查询词典 cathode ray tubes

The key difference between hot cathode glow discharge and conventional cold cathode glow discharge is that the cathode is in a hot state with the temperature about 700～1600℃ in a hot cathode glow discharge.

热阴极直流辉光放电区别于常规冷阴极辉光放电的关键之处在于，在辉光放电过程中，阴极处于700-1600℃的&热&状态，并且放电电流大，工作气压高。

Its main products include: medical X ray tubes, image intensifier tubes and rotating anode X ray tubes etc., which are all in conformity with the national standards and registered with the "Yuan Xing" trade mark.

主要产品有：医用X射线管、影像增强管、下球管等，均执行国家技术标准，以&元星牌&为注册商标。

X-ray radiography, X-ray radioscopy and X-ray computed tomography were performed to the C preforms and C/SiC composites made by chemical vapor infiltration method. Elementary research of the simulation of X-ray nondestructive testing of C preforms and C/SiC composites was conducted. The main contents and conclusions are summarized as follows:(1) The equivalent absorption coefficients of graphite and SiC to Al (KAl/sic, KAI/C) were measured. It was found that in 35-45KV, KAl/sic=1.1~1.2 and KAl/c=0.08~0.12. That means X-ray radiography was much less sensitive to fiber defects than to SiC matrix. It was suggested that Al Image Quality Indicator would be used to evaluate the quality of X-ray radiographs of C/SiC.

本文选择X射线照相、X射线实时成像和X射线CT等三种方法对C纤维预制体及C／SiC复合材料进行了检测和研究，并对C／SiC复合材料X射线检测的计算机模拟做了初步的探索，主要研究内容和结果如下：(1)测定了C和SiC的X射线照相等效系数，在35～45KV的条件下，Al对SiC的等效系数K_为1.1～1.2，Al对C的等效系数K_为0.08～0.12，所以X照相射线检测C／SiC对C纤维缺陷不敏感，而对SiC基体缺陷敏感。

X-ray ,which is excited from the X ray tube, has one wavelength scope, that is energy scope. According to the elements to be analyzed, X ray is choused by filter, and reach the sample. Atoms in the sample will absorb the X ray energy and the decay to emit the special x ray. The X ray will be collected by the collimator into the detector active area, and transferred into electron signal, the signal also will be processed in to energy spectrum and related concentration data by pulse processor with software.

从X光管通过激发Excitation发射出来一定波长范围也就是说一定能量范围的X射线，结合所需要分析的目标元素，使用滤光轮选择对应的能量范围的X射线，照射到样品上，样品中含有的元素原子电子受到激发会发射出其特征的X射线，同样通过Collimator准直器收集一定孔径的X射线进入到检测器Detector，检测器将感应到的X射线转换为电信号，电信号经过脉冲处理器Pulse Processor结合软件进一步将电信号转换成为能谱图以及相关浓度信息。

Including clinical breast X-ray machine technology applications, digital breast X-ray machine performance testing and evaluation methods and projects, digital breast X-ray machine and traditional breast X-ray machine of distinction contrast, Finland Planmed high frequency of breast X-ray photography Clinical application, the new mammography X-ray machines and mammography in the diagnosis of the research topic.

包括乳腺X线机临床技术应用，数字乳腺X线机的性能测试方法及项目与评价，数字乳腺X线机与传统乳腺X线机的临床区别对比，芬兰Planmed型高频乳腺机X线摄影技术临床应用，新型钼靶X线机在乳腺摄影及诊断中的应用等研究课题。

The mechanical property testing shows that the seamless PLLA tubes perform excellent radial strength,which indicates that the mechanical properties of biodegradable stents made of these tubes was supposed to be excellent.PLLA and its composites were first used in preparing seamless tubes as antecedency of laser-cut biodegradable coronary stents in china.Finite element analyses of the biodegradable coronary stent model indicate the explorative design basically meets the requirement of reasonable and applicable stents.There is not such kind of research yet in domestic.Optimum laser-cuttting parameters of CO2 laser was cauculated based on experiential formula,within it,biodegradable coronary stents,especially those with complex structure would be manufacutured from seamless tubes quickly by laser microprocessing with high consistency to the design model.The processing efficiency of the CO2 laser demonstrated in experiential formula by us will play an important guiding role in manufacturing biodegradable stents by laser-processing.Our stents that ascribed to laser-cutted,slotted tube stent are proved to be biodegradable, self-expandable and good biocompatible,basically reach the international level on the aspest of manufacturing procedures and design.

研究结果表明：壳聚糖改性材料综合性能优于纯PLLA，更适合于作为可降解冠脉支架的原材料；自主设计的探索性自膨胀管状闭环型可降解冠脉支架的性能符合冠脉设计要求，设计、验证生物可降解冠脉支架模型的研究在国内还未见报道；制备的改性PLLA无缝管的力学性能优越，可通过激光切割获得冠脉支架，这是国内首次采用聚乳酸材料来制备通过激光加工出可降解冠脉支架的无缝管；二氧化碳激光器加工精度能达到加工要求，加工出来的血管支架名义设计与实测值误差小，实现了冠脉支架、尤其是带有复杂外观设计冠脉支架的快速化、规范化加工，对二氧化碳激光器加工聚乳酸材料的效果研究在国内外属于首创，获得的经验公式对日后的深入研究有重要的指导意义；制备的支架为激光切割管状闭环型冠脉支架，支架外观设计、支架加工手段、支架的性能都基本接近国际水平，支架样品符合设计的理念，可以实现自膨胀功能。

Moreover, since the strain energy of zigzag tubes is larger than that of the armchair tubes with the same semidiameter, the ends of the armchair tubes are easier to be closed than those of the zigzag ones. And the closed structures of the zigzag tubes have a lot of defects, even at 3000 K, there will be few carbon atoms flying away from them.

此外，由于锯齿型碳管应力能比同口径扶手型碳管的应力能大，使得扶手型碳管比锯齿型碳管更容易形成端口封闭的结构，且锯齿型碳管端口的封闭结构出现相对较多的缺陷，甚至在3000K下会有少最碳原子从端口飞离碳管。

The 2, 4 mg tubes and the control tubes were not precipitated except for the 8 mg tube with 10000 r/min configuration. The 3 transparent tubes were desalted with column of Sephadex G-25 Superfine HiTrap respectively. All of the eluents of the 3 tubes were half-diluted consecutively with phosphate buffer saline respectively to change totally into 36 samples of 2 mg group, 4 mg group and control group, with 12 in each group.

取2、4 mg管及未加DNFB的HBIG水溶液对照管，各取半量对半稀释，以HiTrap分子筛柱脱盐， 3个洗脱液再分别作对半系列稀释11次， 3组共组成36个标本。

Water inside vacuum heat- collection tubes; since the hot medium inside vacuum tubes floats up and cold one goes down due to respective specific gravity, hot and cold mediums convections up and down to cause the heat conduction, furthermore transfer the heat to the related working medium in the heat tubes, the working medium sorbs the potential heat and becomes steam to rise up to the condensing section from the tube heat evaporating section; it emits the heat in condensing section to change again into liquid working medium; it flows back to evaporating section under the gravity action, the emitted heat is transferred into the water inside water tank or tube group by means of the heat-conduction through heat tubes condensing section; it makes the cold water in water tank into hot water in the repeated way.

阳光透过全玻璃真空集热管的外玻璃，照射到涂覆在内玻璃管外表面的选择性吸收涂层上，涂层将太阳的辐射能吸收并转化为热能，通过内玻璃管壁导热，传递给真空集热管内其液态传热介质，由于真空集热管内热的介质因比重小而上浮，冷的介质因比重大而下沉，冷热介质上下对流传热和导热，再通过热管的金属壁导热，将热量传递给热管内其相变工质，工质吸收汽化潜热而变成蒸汽，由热管蒸发段上升到冷凝段，在冷凝段放热冷凝，又变成液态工质，在重力作用下流回蒸发段，所放出的热量通过热管冷凝段金属管壁导热，传递给水箱或联集管内的冷水，周而复始，于是便将水箱内的冷水全部加热成热水。

The products have General efficient tubes, three-high tubes, three-cavity tubes and other series, specifications like ф47,ф58,ф70 and so on, and from 1.2m to 2.1m in length about 100 species. Its nnual output can reach 7 million vacuum tubes.

产品有普通高效管、三高管、三腔管等多系列，ф47、ф58、ф70多种规格，长度从1.2米-2.1米近百个品种，年产达700万支真空管。

This is the inheritance of the tribe of the children of Issachar according to their families, the cities and their villages.

19：23 这些城并属城的村庄就是以萨迦支派按着宗族所得的地业。

I've have enough of your garbage.

我听了你的废话。