查询词典 annealing

A large drop in hardness appears in as deformed samples at a temperature 45 ℃ lower than the start temperature of the exothermal peak after isochronal annealing, indicating that the recrystallization and grain growth process is closely relatine to annealing time and temperatur.

出现明显晶粒长大的温度较DSC曲线显示的放热峰起始温度低45℃左右，这主要是由于变形组织的回复再结晶过程是退火温度与时间的函数，降低处理温度并延长处理时间能达到与高温短时处理相同的效果。

The former consists of the spiculate FeAl3 phase which formed by the temperature deduction and the latter is composed of the lingulate FeAl3 and Fe2Al5 phases which embedded the substrate. Diffusion annealing as taken at 850℃, the structure changs apparently with increasing of the diffusion annealing time.

结果表明：浸镀层由表面富铝层及扩散层构成，富铝层包含降温形成的针状FeAl3相，扩散层由FeAl3、Fe2Al5相组成，形状如舌状指向基体。850℃扩散退火，随扩散时间的延长镀层组织结构明显变化。

Miscut SrTiO_3 (001) substrates were pretreated by ex situ annealing inflow oxygen and in situ annealing in vacuum.

采用流动氧气中退火和真空原位退火法对斜切SrTiO_3 (001)基片进行了预处理。

Meanwhile the mutative trend of nitrogen PL intensity is fit to that of isothermal annealing treatment with increasing annealing time, even though the variation is small.

当退火温度为1573K时，随着退火时间的延长，PL结果与等时退火的变化趋势一致，但变化幅度不大。

In this study, we investigate the effect of post-annealing on magnetization damping in sputtering deposited NiFe thin films. The film thickness is ranged from 10 nm to 100 nm. Thin films were deposited at room temperature and a subsequent post-annealing was performed in vacuum better than 10-6 torr from room temperature to 700 0C for 30 minutes.

中文摘要本研究中，我们使用改变后退火效应来观察溅镀制程镍铁薄膜(Ni84Fe16)系列的磁性阻尼行为，溅镀薄膜厚度范围为10 nm ~ 100 nm，而镍铁薄膜后退火过程在真空度约10-7 torr中进行，达到标的温度(范围由室温至700 ℃)后定温30分钟，自然冷却取出。

3Cr2W8V hot work die steel was pretreated by rapid precooling annealing process instead of traditional annealing process.

采用快速预冷退火工艺取代传统退火工艺，对3Cr2W 8V热作模具钢进行了预处理。

It was found that percentage recovery decreases with the increasing of prestrain and increases with the increasing of annealing temperature and there is a higher percentage recovery when up to 600℃ of annealing temperature.

实验表明，合金的形状回复率随预变形量的增加而减小；形状回复率随回复温度的升高而增大，且在600℃左右达到最大值；热-机械训练可以明显提高合金的形状记忆效应。

The new annealing system will be primarily used for recrystallize annealing low-carbon drawn wire.

这一新的退火系统将主要用于再结晶低碳拉拔丝。

Materials and Methods: Under the best annealing condition treatment and making sure the surface characteristics and cooling process after vacuum annealing had no significant effects to thermoluminescent response, TLD samples were put into the ABS TLD holder in the vacuum chamber.

材料与方法：将以最佳回火条件回火完成之CaF2：Dy (TLD-200)及CaF2： Tm (TLD-300)，确保其表面性质及真空回火后冷却过程对热发光反应无影响后，将其置於真空腔内之一压克力置装器内。

Company in early 2007 the focus of research induction annealing tinning machine, power-saving rate and old-fashioned electric wire annealing machine compared to up to 70%.

公司于2007年初重点攻关感应式退火镀锡机，节电率和老式电热丝退火机相比最高达70%。

On closer examination, though, this is not a vote for multilateralism but just the opposite.

仔细审视后我们发现，这并非是对多边主义投出的赞成票，而是恰好相反。

Uncovering their weak spots, so I can defeat them.

揭露出他们的弱点，这样我就可以打败他们了。