查询词典 MIN

Quiet adult heart rate over 120 times/min, and for the tachycardia less than 40 times/min for bradycardia.

成人安静心率超过120 次/ min 者，为心动过速低于40 次/ min 者为心动过缓。

The bromoform concentration of 16.4 μg/l measured after 80 min contact time was reduced to 1.6 μg /l by GAC filtration with an empty bed contact time of 4.2 min.

接触80分钟后测出的16.4μg/l的溴仿浓度经过4.2分钟空床停留时间的活性炭过滤已降至1.6μg/l。

The results show that under the same standard calefaction curve and the same load (132 74 kN), the fire endurance of naked WGJ510C2 is 39 min and that of Q235 steel is 27 min.

结果表明：在标准升温曲线和相同载荷(132 74 kN)下，裸露WGJ510C2 钢梁的耐火极限为39 min，裸露Q235钢梁的耐火极限为27 min，即裸露WGJ510C2钢梁的耐火极限比裸露Q235 钢梁高44 4%。

ResultsA slide of bacterial suspension with a concentration of 1.5×1012/L , to be placed at 37 ℃ for 10 min then stained by carbolfuchsin for 10-15 min. Under a microscope, a clear background with red thalli and faint red flagellum could be seen in 80%-90% of the bacteria.

结果 浓度为1.5×1012/L的菌悬液37 ℃放置10 min制片，用石炭酸复红法染色10～15 min，水洗，干燥镜检，其背景清晰，80%～90%的细菌有鞭毛，菌体红色，鞭毛淡红色，染色效果理想。

Additionally, the orthogonal design was adopted to research the optimum process of coacervation, the oil-water mixture emulsified at speed of 1500 r/min for 60 min with the temperature at 60 ℃, pH at 4.0 had the best effect.

同时采用正交设计对包埋工艺进行了优化，确定当pH为4.0，包埋温度控制在60 ℃，乳化时间60 min，搅拌速度为1500 r/min时，包埋效果最好。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After preaging at 100℃for 24 h, retrogression at 200℃for 7 min, and reaging at 100℃for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210MPa in 3.0%NaCl+0.5%H2O2corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100 ℃ for 24 h, retrogression at 200 ℃ for 7 min, and reaging at 100 ℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5%H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100℃ for 24 h, retrogression at 200℃ for 7 min, and reaging at 100℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5% H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the micro- structure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa，767 MPa和9.1%，显示优越的综合性能。

The second was to compare the effects of the different floating liquids on the destruction of rabbit coccidia oocysts. The results indicated that magnesium sulfate solution showed the lowest rate of coccidia oocyst destruction at 20 min; saturated salt water had the greatest rate of destruction. The destruction increased with time; in the saturated salt water and urea solution damage or deformation of a few coccidia oocysts at were observed 60 min.

其二，不同漂浮液对兔球虫卵囊破坏作用比较；结果表明20min时硫酸镁溶液对卵囊破坏率最低，破坏率最大的是饱和食盐水，随着时间延长各种破坏作用增大，60min时饱和食盐水和尿素溶液中有极少卵囊破损和卵囊变形现象。

The waste combustion in the waste bed and the impacts of the waste burning efficiency are complex. In order to solve this problem, the method of numerical simulation has been adopted to simulate waste combustion, and calculate the mass loss rate, moisture evaporation, volatile release, char burning rate. Used the total flow rate of primary air between 50～1 000 Nm3/min to calculate the mass loss, excess air coefficient of waste bed, components of the gas. Calculated results show that the burning efficiency is higher when the total flow rate of primary air is at 517.47～632.09 Nm3/min .

针对垃圾焚烧炉床层内垃圾燃烧过程复杂性及影响垃圾燃烧效率因素多的问题，运用数值仿真方法对某垃圾焚烧炉床层垃圾燃烧进行了模拟，获得了垃圾质量流失速率、水分蒸发速率、挥发分释放速率、焦炭燃烧速率和烟气的温度；并在50～1 000 Nm3/min范围内改变一次风流量，获得了床层质量流失比值、过剩空气系数和烟气中各组分的质量百分比含量。

There are two types of gold deposits in this area, namely altered rock type and quartz vein type.

本区金矿床包括两种类型：柴胡栏子金矿床为蚀变岩型金矿；莲花山和红花沟金矿床属石英脉型。

You were home and it was two weeks ago.

你回到了家里。当时是两周前。