查询词典 bounding table

A surface or line bounding a thing 边;侧;面: Which ～ of the mountain did you climb up ?

你从山的哪一边爬上去的？

Bounding surface separation has been selected as the most suitable method for middlings processing, by means of study on crystal structure, physical properties, chemical properties, existing state and disintegration degree of the middlings constituents.

通过对中煤各组成成分的晶体结构、物理性质、化学性质、赋存状态、解离程度等性质的研究，确定了界面分选为适合于中煤洗选深加工的主要方法。

The bounding surface may be whether a wall, a fence, or an abstract line or plane. Orientational metaphors of idioms give concepts of an idiom spatial orientation.

习语的方位隐喻特征指的是，人们在习语中参照上下、内外、前后、深浅、中心一边缘等概念建构的隐喻。

It was found that with the increase in the oscillating frequency for a fixed oscillating angle, the film thickness increases, which may contribute to the formation of the oil film; however, the maximum pressure and the pressure scope during an oscillation cycle also increase; which may shorten the fatigue life of the bounding surface in the latter situation.

结果表明：在摆程不变的条件下，膜厚随摆动频率增加而增大，有利于润滑膜的建立，但同时会增加1个周期中的最大压力及压力波动幅度，使工件易于疲劳；对于相同凸度量，在低频摆动工况下边缘效应较高频工况下的严重，因此在低频摆动工况下使用滚子设计时需要增大其凸度量。

The bounding surface hypoplasticity model for rockfill materials modified by the authors is employed to characterize the material behavior for typical tests under different consolidation stress state, drainage condition and loading pattern.

采用所发展的亚塑性边界面模型，对堆石料在不同固结应力状态、排水条件和加载方式下的典型试验进行了数值模拟分析。

Under the optimized conditions, the relative fluorescence intensity decreased linearly with the copper ions concentration in the range from 2 to 200μg·L~(-1) and the detection limit could reach 0.29μg·L~(-1). Based on the charge-transfer quenching mechanism, the copper ions bounding onto the surface of qdots could absorb electrons from valance band, which results in the quenching of fluorescence.

用电荷转移机制解释了量子点荧光猝灭的原因，主要是由于价带电子激发到导带以后被表面结合的Cu~(2+)离子捕获而产生的结果，在此基础上，用光解实验进行了进一步的验证。

Considering the bounding surface plasticity constitutive model of soil, the program, named as WSDP, is coded to analyse the dynamic elastoplastic responses of two-dimensional soil layer.

讨论土体本构关系、土层应力历史状态、人工边界的设置以及为消除人工边界高频振荡而采用的黏性阻尼等因素对土层动力反应的影响。

Then the particle swarm optimization is introduced to collision detection area. In this dissertation, it also proposes two novel framework which combines the exist techniques of hierarchy bounding volume and surface simplification with the PSO. We have tested the frameworks in our "Haptic Interactive System ". The new frameworks performance well for most models in virtual scene.

本文探索和研究了虚拟环境中广泛使用的碰撞检测算法，尝试把几何模型的碰撞检测问题转化为优化搜索问题，把粒子群优化搜索技术引入碰撞检测领域，并结合碰撞检测领域现有的层次包围盒技术和网格简化技术，组成新颖的限时干涉检测算法框架，即用户可以方便地控制分配给碰撞检测算法的时间，尝试去克服这一技术瓶颈。

The influential soil constitutive models involving principal stress axes rotation, such as Matsuoka's model, kinematic hardening model, bounding surface model and the complete stress incremen...

对当前较有影响的含主应力轴旋转的土体本构模型（基于一般应力空间的土体本构模型、运动硬化模型、边界面模型、土体弹塑性应力应变关系的完全应力增量表述等等）进行了较为系统的评述。

On the base of analysis concerning Tianjing and Tanggo-Xingang soil properties and observation results of settlements, some rules of settlement of buildings in the area were obtained. Final settlements, settlements at end of construction and the time of final settlement were discussed. Tests used for determining paramcters of four models were introduced. The parameters in Duncan-Chang model are determined from isotropic consolidation test and the parameters in Gong-Xiannan model from Ko consolidation tests while the parameters in the model proposedin chapter 2 from the equal increment stress ratio test and ones in the bounding surface model developed in chapter 3 from the effective stress-path of CIU test.

根据天津市区及塘沽新港地区的地基土质情况以及沉降观测资料，分析了该地区建筑物沉降的一些规律，讨论了最终沉降量，完工时的沉降量以及沉降稳定时所需要的时间，介绍了确定各模型参数所需要的试验：Duncan—Zhang模型参数根据等向固结的三轴试验确定；龚晓南Ko固结模型根据Ko固结三轴试验确定；本文建立的非线性弹性模型根据等向增量应力比试验确定，边界面模型参数可根据固结不排水剪切试验的有效应力路径确定。

In the chapter 2, the theoretic knowledge about the photosensitive resin and the grinding tools was firstly introduced.

第二章阐述了光固化树脂结合剂磨具的相关理论研究。

Do not use the program's indenting or margin-setting features; these will be added during typesetting.

不要使用缩排，页面边缘设置之类的选项，偶看不大懂。