查询词典 MIN

The majior contributions are summarized as follows:1. Enhanced the concept of min-max transfer capacity, which is the conservative transfer ability against the optimistic transfer ability that ATC evaluates.2. Constructed a TRM model of bi-level optimization based on leader-follower decision-making model, and an analytic method of computing TRM is proposed. A bi-section search algorithm simplifies and speeds up the calculation.3. Proposed the min-max transfer capability model considering steady voltage stability. The BiGA algorithm used in this model is shown to be robust.

本文针对这些问题，补充、提出了一些方法和见解，具体研究成果如下：1、针对ATC评估的是&乐观&情况下电网输电能力，提出了&保守&情况下的电网输电能力-至少传输容量的概念。2、提出基于主从决策的TRM双层优化模型，给出了TRM计算的解析方法，两次一维搜索的算法减小了TRM求解的难度，提高了计算速度。3、提出考虑静态电压稳定约束的至少传输容量评估模型，针对模型特点提出的BiGA算法具有较强的鲁棒性。

Cotton and silk fabrics were dyed with natural carminic acid after the Iron ion pre-mordant treatment. The K/S values of the fabrics were characterized. The single factor process experiments were carried out for mordant concentration, temperature and time. The optimal process parameters were mordant concentration cotton: 1×10^(-3mol/L and 10 min at 90℃; silk: 1×10^(-3)mol/L and 10 min at 40℃.

将铁离子前媒染处理后的棉、丝织物采用天然染料胭脂虫酸进行染色，以染色织物的K/S值进行表征，对媒染剂浓度、温度、时间3个因素进行了单因素工艺实验，得到了铁离子前媒染棉、丝织物的最佳工艺参数（棉：1×10^(-3)mol/L， 90℃，10分钟；丝：1×10^(-3)mol/L， 40℃，10分钟）。

The cases in control group were given 0.3g aspirin for chawing, 5000u low molecular weight haperins were injected abdominally once for 12 hours total for 10 days one course. in the morning they took 0.1g aspirin and 75mg clopidogrel bisulfate, in the mean while, simvastatin betaloc, captopril and nitrogly cerin were used. while the cases in treatment group were pumped intravenous of 0.4ug/kg.min hydrochloride tirofiban sodium at the first 30 minutes, then as 01ug/kg.min for 24 hours on the basis treatment of the control group.

对照组以阿司匹林0.3 嚼碎顿服，低分子肝素5000u，腹壁皮下注射12h1次，共10d，阿司匹林0.1晨服，波立维75mg晨服，及应用辛伐他汀、倍他乐克、卡托普利、硝酸甘油等治疗；治疗组在此基础上应用盐酸替罗非班氯化钠注射液，前30min以0.4ug/kg/min负荷输入，后以0.1ug/kg/min静脉泵输入维持24h；观察两组疗效。

Results indicate that the optimum extraction conditions are as follows: ultrasonic power is 600W, temperature is 53℃, the ratio of liquid to solid is 8︰1, ultrasonic treating time is 70min, reflux extraction time is 120min, the extraction rate of oleanolic acid is 3.000 mg/g; XDA-1 resin is favorable in purification of OA in Chaenomeles sinensis Koehne, the optimum purification conditions are found to be 0.794 mg/mL of OA concentration, the flow rate of adsorption is 0.5 mL/min; the desorption solvent is 90% ethanol, and the flow rate of elutant is 1.0 mL/min.

结果表明，超声波辅助提取最佳工艺条件为：超声功率600 W、提取温度53℃、液料比8：1、超声波提取70 min，回流提取120 min，齐墩果酸得率为3.000 mg/g；XDA-1型大孔树脂对齐墩果酸具有较好的吸附和解吸效果，最佳纯化工艺条件为上柱液浓度0.794 mg/mL，吸附流速0.5 mL/min；以90%浓度乙醇洗脱，洗脱流速1.0 mL/min，纯化后得提取物中齐墩果酸纯度可达26.55%。

Preparation of the cathode includes:shaping under the press of 40Mpa, sintering at 550℃for 1 hour and at 900℃for 8 hours and threading with molybdenum bar; Considering the literatures we choose CaCl2 as salt for preparation titanium. Pretreatment of salt is for 1 hour at 100℃and for 2 hours at 300℃. Partial pressure of oxygen which need lower than 5.11×10-7Pa to reduct titanium oxides and hygroscopic property of salt need a sealed equipment to electrolyse. And finally successfully designed a satisfied one and the results show that the equipment can be satisfied the requirment of the experiment. Flow of the inert gas is 1.5L/min, the voltage is 2.8 V, temperature is 850℃and time is 2 hours during pre-electrolysis. Flow of the inert gas is 0.2L/min, the voltage is 3.1 V, temperature is 900℃and time changes with the mass of TiO2 during electrolysis, namely the greater need the longer time; To eliminate influence of salt and other impurities, the products need to wash with distilled water and dilute chlorhydric acid , then wash with dilute hydrochloric acid under supersonic wave assistant. Finally, electrometical properties of the electrolysis of TiO2 is researched by cyclic voltammetry and chronoamperometry, and results show that there are two main reodox steps, namely from TiO2 to TiO and from TiO to Ti.

阴极制备主要包括40MPa压力下模压成型、两段式烧结(1小时内升至550℃保温1小时，再1小时升温至900℃保温8小时)及烧结后TiO2块打孔用钼棒串接三个主要环节；实验中选用CaCl2作为电解熔盐，并对其进行预处理(100℃，保温1小时； 300℃，保温2小时)；经热力学计算，还原钛氧化物的氧分压至少要低于5.11×10-7Pa，结合电解过程中所用熔盐CaCl2有极强的吸水性的特点，电解装置应有较高的密封性，自行设计了一套密封性可靠的电解装置，便于实验过程中熔盐预处理和氧分压的控制；通过干燥处理预电解过程中Ar流量大约为1.5L/min、电压为2.8 V、温度为850℃、时间为2小时，电解过程中Ar流量大约为0.2L/min、电压为3.1V、温度为900℃，实验结果表明电解时间与TiO2质量密切相关，质量越大需要电解的时间越长；通过自来水冲洗—稀盐酸浸泡、洗涤—在超声波辅助作用下稀盐酸洗涤，可减少熔盐及其它杂质对电解产物检测结果的影响；最后，通过循环伏安法、计时电流法对电解机理的研究，确定电解还原TiO2制备金属钛主要经历了TiO2-TiO-Ti的过程。

The Km and Vmax were 7.35 mg/ml and 0.206 nmol/min-mg for ChoA, and 30.42 mg/ml and 0.376xmol/min-mg for ChoB, respectively. A 270bp DNA fragment, the partial chitosanase gene from Penicillium sp.

酶A的米氏常数K_m及最大反应速度V_分别为7.35 mg／ml、0.206 μmol／min·mg，酶B的米氏常数K_m及最大反应速度V_分别是30.42 mg／ml、0.376μmol／min·mg。

Lucky article-sculpt , sculpture etc., This products can supplying water in time while occurring fire, supplying water speed about 4T/min-10T/min, supplying water angle can circumvolve 360°, all angle can supplying water, and has the auto-outpour device.

设计生产不同的艺术造型。标志物，吉祥物，雕塑等。能为扑救特大火灾，及时提供水源。

The results indicated, catalytic activity was very high, the average rate of O 2 uptake was 4.25×10 -2 mmol/min after 10 min, the yield of cyclopentanone was up to 83%.

实验结果表明，该催化体系对环戊烯的羰基化显示出较高的催化活性，反应 1 0 min，反应的平均吸氧速率为 4.2 5× 1 0 -2 mmol/min，环戊酮的收率可达 83%。

The CPF/ZnO nanomaterial, obtained by treating the precursor PF/ZnO at 460 ℃ for 40 min, could fully decolorize and degrade dye MB in 10 min under the natural light compared with 10% degradation of MB on ZnO only under the same reaction condition. The decolorizing efficiency will be still above 80% after 3 cycles.

如在460 ℃下处理40 min所得的纳米复合材料，在自然光条件下，10 min即可使MB溶液完全脱色，而在相同条件下，纯纳米ZnO仅能使MB的脱色率为10%左右；该催化材料重复使用3次仍可使MB溶液的脱色率保持在80%以上。

After the combined treatment performed at pH=4.0, using 2.5 of TiO2 for 8 min of adsorption and 20 mg/L of ClO2 for 2 min of oxidation, the treated sample was dischargeable under the existing discharge limits for dyeing wastewater; the starting COD was reduced from 750 mg/L to〈100 mg/L and that the wastewater color was reduced from 250 dilutions to 40 dilutions.

结果表明，对于COD为750mg／L、色度为250倍、SS为100mg／L的1000mL印染废水，当溶液pH为4.0、ClO2用量20mg／L、TiO2复合吸附剂用量2.5g、反应时间和吸附时间分别为2、8min时，处理后的废水COD＜100mg／L、色度〈40倍、SS＜70mg／L，达到了《纺织染整工业水污染物排放标准》（GB4287—92）排放要求。

Don't listen to their haver, nothing of that sort.

别听他们胡说八道，根本就没那回事。

But bank's shares trade below their book value, suggesting that investors are skeptical.

但是，银行股票以低于账面价值的价格交易，这一点反应了投资者的怀疑。