查询词典 coating

The stability of alkaline earth sulfides can be improved by two methods, one is by coating with fluoride or oxides, and another is by forming of complex sulfides with Ga.

可通过两种方法改善碱土硫化物的稳定性，其一是通过用氟化物或氧化物的包覆，另一是通过与Ga生成的复合硫化物。

It is with a release coating on one side; alkyd chemistry based.

这是一个释放涂层的一方；醇酸树脂化学基？

Effects of synthesis technology on the properties of coating film of the alkyd resin were discussed.

讨论了合成工艺对涂膜性能的影响，发现采用非醇解工艺可以缩短合成改性醇酸树脂的反应时间。

The function of nanometer Fe_2O_3 for iron red alkyd primer and way of adding into coating are mainly introduced.

着重研究了纳米Fe2O3对铁红醇酸底漆的改性作用和纳米Fe2O3加入方式。

Some alkyd or oil modified paints can be used but this may reduce the adhesion between coating.

某些醇酸漆和油改性树脂漆也允许使用，但会降低层间附着力。

But it is incompatible with oil base, alkyd, polyester coating systems.

但不能与油性、醇酸、聚酯类油漆配套使用。

Based on the Jones matrix method and the reflect characteristic of coating film on mirror, the physical model of polarizing beam splitting in altazimuth Coudé telescope is built.

基于镜面膜层复振幅反射特性，采用琼斯矩阵描述方法，建立了偏振分光物理模型，研究了共孔径发射和接收偏振耦合分光的效率问题，并与实验结果进行了比较。

New type of strontium aluminate shone coating has excellent light stability, which can be used outdoors.

新型的铝酸锶类发光涂料其耐光性优良，可用于室外。

Liquid diffusion technology was used to aluminize on the surface of AZ31 magnesium alloy.The hypereutectic aluminized coating was obtained.

采用液相扩渗技术在挤压态AZ31镁合金表面快速渗入铝，在合金表面获得过共晶渗层，并对渗层的成分、相组成、扩渗过程、纳米硬度和腐蚀性能进行分析。

The results are listed as following :㏕he best anti-erosion proportion of resin present is 25wt% in the condition of silicon carbide reinforced SMCC, while the alumina reinforced SMCC is 40wt%.(2) The better anti-erosion results was achieved with the ratio of silicone resin to acrylic resin containing hydroxy being 3: 1.㏕he composites coating tends to be more brittle when added in alundum particles. It also means that the maximum erosion peak of alundum reinforced SMCC tends to normal angle.甌he change of erosion rate of SMCC can be divided into two stages with the increment erodent velocity: the slow erosion stage of the beginning and the stable erosion stage.

首次发现：①SiC增强的复合涂料涂层，树脂含量为25wt％时，具有最佳耐冲蚀性能：Al_2O_3增强的复合涂料涂层，树脂含量为40wt％时，具有最佳耐冲蚀性能；②SiC增强的涂料，有机硅树脂与丙烯酸树脂的比例为3：1时的耐冲蚀性能好于1：1的复合涂料涂层；③Al_2O_3增强体使涂层变脆的倾向大于以SiC为增强体的涂层，即SiC增强的复合涂料涂层的最大冲蚀率出现在30°，Al_2O_3增强的复合涂料涂层的最大冲蚀率出现在75°～90°之间；④低速冲蚀磨损机理主要是弹性变形与疲劳；高速冲蚀磨损机理主要是显微切削和显微犁耕。

In the chapter 2, the theoretic knowledge about the photosensitive resin and the grinding tools was firstly introduced.

第二章阐述了光固化树脂结合剂磨具的相关理论研究。

Do not use the program's indenting or margin-setting features; these will be added during typesetting.

不要使用缩排，页面边缘设置之类的选项，偶看不大懂。