查询词典 buffer circuit

Working Principle Transmitter is composed of sensor and electronic element circuit, pressure of measured medium directly applies on sensor s ceramic diaphragm, force diaphragm to displace tinily in proportion to pressure of medium, under normal working condition, diaphragm displace no more than 0.025mm, electronic circuit detects this displacement, and convert it into standard industrial measuring signal i.e.

工作原理变送器由传感器与电子元件线路组成，被测介质的压力直接作用于传感器的陶瓷膜片上，使膜片产生与介质压力成正比的微小位移，正常工作状态下，膜片最大位移不大于0.025mm，电子线路检测这一位移量后，即把这一位移量转换成对应于这一压力的标准工业测量信号（4~20）mA。超压时膜片直接贴到坚固的陶瓷基体上，由于膜片与基体的间隙只有0.1mm，过载时膜片的最大位移只能是0.1mm，所以从结构上保证了膜片不会产生过大变形。

Including the low-pass filter circuit and Operation Transconductance Amplifier circuit design.

包括低通滤波电路，跨导运算放大电路电路的设计。

This paper introduces the difficult assistant teaching software of circuit and its application in the transient state analysis of second-order linear dynamic circuit.

介绍了电路疑难辅助教学软件，并对其在二阶线性动态电路暂态分析中的应用进行了阐述。

This subject has mainlyexplained that chooses integrated circuit as the key device, hasdesigned a simple and easy digital cymometer, regard trigger andcounter as core , input , separate by signal frank , touch off ,count circuit , data processing , data reveal module of functionmake up.

本课题主要选择以集成芯片作为核心器件，设计了一个简易数字频率计，以触发器和计数器为核心，由信号输入、隔直，触发、计数、数据处理和数据显示等功能模块组成。

It is the equivalent circuit of a triode amplifier circuit .

它是三极管放大器的等效电路。

Circuit breakers or fuses are installed and coordinated with wiring by selecting the appropriate trip value so that if equipment malfunction or user error causes too much current to flow through a wire, the circuit breaker will trip to prevent the wire from overheating.

断路器或保险丝安装后可以协助线路选择适当的跳闸值。这样，当设备故障或用户失误导致流过线路的电流太大时，断路器将跳闸以防止线路过热。

Adopting discrete time-domain method to set up the mathematical model of high-voltage conversion circuit, and analyzing the influence of frequency, duty cycle, primary inductance, different turns ratio parameters how to affect high-voltage convertion circuit charging time.

采用离散时域方法建立高压转换电路数学模型，分析了高压转换电路频率、占空比、原边电感量以及匝比等设计参数对高压转换电路充电时间的影响，并进行了仿真和实验验证。

Based on the iso/iec 18000-6c standard, the analog circuit of the ultra high frequency passive transponder ic is designed, according to the design requirements of analog circuit.

基于iso/iec 18000-6c标准，以设计出符合标准的标签芯片为设计目标，超高频无源电子标签芯片模拟电路被提出。

However , to realize t he same system f unction , different circuit designer may adopt different method , there is a problem of complexity in circuit s.

但是，实现同样的系统功能，不同的电路设计师可以采用不同的实际方法，这样就存在一个电路复杂程度的问题。

5 A primary circuit switch shall be connected to an ungrounded circuit conductor ."

" 8.5 初级电路的开关应连接非接地导体上。"

Tom: You are right, he worked hard all the time.

你是对的。他一直都是努力工作。

Take shortcomings,failures,and mockings of others as commonplace and a drive to complete oneself,hold your own opinion over the evalution and disscution divested from others,afterwards sink into the state of eliminate mistakes if any or encourge oneself being not being influenced by the sayinngs of others or having no ideas to do.

把缺点、失败及别人的耻笑等看成是一种常事，当成完善自己的动力，对别人的评价和议论自己心中有主见，做到&有则改之，无则加勉&，不为人言所左右或无所适从。