查询词典 elastic

Based on the analysis of the short life of the bearings in the speed increaser of Morgan finishing unit and elastic spacers and breaking of input shafts,the transformation is made to the output and input shaft bearings and the related parts in the speed increaser ,with the good results.

针对高线摩根精轧机组增速机轴承和弹性垫片使用寿命短，输入轴断轴等事故进行分析探讨，通过对增速机输出轴轴承、输入轴及相关配合零件的改造，取得较好的使用效果。

Based on the analysis of the short life of the bearing s in the speed increaser of Morgan finishing unit and elastic spacers and breaking of input shafts,the transformation is made to the output and input shaft bearing s and the related parts in the speed increaser,with the good results.

针对高线摩根精轧机组增速机轴承和弹性垫片使用寿命短，输入轴断轴等事故进行分析探讨，通过对增速机输出轴轴承、输入轴及相关配合零件的改造，取得较好的使用效果。

In the full-scale aero-elastic model test, it is observed that there exist more than one interval of poor aerodynamic performance, and the non-symmetric erection sequence, while increasing the aerodynamic stability at the very places where aerodynamic performance of symmetric erection sequence is poor, performs worse in some other intervals with a vertical flutter phenomenon.

在全桥气弹模型的风洞试验中发现，采用对称架梁施工方法，在施工过程中会存在颤振稳定性最差的区间，并且这样的区间可能不止一个，而采用非对称架梁施工方法，固然在那些采用对称架梁施工时颤振稳定性较差的区间处提高了颤振稳定性能，但却在另一些施工区间中表现出比对称架梁施工更差的颤振稳定性能。

The nano-hardness and elastic modulus of the ceramic coating were determined using Nano Indenter XP system.

用纳米显微力学探针测定了陶瓷层的纳米硬度和弹性模量。

1 This test method is based on the penetration of a specific type of indentor when forced into the material under specified conditions. The indentation hardness is inversely related to the penetration and is dependent on the elastic modulus and viscoelastic behavior of the material. The geometry of the

4.1本测试方法是根据有关规定，将指定类型的压足压入测试材料进行测量的，反言之，硬度与压入量有关，同时又与材料的弹性模量和粘弹性能有关。

The influence of indentor radius on the plastic deformation has been discussed and some important results are as follows:(1) The influence of the ratio of ceramic coating thickness to indentor radius on the failure of coating, plastic deformation of substrate and crack propagation are obvious.(2)The propagation of crack in ceramic coating is assumes to be of semi-elliptical shape under normal contact with a rigid sphere.(3)Fatigue life of ceramic coating is mainly decided by substrate and load, the lower substrate elastic moduli and load, the more cycles of fatigue.

分析了压头半径对塑性变形的影响，模拟结果表明；(1)陶瓷涂层厚度和压头半径之比对涂层失效、基体塑性变形及裂纹的形成有显著影响；(2)在刚性球压头静态挤压条件下，陶瓷涂层中的预制裂纹按照椭圆形裂纹规律扩展；(3)陶瓷涂层的疲劳寿命与基体和载荷有很大关系，基体弹性模量越小，疲劳寿命延长。

Nano- and Micro-Hardness Testers（Nano Indentor/Micro Indentor）- Quantitative measurement of mechanical surface properties: elastic modulus and hardness - Analysis of fracture modes, cracking,… Nano- and Micro-Scratch Testers - Adhesion and anti-scratch properties of coatings and films - Profilometry Tribometers - High Temperature, Vacuum and Nano Tribology - Wear and Friction studies Calotest / Calowear - Coating thickness measurement - Wear rate testing 3D Imaging - Atomic Force Microscope - Confocal Microscope

动态压痕测试仪器为您提供纳米或微米尺度下材料的硬度、弹性模量、蠕变、断裂韧性等性质。我们还为您提供纳米级、微米级摩擦磨损测试仪器，用以测量材料的摩擦系数和磨损率。我们的球磨仪器是测量薄膜厚度最简单准确的工具。我们同时提供光学显微镜、原子力显微镜、白光共焦显微镜成像工具。我们在瑞士的分析测试中心随时准备为您提供高质量测试服务。

In this paper, from the basic equations of the anisotropic rectangular plate with four free edges on elastic foundation, the exact solution for it is discussed indetail.

本文从弹性地基上四边自由的各向异性板的基本方程出发，详细地论述了如何求得其精确解的过程。

The total differential cross section, elastic differential cross section and inelastic differential cross section for collision between He isotopic atoms and NO molecule have been calculated by using close-coupling approximation method.

汪荣凯 贵州师范大学理学院，贵阳 550001沈光先贵州师范大学理学院，贵阳 550001；四川大学原子与分子物理研究所，成都 610065宋晓书贵州师范大学理学院，贵阳 550001；四川大学原子与分子物理研究所，成都 610065

You should also be familiar with momentum and kinetic energy for elastic and inelastic collisions.

你应该熟悉弹性和非弹性碰撞下的动量和动能变化。

Objective To investigate the effects of interleukin-1 β converting enzyme gene on the biologic characteristics of ovarian cancer cells.

目的 探讨白细胞介素-1 β转换酶的表达，对卵巢癌细胞生物学特性的影响。

Campylobacter: This illness is the most commonly identified cause of diarrheal illness in the world.

弯曲：这种病是最常见的原因查明腹泻病，在世界上。