查询词典 buffer circuit

Sample and Hold Circuit The sample and hold circuit is used to take a narrow-band measurement of a time-changing signal and to hold that measured value until reset.

采样保持电路采样保持电路，是用一个窄波段测量时间变化的信号，并认为测值，直至复位。

In the system, a finepositioning window signal generating circuit redundant, sample and hold circuit of positioning error signal using no traditional charge/discharge method but high-speed switches and operational amplifier integrators, and cross-zero detector with threshold for higher reliability, is originated by the author in this paper.

综合面伺服和扇区伺服的各自优点，设计完成了4000 TPI光刻伺服解调系统：在设计中，首创了带冗余的精定位窗口信号生成电路，采用高速模拟开关和运放积分电路代替传统的电容充放电法，以完成精定位位置误差信号的平均与采样保持，使用带阈值的过零检测电路提高过道脉冲的可靠性。

To reduce the area of the layout,we use one-stage OP-AMP in the ROIC,and the sample and hold circuit shared by pixels in a column is also applied instead of sample and hold circuit in every pixel.

本设计采用电容反馈互阻抗放大器结构作为输入级，列共用方式的采样保持电路，源级跟随器作为输出级，用移位寄存器来控制行、列选通并控制电路工作的时序。

In formal we adopt 1.5-bit/per stage technology and a 2-bit flash ADC in the last stage. We adopt switch-capacitor circuit to design the sample and hold circuit and the multiplying DAC.

本次设计为九阶段的管线式类比数位转换器，前八个阶段采用1.5-bit/per stage的技术，最后一个阶段则为一个2-bit的快闪式类比数位转换器。

Considering the speed , power dissipation and specifications, A flip-around sample and hold circuit was designed to reduce the power consumption; S/H circuit is followed by eight 1.5-bit stages and a final 2-bit flash sub-ADC.

该流水线式ADC的采样保持电路采用Flip-around结构以减少功耗；前8级每级1.5位，最后一级为2位的并行flash ADC，并采用数字校正技术对级电路的误差进行校正，最终以达到10位的精度；为了达到系统低功耗的要求，该流水线ADC采用了运放共享技术和逐级缩小技术。

The ADC is pipelined, including a single-input/difference-output sample/hold circuit and nine stage subcircuits. The preceding eight stages are 1.5bits/stage, and the last stage consists of two comparators. Every input sample is converted into 18 bits binary signals, and these binary signals are converted into 10 bits binary signals through digital correction circuit.

模数转换电路采用流水线式的结构，包括具有单端输入/差动输出功能的采样保持电路和九级的子电路，前八级子电路使用1.5位/级的结构，最后一级使用两个比较器实现，每个输入值被转换为18位的二进制代码，通过数字纠正技术最终实现10位的输出，按照前端电路的应用要求，这个模数转换器实现1.33MHz的采样速率。

Circuit noise within the system: such as CRT deflection circuit power to the secondary emission of noise _ mother _ Sina fashion blog, fashion, mom, wedding photography network to provide in accordance with the relationship between noise and signal, image noise can be divided into additive and multiplicative noise two types of noise ...

系统内部电路噪声：如CRT的偏转电路二次发射电予的噪_时尚妈妈_新浪博客，时尚妈妈，婚纱摄影网提供按照噪声和信号之间的关系，图像噪声可分为加性噪声和乘性噪声两大类。。。

Aimed at the use of underwater active detection system, an analog pretreatment circuit is designed. More than one amplifier and two filters are used to process the signal. The signal can be amplified and self-excitation is avoided. The series of AD867X are used to restrain the circuit noise.

针对水下主动探测系统的应用，设计了一种模拟预处理机，该电路采用分级放大结构，并使用两级滤波器对信号进行滤波处理，在达到对信号放大倍数要求的同时避免了放大器自激，采用噪声性能好的AD867X系列芯片有效抑制了电路噪声对信号的影响。

In this thesis, the self-excited oscillation in HVDC circuit breaker is investigated. And the main problems in the development of HVDC circuit breaker have been summarized.

本文对高压直流断路器的自激振荡问题进行了深入的研究，并分析和介绍了高压直流断路器的发展现状及研制中所面临的主要问题。

Based on method of moment and field-circuit coupling theory, nodal method of analysis in circuit theory is applied to the power parameters calculation of grounding grids. The inner self-resistance and self-inductance of conductors, mutual inductance between conductors, and displacement current of conductors are taken into account.

基于矩量法和场路结合的思想，将电路中的节点电压法用于接地网工频参数计算中，该方法不仅考虑了接地导体的内自阻抗和自感，而且考虑了导体间的互感，导体的位移电流。

Tom: You are right, he worked hard all the time.

你是对的。他一直都是努力工作。

Take shortcomings,failures,and mockings of others as commonplace and a drive to complete oneself,hold your own opinion over the evalution and disscution divested from others,afterwards sink into the state of eliminate mistakes if any or encourge oneself being not being influenced by the sayinngs of others or having no ideas to do.

把缺点、失败及别人的耻笑等看成是一种常事，当成完善自己的动力，对别人的评价和议论自己心中有主见，做到&有则改之，无则加勉&，不为人言所左右或无所适从。