查询词典 dynamic memory

Based on the whole-system dynamic accuracy theory and the dynamic error decomposition and tracing theory,this paper developed a new theory of dynamic measuring-system accuracy losing diagnosis theory .

基于全系统动态精度理论和误差分解与溯源理论，提出了动态测试系统精度损失诊断理论。

The time and temperature dependence of dynamic modulus and phase angle of hot mix asphalt is analyzed,the master curve of dynamic modulus and phase angle is built using time-temperature superposition principle,the Witczak predictive equation is verified using the test results,which is helpful to provide good reference for China to use dynamic modulus as pavement design parameters.

分析了沥青混合料动态模量和相位角对温度和加载频率的依赖性，利用时间-温度置换原理建立了动态模量的通用曲线，并用动态模量实测结果对Witczak预估模型进行了验证和分析，为将动态模量作为沥青路面设计参数和混合料性能评价指标提供了有益参考。

We proposed the time-changed dynamic models of radar signals based on dynamic theory, and can analyze quality and quantity of the deinterleaving pulse train;(2) We proposed the algorithm to computer selfsimilarity exponent and detect successfully the object echo buried in noise according to self-similarity of noise and nonsimilarity of sine wave;(3) We also proposed a nonlinear dynamic filtering detection model.

1根据动力学理论，提出了雷达信号的时变动力学模型，利用这个模型可以对已经分选出来的雷达信号进行定性和定量分析；(2)提出了快速计算自相似性指数的算法，并利用噪声和正弦波分别具有自相似性和不具有自相似性的特点，成功地检测到淹没在噪声中的目标回波；(3)提出了一种非线性动力学滤波检测模型。

The hot helium temperature follows HTR-10's nuclear power changes slowly, and there is a large coupling between them, so the RPHHT system adopts cascade control, the minor loop is fast, and the major loop is hot helium temperature control loop whose dynamic response is slow; there is also a large coupling between main helium loop and steam-water loop, and both the main steam temperature measure signal and the heating process of the once-through steam generator are delayed, therefore, the MHFMST applies cascade control, the minor is main helium flow control loop whose dynamic response is fast, and the major is the main steam temperature control loop whose dynamic response is slow.

本文运用机理建模法，建立了HTR-10系统动态控制模型，然后进行了动态性能仿真，将堆芯用集中参数表示，冷却剂按一维流动处理；直流蒸汽发生器按二回路工质不同的相分为预热段、蒸发段和过热段，建立了三环节控制模型，得到HTR-10系统控制模型；仿真结果与数值计算结果对比表明，本文所建立的控制模型，能近似地反映HTR-10的动态特性，适合设计控制系统。

This method's characteristics is that shape and gauge close\|circuit control is achieved by means of static load distribution, dynamic load distribution and dynamic setting Automatic Gauge Control,and Bellman dynamic programming is employed in calculation.

该方法的主要特点：系统中采用了静、动态负荷分配，动态设定厚度自动控制系统完成了板形板厚的闭环控制，在算法中采用了贝尔曼动态规划。

Finally, the dynamic characteristics of a full-size flat plate subject to the actual dynamic loads are predicted from those of a scale plate models subjected to the scale dynamic loads and the associated scaling rules.

最后，便可以利用比例法则以及缩小平板承受缩小外部负载时的动态特性，精确的预测原型平板模型承受实际外部负载时的动态行为。

With CAE analysis, multi-body dynamic model of the loader is established with multi-body dynamics software of finite element NAS-TRAN and MSC Adams/View during design period. Various curve functions are added in dynamic analysis model to simulate the terrain excitation on tires and conduct dynamic calculation and analysis. Stress change vs. time of each part is easily obtained when a loader travels on rough terrain. Compared with test results of the physical prototype, the calculation results are relatively consistent.

利用CAE分析手段，在产品的设计阶段，利用有限元NASTRAN和MSC Adams/View多体动力学软件建立装载机的多体动力学模型，通过在动力学分析模型上加入各种曲线函数来模拟路面对轮胎的激励，进行动力计算分析，很容易获得装载机在通过不平路面时各部件应力随时间的变化值，并将其计算结果与物理样机的测试结果进行对比，两者的结果比较一致。

Firstly, two examples, which belong to static analysis and dynamic analysis respectively, were given to show the effectiveness of discrete element method. Then the discrete element method was used to perform dynamic analysis of the Chinese 1 km deep-ocean mining system. The dynamic performance of the entire mining system under different current directions was discussed and compared with that from finite element method.

首先，从静态分析和动态分析两方面，给出2个典型算例，证明该方法的有效性；然后，将离散元方法用于中国1 km深海采矿系统的动力学分析，讨论不同海流方向下整体系统的联动性能，并与有限元方法进行对比。

The dynamic power_adaptive technique has broken the tradition of the static architecture design in the microprocessor field. It offers a power_adaptive mechanism for key hardware resource on the chip. By analyzing the demand of applications through software, the dynamic power_adaptive technique can offer hint information to hardware, make reconfigurations of the hardware sources according to the change of the demand, and close unnecessary or invalid redundant resources. On the premise of guaranteeing performance, the dynamic power_adaptive technique always serves the present application with the most suitable resource, so as to achieve the goal of saving consumption.

动态低功耗自适应技术打破了微处理器设计中静态体系结构设计的传统，为芯片上关键的硬件资源提供一种动态低功耗自适应机制，通过软件分析应用需求，并向硬件提供指示信息，使得硬件资源根据应用需求的变化动态调整，关闭不必要的或者无效空转的冗余资源，在保证性能的前提下，总是以最合适的资源服务于当前应用，从而达到节省功耗的目的。

Analyzing the dynamic behavior of dislocations in the deformed metal at high temperature and high strain rate, a new theoretical model of dislocation dynamic behavior is put forward to describe the dynamic recrystallisation mechanism of the weld metal.

采用本文首次提出的测量摩擦界面温度的半自然热电偶测温法，并结合焊接过程中的急冷凝结组织分析、微区应变速率分析，以及摩擦扭矩测量等相关实验方法，测定了焊接过程中焊合区金属的组织及相应的热变形参数。

"Second Life is remarkably easy to work with, and is very popular,"

"第二次生命是显着容易的工作，并且很受欢迎，"

For example, we usually assume that materials are homogeneous and isotropic and free of internal defects or flaws.

为了得到适合有限元分析的模型，我们必须经过如图2所示的简化步骤。