查询词典 cathode current

An extremely high temperature of anode humidification is also unreasonable; as a result, when the current density is high, the liquid water should be injected directly into anode gas channel to guarantee both high inlet H〓 concentration and well-humidified membrane. 4. The utilization of Pt in the cathode catalyst layer will decrease with the increasing current density; as a result, based on the principle of maximal Pt utilization, the catalyst layer can be designed much thinner or not uniformly in the catalyst distribution.

而在此截面上，交指型流场燃料电池阳极侧的液态水饱和度的极值位置并不确定；在电池阴极处，液态水饱和度的极值总是出现在z=0.002m处的气体扩散层和膜的界面上，并且该处的液态水饱和度沿x方向存在一个最大值，与此相应的氧气的质量浓度分数在该处达到极小值，因此极限电流密度将首相出现该处，但总体来说液态水饱和度沿x方向的分布较为均匀。4。

That is less copper anion in the environment. PASP has the effect of corrosion inhibition in hydrochloric acid solution. In addition the potation of cathode summit current turned negative as increasing PASP concentration, and the potential of anode summit current turned positive, it can constrain the corrosion of copper. That is to say PASP is a mixed corrosion inhibitor and can constrain the corrosion of copper surface.

循环伏安测试结果表明： PASP的加入同时抑制了铜表面的阴阳极反应，使阴极峰和阳极峰电流都减弱，说明此环境中的铜离子的含量较少，PASP对铜在盐酸中有缓蚀作用；另外阴极峰电位随着PASP添加浓度的增大而依次变负，而阳极峰电位依次变正，抑制了铜的腐蚀，说明PASP是混合型缓蚀剂，有效地阻止了铜表面的腐蚀。

The third winding is coupled between the primary winding and a capacitor to produce a current that controls a variation of a ratio between the focus voltage and the anode voltage as a function of variation in a beam current in the cathode ray tube.

在初级绕组和电容器之间连接第三绕组，从而产生一个电流，该电流用于对作为阴极射线管中电子束电流的变化的函数的聚焦电压与阳极电压之间的比率的变化进行控制。

This protection machine series product make use of to respond to quickly not the line presses the component , assurance the direct current system is positive, the anode, cathode and as and anodes and the potential difference of the as settle, allowing appear temporary in the direct current system conduct electricity press limit the weak electricity equipments inside the scope, thus insuring the equipments safety movement.

本保护器系列产品利用快速响应的非线性压敏元件，保证直流系统正、负极间，正极与地间及负极与地间的电位差恒定，将直流系统中出现的暂态过电压限制到弱电设备的允许范围内，从而确保设备安全运行。

The results show that when the cathode humidified temperature increase, the humidification of membrane and fuel cell performance improved at lower current density, while the saturation in diffusion layer increase and the performance decreases at higher current density. Humidification of membrane and fuel cell performance improved when the anode humidified temperature increase, the saturation in diffusion layer decrease and fuel cell performance improved when the fuel cell working temperature increase, the resistance of diffusion layer decrease and the performance improved when the porosity largen. At last, the simulation results are compared with the experimental results and they are basically the same.

结果表明随阴极加湿温度的提高，在低电流密度运行时膜的润湿条件改善，燃料电池性能提高，在高电流密度运行时扩散层中液态饱和度增加，燃料电池性能下降；随阳极加湿温度的提高，膜的润湿条件改善，燃料电池性能提高；随燃料电池运行温度的提高，扩散层中液态饱和度下降，燃料电池性能提高；随气体扩散层孔隙率增加，气体扩散层阻力减小，燃料电池性能提高。

The properties of the plating bath and the coating quality are investigated based on hull-trough test and electrochemical tests.The results show that the stability of electrolytic solution is increased,with addition of(NH_4)_3C_6H_5O_7 and the current efficiency ranges of the cathode are extended greatly to 0.11～1.54A/dm~2.Further,the current efficiency...

结果表明：柠檬酸铵的加入可提高镀液稳定性，增大阴极极化作用，可使阴极电流密度范围扩宽到0.11~1.54A/dm2，阴极电流效率高达95.6%，所得镀层细致、均匀、结合力好，为取代氰化镀铜提供了新思路。

In addition, the effects of current, cathode cone angle and arc length on the current density and arc pressure distribution at anode surface in GTA welding are analyzed by the use of the built arc model, and the computed results agree well with the experimental results.

另外，运用建立的电弧数学模型，分析了焊接规范参数变化对直流GTAW电弧阳极表面电流密度和电弧压力径向分布规律的影响，计算结果与实验结论基本一致。

It is of great significance for main economic technical indexes to improve current efficiency, unit power consumption and reducing unit output ect to choose density of cathode current in designing electrolysis tank.

在电解槽型的设计过程中，如何合理选择阴极电流密度，对提高熔盐电解的电流效率、单位时间产量，降低单位电耗等主要技术经济指标具有十分重要的现实意义。

The polarization curve is not sufficient for a reliable and unique validation of a PEMFC model since different parameters can lead to an identical polarization curve. A three-step validation approach is proposed for a complete and unique validation. These three steps are:(1) validated by the global polarization curve,(2) validated by the local current density distribution curve, and (3) validated by the cathode over-potential and anode over-potential versus current density curve. The results from the comparison of four flow-fields show that the PEMFC performance of the flow-fields decreases in order by interdigitated, metal foam, pin-type and parallel.

通过PEMFC参数敏感性研究发现，PEMFC性能受多种参数的影响，这些参数可分为非敏感性参数、敏感性参数和高敏感性参数；与阳极侧参数相比，PEMFC性能对阴极侧的参数更敏感；不同参数值的组合可以得到几乎完全相同的极化曲线，因此电池的极化曲线不足以用于验证数学模型的唯一性与可靠性；为验证PEMFC数学模型的唯一性与可靠性，提出了模型验证的三步法：极化曲线验证、局部电流密度验证和阳极总过电位与阴极总过电位验证。

Some Micro-hollow Cathode Sustained glow discharge experiments also have been done. The results show the linear development of the MCS glow discharge current with increasing MHCD current at high-pressure.

MHCD作大体积辉光放电的电子源存在着一个自持电流阈值，当MHCD电流大于这一阈值时，放电电流随着MHCD电流增加而线性地增长。

We were cousins—his grandfather was King of Scots,and his great-grandfather was Henry VII of England.

我们是堂姐弟——他的祖父曾是苏格兰国王，他的曾祖父是英格兰的亨利二世。

I do want to help you, but I am in a quandary now!

我是想帮你，但是我现在左右为难啊！