查询词典 contact

By using Transmission Line Model to investigate the ohmic contact of electrode metal and InP semiconductor. We got a low specific contact resistively of 2.24×10-5 Ω-cm2 of the AuBe/Cr/Au contact to p-InP.

我们用Transmission Line Model方式得到低的特徵接触电阻约2.24×10-5 Ω-cm2之AuBe/Cr/Au属和p-InP形成的欧姆接触。

The third approach is about the concept of an ITO direct Ohmic contact structure on GaP window layer. The direct Ohmic contact structure is performed by the deposition of an AuBe diffused thin layer and the following activation process on the surface of a Mg-doped GaP window layer. The presence of this thin AuBe diffused layer yields the Be dominant metallic surface layer and significantly reduces the barrier height between the ITO and p-GaP layer. Via the modification of contact structure, not only the brightness was significantly increased but the reliability was comparable to the conventional LED without this structure.

第三个研究为一种具有直接欧姆接触在p型磷化镓窗层与氧化铟锡界面的制程方法，於本研究中并无习知砷化镓欧姆接触层的存在，我们利用金/金铍金属藉由热退火程序，使其金铍原子在磷化镓窗层表面形成具金属特性之薄膜层，降低磷化镓与氧化铟锡接触产生之接面能障；另外，该元件在氧化铟锡直接欧姆接触於磷化镓窗层下，除亮度具明显提升外，在稍大电流(20毫安培)元件可靠度测试下，亦未有明显衰减情形发生。

The contact curved surface equations and the contact plane surface equations have been worked out. The boundary curve eqations of the contact surface have been founded.

运用数学分析方法，首次对板式楔横轧工艺的轧件稳定旋转条件、轧件不产生缩颈拉裂条件进行了理论研究。

The coefficient of friction for static contact is higher than for dynamic contact, so static contact provides better traction.

此时因为静摩擦系数比动摩擦系数高，所以静摩擦的附着力较大。

The function of the contact line for the conjugate tooth trace is solved by this contact trace function; and also solved the parameters of the contact trace.

根据此齿面方程求解出了共轭齿面的接触线方程；并通过实例求解出了与齿面接触区密切相关的参数解。

The transformation of the contact force from contact point to nodes of contact elements is accomplished according to their shape.

并根据接触单元的形状实现了接触力从被接触点到接触单元节点的转化。

In traditional, the working probe naturally sustaining repeated bending actions and wear, absolutely needs a mechanism to prevent it from being damaged, caused by the change of the probe's geometry and the increase of the contact resistance. Therefore, in this study, we develop a CMOS-based chip in connection with the electroformed probes to detect each of their counterforce, contact resistance to evaluate if their contact force and coplanarity are controlled within safe range.

传统上，探针常因为弯曲作动和磨耗，使几何形状产生改变，进而电阻值提升，使过大的电流通过探针而烧毁，或因共面度不佳部分探针未能确实接触IC焊垫误判成断路，故晶片的制作重点在於监测探针卡上个别探针的回馈力量，当探针量测IC时，可进行即时探针反作用力、接触电阻的检测，进而了解探针卡工作时受力是否均匀、平坦度是否符合要求等性质。

And then switch on the offset printing presses, and tweak the adjustment nut, rubber plastic knife blade slowly to the oscillating roller surface contact, left and right extremes of adjusting screw contact pressure requires uniform, rubber knife and oscillating roll each part can even contact curettement innovativeink across the Board.

然后启不静胶印机，并且拧不静调度螺母，使橡皮胶刀的刀刃迟缓不天向串不朱辊的暗不天隔绝，把握两头的调度螺丝隔绝不张力给求平均，橡皮刀与串不朱辊每一个部位平均隔绝，不妨片面不天刮不兴油不朱。

The effect of tribology factors on bearing vibration is studied experimentally. AR model and WPT are used to processing the normal arid abnormal signals. The results are as follows:1. The vibration of ball bearings is caused by the tribology action of contact pairs of ball and ring races and has the essential of tribo-dynamics. Any factors affecting the tribology characteristics of contact pairs will affect vibration and noise of bearings consequently.2. Vibration characteristics of bearing keep almostly unchanged with the increasing of axial load expecting the increasing of nature frequencies. When radial load increasing with axial load unchanged, nature frequencies keep unchanged but some new vibration peaks appears in the spectrum.3. Vibration amplitudes are damped and nature frequency are enhanced with sufficient lubrication. Vibration and noise of bearings increase obviously and roar can happen and the contact surfaces scratch slightly under insufficient and unclean lubrication state. Bearing will be disabled in a few minutes without any lubrication.4. Bearing vibration is unstable under low speed. With the speed increasing, the vibration become stable and natural frequencies increase slightly but the amplitudes increase apparently.5. Bearing vibration can be excited only by some harmonics ofwaviness without lubrication and by all harmonics with lubrication based on the theoretical analysis.6. The nature frequencies of ball bearings decrease with the increasing sizes. When international clearance increasing, nature frequencies decrease in radial and increase in axial and angular and the amplitudes increase in radial and decrease in axial and angular. When the number of balls increasing, nature frequencies increase and amplitudes decrease. When the pitch diameter increasing, axial nature frequency increase and others nearly keep no change. When outer race groove curvature radius increasing, nature frequencies increase in radial and decrease in axial and angular and amplitudes keep no change in radial and increase in axial and angular. When inner race groove curvature radius increasing, nature frequencies decrease and amplitudes increase.7. The distortion in amplitude and frequency components of bearing vibration signals picked up by the present probe measurement method is founded and right conclusions cannot be achieved by the signals. When accelerometer is rigidly screwed with steel stud onto a flat outer surface of a ball bearing, vibration signal can be got without distortion and the reliability of research on bearing vibration is assured.8. AR model is suitable for large samples of bearing vibration signals, square root of length of samples can be used as the upper limitation of order determination and the FPE order selection criterion is effective. Many advantages of AR spectrum are founded over the classical based on FFT.9. Time-Frequency analysis is necessary for abnormal noise of ball bearings. WPT overcomes the principle shortcomings of STFT and proved to be a best tool to process the abnormal signals.

理论分析和试验研究表明： 1球轴承振动是钢球—滚道接触副中的各种摩擦学作用引起的，具有摩擦动力学的本质，任何对接触副的摩擦学特性有影响的因素都将对球轴承的振动和噪声特性产生影响； 2中心轴向载荷作用下，载荷增大使球轴承的固有振动频率升高，载荷越大同样的载荷增幅引起的频率升幅减小，足够大的中心轴向载荷作用下载荷的变化对球轴承振动的频率特性不会产生明显的影响； 3轴向和径向联合载荷作用下，径向载荷不大时球轴承振动的固有频率基本不变，但是可能引起变刚度激励的非线性振动，出现新的频峰，过大的径向载荷将使部分钢球脱离接触，使球轴承的振动和噪声呈现不稳定状态； 4润滑对球轴承的振动和噪声特性有重要的影响，良好的润滑对振动有明显的抑制作用，润滑不充分时，振动和噪声的水平会有明显增高，一定条件下还会激发接触副中的谐振，发出啸声，造成接触表面的伤害，无润滑干接触时，短时的运转就会损伤接触副表面，使振动和噪声迅速增大，并随时可能引发严重的磨损和卡滞失效；接触副润滑良好时，油膜的"刚化效应"使球轴承振动的固有频率有所提高，润滑剂中含有弥散性污浊时，振动的幅度总体升高，但弥散性污浊不会改变球轴承振动的频率特性；浙江大学博士学位论文：球轴承振动的研究 5低速时，球轴承振动的基本特征呈现不稳定状态，随着转速的提高，球轴承振动的频率特性趋于稳定，固有频率频峰升高； 6理论分析表明，干接触时钢球和滚道表面波纹度的某些谐波分量能激励球轴承的振动，振动的幅值与谐波幅值成正比，实际球轴承中钢球的分布不可能完全均匀，波纹度的激励作用会随时发生；润滑接触的分析表明，波纹度的任意谐波分量均能激励球轴承的振动； 7球轴承的几何和结构参数分析表明，球轴承尺寸越大，径向、轴向和角振动的固有频率越低；钢球中心圆直径增大，球轴承的径向和轴向振动的固有频率基本不变，角振动的固有频率有所上升，振动的幅频特性基本不变；径向游隙加大使球轴承的径向振动固有频率降低，轴向和角振动的固有频率有所升高，径向振动幅频特性的幅值升高，而轴向和角向降低；钢球的数量增多使球轴承振动的固有频率上升，幅频特性的幅值下降，径向振动的幅值下降最为明显；外圈沟曲率半径系数增大使球轴承径向振动的固有频率升高，轴向和角振动的固有频率降低，径向幅频特性基本不变，轴向和角向幅频特性幅值升高；内圈沟曲率半径系数增大使径向、轴向和角振动固有频率均下降，振动幅频特性的幅值均有升高； 8试验对比表明，传感器采用探针式安装时，由于探针接触副接触特性的影响，钡(量得到的球轴承振动信号有失真，采用专门设计和制作的试验球轴承，以固定式安装加速度计，首次测量得到了球轴承振动的真实信号，通过对振动信号的分析，验证了球轴承振动的理论模型； 9)基于时间序列分析的AR模型适用于大样本球轴承振动信号的分析，以样本长度的均方根值作定阶上界，FPE做判阶准则，给出的AR谱光滑，频率分辨率高，是球轴承振动分析的简便而可靠的手段； 10以时频域分析的小波包变换分析球轴承异音信号能够比较好地定位和聚焦异音发生的时间，时间间隔，频率范围，同样是球轴承振动分析的可靠的手段，可用作球轴承故障诊断技术。

There is a single solution included with this download, the solution contains a Win Forms project called "LinqToObjects"; this project contains two forms the main form (frmContactBook and a form used to display the total list of contacts, a serializable class called Contact (used to contain contact related data), and a class entitled, Serializer which contains two static methods used to serialize and deserialize the contact data (writing it to and reading it from a file).

有一个单一的解决方案，此下载包含的解决方案包含一个双赢窗体项目名为"LinqToObjects"，这个项目包含两种形式（主要形式和用于显示的联系人总清单，一表一序列化类的所谓联系方式，以及一个名为，其中包含用于串行序列化和反序列化的联系资料两个静态方法类（书面形式并从文件中读取它）。

I use an example quoted by Hu Jiaqi:"It is reported that America separates the DNA of a kind of virus by making use of genetic technology and combines it with another kind of DNA. Finally, they get a kind of virulent biological agent called a "pyrotoxin". Someone discloses in private that 20 grams of such a kind of biological agent could result in the global death of 6 billion people due to infection."

我在这里例举胡家奇所引用过的例子："据报道，美国利用转基因技术，将一种病毒的DNA分离出来，与另外一种DNA进行结合，拼结成一种剧毒的"热毒素"生物战剂，且私下有人透露，这种生物战剂只需20克，就可以导致全球60亿人全部感染死亡。"

Waiting, for the queers and the coons and the Reds and the Jews.

等待着疯子和黑人还有红色共产主义者还有犹太人