,加入2%的Li2CO3可使反电动势降低0.5V;通过控制电位法测得加料周期为15 min:在680℃、电流密度为0.62A/平方公分的条件下持续电解3h,最终制得了理含量高达7.93%的铝锉合金,电流效率可达74.1%。
-
Issues added: GTO below the opening of the process and shutdown process: Located GTO anode forward voltage electric pressure, when the increase in positive gate trigger current IG, through N1P2N2 transistors amplification makes its collector current IC2 and emitter current IK increase.
问题补充:下面分析GTO的开通过程和关断过程:设GTO阳极电压力正向电压,当在门极加正向触发电流IG后,通过N1P2N2晶体管的放大作用使得其集电极电流IC2和发射极电流IK增加。
-
By using a speed sensor, it's applied in driving an electric current into a magnetic current and torque current and controlling them.
通过使用速度传感器,该矢量电动机将电流驱动至磁流以及转矩电流中,并对它们加以控制。
-
A prediction model has been proposed to deal with threshold voltage shift as a function of 1MeV neutron flux and gate oxide thickness, and to deal with room-temperature annealing of threshold voltage shift induced-by 〓Coγ as a function of electric field and gate oxide thickness. The commonness and individuality of MOS device degradation between hot-carrier effect and ionizing radiation were investigated. The dependence of substrate current, gate current and threshold voltage shift due to hot-carrier on gate oxide thickness were simulated with MEDICI-2D simulator. The photocurrents of PN junction and bipolar transistor were studied. Their transient responses on varied bias voltages, pulse durations and absorbed doses were simulated. The influences of NPN base width on base and collector photocurrents were investigated. We also studied 1MeV neutron displacement damage in PN junction, and calculated reverse current leakage under the neutron flux of 2. 67×10〓 per square centimeter. 3 The study of nondestructive screening method for MOS radiation tolerance A theoretical and experimental study of nondestructive screening methods for radiation tolerance of nMOS and pMOS were firstly fulfilled. We determined the informative parameters pertinent to the method and proposed how to deal with experimental data and verify obtained results statistically, as well as make the required steps for nondestructive screening. Based on the experimental data of 180 samples of discrete pMOS devices, the relation between sample quantity and correlation coefficient, screening equation, and other significant results were obtained from the threshold voltage shifts of pre-and post-irradiation samples.
二、分立器件电离和位移辐射损伤响应研究在国内首次开展了电离辐射引起的氧化层阈值电压漂移和退火理论研究,编程计算了1MeV中子引起的MOS器件阈值电压漂移与中子通量及栅氧厚度的关系,计算了〓Coγ光子引起的阈值电压漂移及退火的时效曲线与纵向电场和栅氧厚度的关系等,对评估MOS型集成电路电离损伤和加固方法研究,以及论文中开展的MOSFETs无损筛选方法研究奠定了基础;分析了MOS器件热载流子损伤效应与辐射电离损伤效应之间的异同性,利用二维模拟软件MEDICI-2D模拟了衬底电流和栅电流,在不同栅氧厚度下随栅压的变化曲线,计算了热载流子效应造成的阈值电压漂移,研究结果对当前存在的以热载流子效应研究取代电离辐射损伤实验研究的设想,具有重要的参考价值;开展了PN结和双极晶体管电离光电流研究,计算了不同偏压、不同辐射脉宽和不同吸收剂量下PN结光电流的瞬时响应,计算了不同辐射脉宽下NPN晶体管基极电流和收集极电流的瞬时响应,以及基区宽度对NPN晶体管光电流的影响,研究结果对双极器件抗电离辐射损伤响应及加固方法研究具有重要意义;在国内首次开展了器件位移损伤的理论研究,分析了辐射产生的缺陷对电性能的影响,计算了注量为2.67×10〓cm〓的1MeV中子产生的缺陷对PN结反向电流的影响。
-
It is introduced that harmonic current in the electric network and harmonic current detecting method based on instantaneous reactive power theory in the paper,and then it presents the current detecting method in the anisomerous mains voltage,aberrance circuit based on instantaneous reactive power theory .
通过对电网谐波和瞬时无功功率理论在谐波检测中应用的分析研究,作者给出了基于瞬时无功功率理论的检测方法在电网电压不对称、存在畸变时的电流检测方法。
- 相关中文对照歌词
- Electric
- Electric Guitar
- Little Electric Chair
- The Church Of Hot Addiction
- Electric
- Electric Car
- Dance Electric
- Tragedy
- Electric
- I Am Electric
- 推荐网络例句
-
Mr. Putin said there were signs of genocide against the Ossetian people.
普京说,有迹象表明对南奥塞梯人进行了种族清洗。
-
What I'm trying to say, Tristan is...
特瑞斯坦。我想说的是。
-
Petersen largely pays attention to nanotech, but she also draws connections between technology and how it's used.
Petersen的注意力主要放在纳米技术上,不过她也研究技术与如何使用之间的联系。