查询词典 basic angle

Based on the principle of grating diffraction, by using television measuring system to measure the offset between the imaging of incident laser and the optical axis to confirm the angle of incidence and the angle of diffraction of the grating, a method of measuring incident laser wavelength in far field with grating is brought up.

依据光栅衍射原理，采用电荷耦合器件CCD作为探测器，通过测量入射激光成像点在电视靶面坐标系中的脱靶量，确定光栅的入射角和衍射角，提出了一种利用固定式平面反射光栅测量远场未知方位入射激光波长的方法。

When the angle radius of the diffraction spot's the first dark ring is big, the effect is relatively small. But when the angle radius is small, especially for turbulent effects being weak, the effect on the beam spreading is very distinct, and the magnitude of the beam spreading is mainly dependent on the jitter item of the scaling relations.

由此定标关系可知，当系统衍射角σ0较大时，跟踪抖动对光束扩展的影响比较小；但是当系统衍射角σ0较小时，特别是在湍流效应较弱的情况下，抖动的影响非常显著，此时光束扩展主要是由系统抖动项所决定的。

The relationship between acoustic wave direction,laser incident angle,and laser diffraction angle of TeO2 acousto-optical deflector with acoustic frequency was analyzed based on the TeO2 crystal acousto-optical characteristic and Dixon equations under abnormal Bragg diffraction.

根据晶体的声光特性以及反常布喇格衍射的Dixon方程，得出了氧化碲声光偏转器在反常布拉格衍射条件下的参量矢量关系。分析了超声波方向、入射光角度、衍射光角度与声波频率之间的关系。

X-ray diffraction is one of the most common and efficient ways to measure a superlattice structure. This dissertation displays the detail results for characterization of Ge〓Si〓/Si superlattices by x-ray diffraction (including x-ray small angle diffraction and double crystal diffraction). It was found, when the growth temperature is lower, the intensities of xray small angle diffraction peaks are modulated by a periodical function, which indicates that both sets of interfaces of the superlattice is highly flat; when the growth temperature is higher, the diffraction peak intensities are simply decay with the increase of diffraction vector, which indicates that one set of interfaces is highly flat but another is not; when the growth temperature is very high, the diffraction peaks are reduced more rapidly, which indicates that both sets of interfaces are not ideal.

本文详细介绍了用X-射线衍射（包括X-射线小角衍射和双晶衍射）方法对Ge〓Si〓/Si超晶格结构特性测试的结果，尤其是发现，当Ge〓Si〓/Si超晶格的生长温度较低时，X-射线小角衍射谱峰的强度随着衍射波矢的增加而周期性调制，表明超晶格的两套界面都十分平整；当生长温度较高时，Ge〓Si〓Si超晶格的X-射线小角衍射谱峰的强度随着衍射波矢呈简单的衰减变化，对应于超晶格内有一套界面不平整的情况；当生长温度进一步提高时，X-射线小角衍射峰明显减少，表明超晶格内两套界面都不理想。

One limb dips to the north with a dip angle of 46 degrees and the other limb dips to the south with a dip angle of 48 degrees.

其中一个翼倾向北，倾角46度，另一个翼倾向南，倾角48度。

One limb dip s to the north with a dip angle of 46 degrees and the other limb dip s to the south with a dip angle of 48 degrees.

其中一个翼倾向北，倾角46度，另一个翼倾向南，倾角48度。

This paper introduces the developing conditions of big dip angle belt conveyor in our country,generalizing the five kinds of main type and their principal uses of big dip angle belt conveyor.

介绍国内外大倾角带式输送机的研制状况，概述大倾角输送机的5种主要类型及其用途。

Under the influence of angle of joint and load, the distributing of displace field exits non-uniformity, and with the increase of joint dip angle the non-uniformity become stronger.

6受节理和加荷方向的影响，位移场分布存在一定的不均匀性，随着节理倾角变大，不均匀性增强。

The design method is described, and the calculation results are presented under the standard air conditioning condition. The working process of the two-stage expander is discussed, and the difference between the two-stage expander and the conventional one is stated. In addition, the influence of the dip angle on the expansion chamber volume is analyzed. The results show that the dip angle has little effect on the expansion chamber volume and it is suggested that the effect may be neglected in the expander design.

介绍了该膨胀机的设计方法，给出了标准空调工况下的计算结果，详细讨论了两级旋叶式膨胀机的工作过程，并对两级膨胀机与传统旋叶式膨胀机的区别进行了论述，最后分析了滑片倾角对工作腔基元容积的影响，结果显示，滑片倾角对工作腔基元容积的影响很小，在膨胀机的设计过程中忽略滑片倾角的影响是合理可行的。

Research shows that the main factors influencing forging penetration efficiency are reduction in pass and the dip angle of the hammer, and the main factors influencing forged piece surface quality are axle feeding speed and rotation angle.

研究表明：影响锻透性的主要因素为道次压入量和锤头倾角；影响锻件表面质量的主要因素为轴向送进速度和旋转角度。

Many will continue to choose to live in duality and in conflict.

许多人将继续选择活在二元对立性和冲突中。

I find that students of the University of Physical Education all wear sportswear at first sight.

我发现：体育大学的学生乍一看，都是穿运动衣，大家都一样