查询词典 developable surface

The amplitude of the surface velocity of the panel and the acoustic pressure on the porous surface are reduced largely in the vicinity of structural resonances due to the additional radiation damping and visco-thermal absorption phenomenon in the porous layer.

请注意振膜表面速度分布的两种极端情况。一种极端情况产生在作活塞运动的刚性表面中，此时整个表面的振幅和相位是处处相等的。

The surface acoustic wave can disperse when the material properties of near-surface change.

材料近表面性质的变化能够导致在其中传播的声表面波发生色散。

After water treated by LVEF, the scaling ions in the water will be transformed into active fine crystal nucleus which scattering in the treated water by the electric field. These crystal nucleuses have lower surface energy and greater active surface area.

水经低压电场处理后，水中成垢离子会优先在电场中析出并形成活性微晶核分散在处理水中，这些微晶核具有较高的表面能和较大的活性表面，它们更容易吸引水中的成垢离子，从而阻止在换热表面形成垢核并继续长大，从而达到阻垢的目的。

this article discusses the integral theorem of mean the promoted question, mainly has two aspects: On the one hand in analyzes in the teaching material under the first integral theorem of mean condition, had proven lies between the value spot to have to be possible to obtain in the open-interval, further discusses this knot promotes to the generalized Riemann integral, and further proved the conclusion also establishes to the promoted first integral theorem of mean; Promotes on the one hand in addition the integral theorem of mean to in the curve and the curved surface, and has proven the curvilinear integral theorem of mean and the surface integral theorem of mean.

本文讨论积分中值定理的推广问题，主要有二个方面：一方面在分析教材中第一积分中值定理的条件下，证明了介值点必可在开区间内取得，进一步将这个结论推广到广义Riemann积分，并进一步证明结论对推广的第一积分中值定理也成立；另一方面，将积分中值定理推广到曲线和曲面中，并证明了曲线积分中值定理和曲面积分中值定理。

The paper put forward segmentation method of wood surface disfigurement based on fractal parameter and the adjunction of spring and mass of matrix directing at disadvantages of segmentation method of traditional surface disfigurement and calculation methods of fractal parameter.

论文主要针对传统表面缺陷分割方法的不足，提出了基于分形参数的木材表面缺陷分割方法，并针对分形参数计算方法的缺点做了相应改进，提出了增容矩阵的计算方法。

A new digital measure method was presented based on the three coordinate measuring machines. Compensation of sensor radius, establish part's measure reference frame, the best measuring layout and mix programmed scanning all those not only enhance measure precision and increase efficiency of scanning measure, but also the data can image geometrical characteristic of complex surface. The method was illuminate by a sample, and the digital data of the surface adumbration are obtained at last

在三坐标测量机的基础上给出了一种数字化测量曲面轮廓的方法，通过测球半径的补偿、坐标系的建立、最佳测量路径的规划以及混合编程扫描，提高了测量精度及扫描测量的效率，而且采集到的数据可以反映曲面的几何特征，并以实例对该方法进行说明，得到了数字化的曲面轮廓数据。

Finally ,by multidisciplinary analysis of the form of microfacies type ,the thickness distribution of sandbody ,the shape of sandbody and permeability variation, the 4th surface corresponds theⅡ、Ⅲinterbed which control the aeolotropy of the reservoir,the remaining oil distribute along the abandoned channel or under the 4th surface ,and the barrier bed which is separated by abandoned channel is favor place to look for remaining oil .

最后，通过对沉积微相类型、砂体厚度分布、砂体形态展布、渗透率变化等综合分析，认为4级界面对应于Ⅱ、Ⅲ类夹层，其对储层非均质性的控制作用明显，剩余油沿废弃河道或4级界面以下分布，被废弃水道所分隔的隔层下覆的单体是寻找剩余油的有利部位。

The main factors affecting the soil-structure interface behaviors were found experimentally and theoretically, including: 1 the thickness of the interface that is five to six times the average grain size of the soil; 2 the aeolotropy of interface, which is responsible for anisotropic response of the stress-strain response of the interface; 3 two physical states, including crashing and compression of the soil near the structure surface, which govern the stress-strain response of the interface strongly; 4 two shear deformation components due to sliding and constraint of the structure surface relative to the soil respectively, which forms the deformation of the interface; 5 the volumetric strain due to dilatancy, which is found to be composed of a reversible dilatancy component and an irreversible dilatancy component. 4. A unified constitutive model of the interface, based on new elasto-plasticity damage theory, was developed. It was confirmed to be effective for the conditions considering monotonic and cyclic shearing, coupling effect of shear and volumetric strains, evolution of physical state, micro-structure aeolotropy of the soil and the resulting aeolotropy of the interface as well as the three normal boundary conditions stated above. 5. 2D and 3D finite element formulations of the present model were derived and incorporated into the FEM codes. They were applied to the evaluation of practical engineering problems with different typical interfaces between soil and structure. The new model was shown to be reasonable and effective.

确定了粗粒土与结构接触面厚度约为5～6倍的平均粒径，首次揭示了接触面的细观结构异向性以及由此所引起的宏观剪切异向性，发现了在单调和往返剪切荷载作用下土颗粒破碎和剪切压密两种物态变化机制共同支配着接触面力学性质的变化，通过细观分析证实了接触面的变形可分解为一般同时发生的土与结构交界面上的滑移变形以及结构面位移约束范围之内土体本身的剪切变形两部分，观测到接触面受剪时表现出明显的相对法向位移，并可分解为可逆性和不可逆性两个分量；(4)建立了第一个能够统一地描述单调与往返剪切特性、剪应变与体应变耦合特性、细观结构和宏观剪切异向性以及土颗粒破碎等物态变化特性的土与结构接触面弹塑性损伤本构数学模型，并采用多种法向边界条件复杂加载路径的试验成果验证了新模型的合理性和有效性；(5)提出了新模型的二、三维有限元格式并结合实际边值问题进行了应用计算分析，比较了不同接触面本构模型对计算结果的影响，证实了新模型及其有限元格式不仅能够合理地描述土与结构接触面的主要力学特性，还能够较好地反映土体与结构物在接触面处的滑移、脱开等不连续现象。

This paper discusses the theory method calculating surface temperature of ballistic target above aerosphere, and analyses the effect of dimensional orientation of target s flight gesture and sun radiation direction on its surface temperature.

论述了大气层外弹道式目标表面温度的计算方法，对某弹道式目标大气层外飞行过程中当太阳辐射方向改变时其表面温度的变化情况进行了数值计算，分析了目标飞行姿态与太阳辐射方向之间空间方位关系的变化对目标表面温度的影响。

In Brunn-Minkowski-Firey theory, we establish two extremum properties of the new ellipsoid; Then we generalize Petty\'s affine projection inequality and monotonicity results related to affine surface area to L_p—affine surface area; We establish the Brunn-Minkowski type inequalities for the volume of the L_p centroid body and its polar body with respect to the normalized L_p radial addition. At last, we introduce the minimal L_p—mean width of a convex body and generalize the minimal mean width to the Brunn-Minkowski-Firey theory.

在L_p-Brunn-Minkowski理论中，我们首先给出了两个关于新椭球的极值性质；然后研究了L_p仿射表面积，将Petty仿射投影不等式和Winterniz单调性问题推广到L_p仿射表面积；建立了L_p质心体和其极体的Brunn-Minkowski型不等式；研究了凸体的最小L_p平均宽度，给(来源：3bABbeC论文网www.abclunwen.com)出凸体K具有最小L_p平均宽度的充分必要条件，最后给出了凸体L_p平均宽度位置的稳定性。

Pachomius manual labour was organized as an essential part of the monastic life; and since it is a principle of the monks as distinguished from the mendicants, that the body shall be self-supporting, external work of one sort or another has been an inevitable part of the life ever since.

根据圣pachomius体力劳动组织作为一个重要组成部分寺院生活；以来，这是一个原则的和尚，作为有别于乞丐，该机构应自支撑，对外工作的这种或那种已一个必然的一部分，生活至今。

In order to study the effects of parametrical rolling on the ship movement and tilts, in allusion to ship's navigating in regular following waves, the equation of ship rolling motion is transformed into normal Mathieu equation by proper variable replacement when strong parametrical excitation in restoring moment varied according to sine or cosine wave.

为研究参数横摇对船舶运动和倾覆的影响，通过对船在规则波上随浪航行时，恢复力矩中出现的1个以正余弦规律变化的强参数激励项进行适当的变量置换，将船舶的横摇运动方程转换成标准形式的Mathieu方程。