查询词典 coating

3 Primer shall be done in the way of brush coating or roller coating by one or two coatings, the time interval shall be 8 hours above; add one priming lacquer on the former base layer.

6.3用刷涂或滚涂方式涂底漆1至2道，每道间隔时间为8小时以上；在旧基层上需再增1道底漆。

If there is old film which is epoxy、coal epoxy、polyurethane coating on the surface, hacking off and cleaning the surface, then brush the coating directly.

B、未失效的韧性旧漆膜，手工难以除掉，若确认是环氧、大漆、聚氨酯等类型，可经过打毛并除去油污后直接涂刷本产品。

If there is old film which is epoxy、coal epoxy、polyurethane coating on the surface, hacking off and cleaning the surface, then brush the coating directly.

B、未失效的旧漆膜，手工难以除掉，若确认是环氧、大漆、聚氨酯等类型，可经过打毛并除去污物后直接涂刷本产品。

If there is old film which is epoxy、coal epoxy、polyurenthane coating on the surface, cleaning the surface and brush the coating directly.

失效之韧性旧漆膜，若确认为环氧、环氧沥青、大漆、聚氨酯等类型，可经打毛并用溶剂除去油污后直接使用本产品。

Traditional Ni coating and brush electroplated composite coating of nano-diamond/Ni are prepared respectively on 45(superscript #) steel matrix. A comparative study of the structure and performance of the two brush electroplated composite coatings is carried out by metallographic microscope, scanning electron microscope, energy dispersive spectrometry and X-ray diffraction.

以45钢为基体，制备了普通镍镀层和nano-diamond/Ni复合刷镀层，采用扫描电镜、能谱仪、X射线衍射仪和金相显微镜等设备对比研究了两种镀层的组织形貌。

If there is old film which is epoxy、coal epoxy、polyurethane coating on the surface, hacking off and cleaning the surface, then brush the coating directly.

B、表面处理时难以除掉的未失效韧性旧漆膜，若确认是环氧、大漆、聚氨酯等类型，可经过打毛并除去油污后直接涂刷本产品。

Metallographic microscope and SEM results show that the surface and structure of nano-diamond/Ni brush electroplated composite coating are more smooth and compact than that of Ni coating. And on the surface of brush electroplated composite coatings, which appear to be the typical cluster crystals in a cauliflower shape, nano-diamonds are wrapped by nickel crystal grains.

金相显微镜和扫描电镜分析结果表明，与普通镍镀层相比，nano-diamond/Ni复合刷镀层的表面更加平整、致密，组织更加细化：nano-diamond/Ni复合刷镀层表面呈典型的&菜花头&形状，弥散分布的纳米金刚石被镍包裹。

The mass and energy change speed of the TiB2 coating paste for aluminum electrolysis during its solidification and carbonization process was studied by the DTG and DDTA, and a reasonable heating program of solidification and carbonization was established. On this basis, the effect of heating program on the properties of TiB2 cathode coating was investigated.

摘 要：采用DTG， DDTA等热分析手段，研究了高温固化、炭化过程中，铝电解用TiB2阴极涂层糊料的质量和能量的变化速率，制定了涂层的变速固化、炭化升温制度；在此基础上，研究了升温制度对TiB2阴极涂层性能的影响。

I plant of the chromium oxide, alumina ceramic coating and has a tungsten carbide metal-resistant coating wear, corrosion resistance, high temperature, and other fine performance.

我厂所制备的氧化铬、氧化铝陶瓷涂层和碳化钨金属涂层有着耐磨损、耐腐蚀、耐高温等优良性能。

Chromium oxide ceramic coating has proven to be laser engraving the best roller surface material and the roller surface coating technology is plasma spraying.

氧化铬陶瓷涂布已被证明是激光雕刻网纹辊的最佳表面材料，而网纹辊表面陶瓷涂布的新技术就是等离子喷涂。

In the chapter 2, the theoretic knowledge about the photosensitive resin and the grinding tools was firstly introduced.

第二章阐述了光固化树脂结合剂磨具的相关理论研究。

Do not use the program's indenting or margin-setting features; these will be added during typesetting.

不要使用缩排，页面边缘设置之类的选项，偶看不大懂。