查询词典 cable draft

"The inboard end of a chain, rope, or cable, especially the end of a rope or cable that is wound around a bitt."

索链、绳子或缆绳在船内的终端，尤指绕在系缆柱上的绳子或缆绳的尾端。

The suitable Network Cupboard , Cable Brach Box in Distributed Electric Cable Network

环网柜，电缆分支箱在配电电缆网络中的合理利用

During the process of branching optical cable, the duct is opened for a piece of 10cm first, then cut the guided tube for branching, and connect the guided tube with new one, finally install Y-connector, through which the micro cable can be installed by air-blowing in.

在进行光缆分歧时，首先用切管刀将母管切开一段约10cm的口子，然后剪断要进行分歧的那根子管，并用连接头将剪断的子管和支线的子管连接，最后安装Y型连接器。完成上述工作后，即可向子管中吹入光缆。

To check the continuity of a cable pair by putting an audible buzzer on one end and then checking with a "buttinsky" to see if you can hear the buzz and thus identify the correct cable pair.

要检查电缆是否接通，将一个听得到声音的蜂鸣器放在电缆一端，然后使用"buttinsky"检查，看是否能听到蜂鸣声，以此来判断电缆是否接通。

Development, production and sale of cable and cable systems by operating companies worldwide

这是我们为什么能够不断地研发，生产和设计新的产品以达到客户严格的使用水平。

5 For cargo lots over 1,000 M/T each, or any other lots less than 1,000 metric tons but identified by the Buyer, the Seller shall, at least 10 days prior to the date of shipment, inform the Buyer by telex or cable of the following information: the contract number, the name of commodity, quantity, the name of the carrying vessel, the age, nationality, and particulars of the carrying vessel, the expected date of loading, the expected time of arrival at the port of destination, the name, telex and cable address of the carrier.

15.5、一次装运数量超过1，000吨的货载或其它少于1，000吨但买方指明的货载，卖方应在装船日前至少10天用电传或电报通知买方合同号、商品名称、数量、船名、船龄、船籍、船只主要规范、预计装货日、预计到达目的港时间、船公司名称、电传和电报挂号。

If in the process of cabling, repeatedly bend the cable so if the copper wires inside the cable may be broken.

要是在布线的过程中，反复弯曲这样的网线的话，网线里面的铜线缆可能就会被折断。

Taking into account the net line in the wiring often need to bend, so many manufacturers in the production of regular cable had been left a certain amount of skin stretching, and to ensure that when the cable from damage in the bend.

考虑到网线在布线时经常需要弯曲，因此许多正规厂商在制作网线都给外皮留有了一定的伸展性，以保证网线在弯曲时不受损伤。

The stator inner diameter of Powerformer is calculated according to the bend radius of cable and the slot shape is determined by the outer diameter of cable, a rated voltage 35kV and rated power 2550kW Powerformer is designed on the basis of this design method.

即根据电缆的弯曲半径计算电机的定子内径，由电缆的外径确定电机的定子槽形，在此基础之上设计了一台容量2550kW，额定电压35kV 的Powerformer。

Cable bend radius implements corresponding non-cornbustion.retardant cable standard stipulation.

电缆弯曲半径，执行相应非阻燃电缆标准的规定。

Chimborazo and Cotopaxi, took me by the hand.

越过琴博腊索山和科托帕克西山。

This car is in a good condition.

这辆车的状况很好。