英语人>网络例句>annealed 相关的网络例句
annealed相关的网络例句

查询词典 annealed

与 annealed 相关的网络例句 [注:此内容来源于网络,仅供参考]

The films also can be annealed in air or reductive circumstance according to the requirement.

根据性能的要求也可以选择在空气中或者在还原气氛中退火。

I want to think of poems as if made in a shot tower, a tall building where molten lead poured through a sieve drops a long way, with surface tension forming perfect spheres, annealed by the plunge into the cold water tank of reality at the bottom.

我把诗想成好象造于一个制弹塔中,一幢高高的建筑物里熔化的铅水倾滤过筛网滴下一条长长的路径,因表面张力形成完美的圆球,淬入底部的现实的冷水槽中增韧变强。

It has mainly actions as follows: accumulating steel wire; sending steel wire; drawing steel wire; clipping; tighten; squeezing flat; regulating position of strapper, etc; using annealed rod of φ6.5,φ6.0 or hot-finished rod ofφ6.0 directly as strapping steel wire; it straps and tightens for 720°,and then squeezing flat to make sure that it straps firm and not easily loose.

它具有如下主要动作:蓄丝、送丝、抽丝、剪断、拧紧、挤平、打捆机位置调节等;使用φ6.5,φ6.0的退火盘条或直接采用φ6.0的热轧盘条作捆丝;其捆结拧紧720°,然后挤平,保证了捆结牢固,不易松脱。

At this annealed condition, the C atoms were easily incorporated into the substitutional sites and no SiC phase was formed.

傅立叶变换红外光谱和RBS研究结果表明,SPE生长的SiGeC薄膜具有较好的外延质量。

XRD results indicate that the major diffraction peaks of the film match those of Sb2Te3. The film growth is apparently at the [101]/[012] orientation and many Te peaks are observed. Hall measurement reveals that all the samples are p-type and the resistivities are low. The electric conductivity of the films approaches that of the bulk metal and the carrier concentration is of 1023 cm-3. Seebeck coefficient measurement shows that the samples have nice thermoelectrical properties and the seebeck coefficients are in the range of 7.8—62 μV/K. Among all, the samples annealed at 200 ℃ for 6 h have the highest seebeck coefficient of about 62 μV/K and the lowest resistivity.

XRD测量结果显示,薄膜的主要衍射峰与Sb2Te3标准衍射峰相同,在[101]/[012]晶向取向明显,存在较多的Te杂质峰;霍尔系数测试结果表明,薄膜为p型半导体薄膜,薄膜电阻率较低,其电导率接近于金属电导率,载流子浓度量级为1023 cm-3,具有良好的电学性能;Seebeck系数测量结果显示,薄膜具有良好的热电性能,在不同条件下制备的薄膜的Seebeck系数在7.8—62 μV/K范围;在所制备的薄膜中,退火时间为6 h、退火温度为200 ℃的薄膜其Seebeck系数达到最大,约为62 μV/K,且电阻率最小。

Pt-inserted nanotube titanic acid was prepared as follows: H_2PtCl_6 ethanol solution was filled into the titanic acid nanotubes and then annealed in air at 673 K for 3 h.X-ray photoelectron spectroscopy showed that H_2PtCl_6 has been converted to Pt~0 and PtO.The result of electron spin resonance revealed that there are single-electron-trapped oxygen vacancies to be formed in PNTA after heat treatment in air.

通过在真空条件下将氯铂酸的乙醇溶液引入到钛酸纳米管内,再经过热处理制备了镶嵌铂的纳米管钛酸。X射线光电子能谱表明氯铂酸大部分转变成Pt0和PtO,顺磁共振谱表明在PNTA中生成了束缚单电子的氧空位,在紫外-可见扩散漫散射谱谱上表现出对可见光有吸收能力。

For Si0.8Ge0.2 film in a window of 3μm×3μm,its strain is relaxed by only less than 4% after the sample is annealed at 950℃ for 30min,which is much less than the strain relaxation of the Si0.8Ge0.2 film grown on the unpatterned area on the same substrate under the same annealing condition.

在3μm×3μm窗口中共度生长的Si0.8Ge0.2/Si异质结构材料,在950℃高温退火30min后,它的应变弛豫不大于4%。远小于同一衬底上非微区生长材料的应变弛豫。

WIRE GAUZE WITH SQUARE APERTURES MADE FROM ANNEALED ROUND WIRE FOR INDUSTRIAL USE.

筛和筛分。工业用退火圆钢丝制方孔金属筛。

They exhibit a strong luminescence peak at around 630nm and will transform into wurtzite structure when annealed at 500°C.

它们在630nm有较强的发光峰,经过500℃热处理后转变为纤锌矿型结构。

Precursors of sulfates and alkali halides prepared in co-deposition process were mixed homogenously, annealed at high temperature and then formed CoO and NiO fibers, XRD, XPS, Raman and SEM were used to characterized the samples, the growth of these fibers might be a special LS mechanism: soluble precursors in molten salt decomposed gradually to form initial crystal nucleus and succeeding particles adhered to these nucleus and grew anisotropically in the special high temperature fluent medium, the higher decomposition temperature and solubility of the precursor are two key factors in this method, which are in favor of a longer growth process and result in larger sizes of the final metal oxides crystals.

以共沉淀方法生成硫酸盐与碱金属卤化物融盐的均匀混合前驱物,在高温下退火制备出了CoO和NiO的晶须,以XRD和XPS等对成份进行了分析,SEM分析了形貌特征,研究了不同前驱物热分解特性,认为本方法是一种简单的LS生长机制:可溶性前驱物于融盐中热分解后逐渐析出成核,后续的粒子附着在核上,在融盐环境下沿一定方向作准一维生长,其产物形貌之不同源于硫酸盐的高分解温度和在融盐中的可溶性,导致晶体生长过程中成核过程与生长过程竞争的结果对一般前驱物结果的偏移。

第6/16页 首页 < ... 2 3 4 5 6 7 8 9 10 ... > 尾页
推荐网络例句

I smile at your play with that little bit of a broken twig.

我微笑着看你玩那一段小小的树枝。

They may be produced for almost any shaft angle.

他们可能在制作中几乎任何一个轴角。

The effects of several parameters on thestate of the accelerated flyer and the characteristics of shock wave propagation in thetarget were studied in detail, and the physical data and physical profilers wereobtained more generally, which made us understand the whole physical process moreprofoundly.

首先,数值模拟了激光直接驱动铝飞片碰撞铝靶模型,对各种物理参数对飞片飞行状态和靶中冲击波特性的影响程度进行了比较详细的研究,得到了比较全面的物理数据和物理图像,对整个的物理过程有了比较深刻的理解。