过载

基本解释 (translations)

overload  ·  overloaded  ·  overloading  ·  overstress  ·  overloads

词组短语

over loading

与过载相关的网络例句 [注：此内容来源于网络，仅供参考]

The device run perfectly when the subjects were exposed to + 9 G maximum profiles at acceleration onset rate 3 G/s and the average acceleration protection value of the anti-G equipment was above 3.5 G.

具有分压装置的新型抗荷服进行了10人次的离心机生理试验，在过载增长率3G/s、最大试验过载9G条件下，分压装置工作正常，装备抗荷效果达到了3.5G。

Using Latin square test, the effect of geometrical parameters on the characteristics of non-overload sewage pump was studied, and the effecting principle of geometrical parameters on efficiency, maximum brake horsepower and its location were researched, the major and minor factors affecting these performance were found out by way of variance analysis, the correction of equation on maximum brake horsepower and its location were also tested.

用正交试验法研究了各几何参数对无过载排污泵性能的影响，探索了各几何参数对效率、最大轴功率值及其位置的影响规律，并通过方差分析找到了影响这些性能的主要因素和次要因素，验证了无过载排污泵最大轴功率值及其位置公式的正确性，根据试验结果对模型泵提出了进一步设计方案，本试验结果对无过载排污泵水力设计有一定的参考价值。

The four varistors form the Wheatstone full bridge. Two lateral sides of cantilever and overload protection structure are fabricated using DRIE technology. A novel overload protection curvature is designed to be similar to the cantilever bending shape which is bearing the greatest acceleration. This design increases the overload protection and improves the vibration damping of accelerometer to the critical damping.

悬臂梁两侧面和过载保护曲面采用DRIE技术加工，过载保护曲面设计成近似于冲击加速度传感器承受最大加速度时悬臂梁弯曲曲面的形状，一方面提高了悬臂梁过载保护能力，另一方面可以调节加速度传感器的工作阻尼至临界阻尼，有效提高了加速度传感器的工作频率带宽。

In the power supply circuit, series power supply and the adjustment of the series load, the load current flows through all of the adjustments, and transistors Guozainaili worse, once output overload or short circuit, the input voltage increases in the full set of adjustment an emitter, the current surge to adjust the fierce heat, if not over-current protection measures at this time, the adjustment will be burned, power Zhengliuguan also will be greatly threatened or damaged.

中文摘要：在稳压电源电路中，串联型稳压电源的调整管与负载串联，负载电流全部流经调整管，而晶体管的过载能力较差，一旦输出端过载或短路，输入电压全部加在调整管集---射极间，其电流剧增，使调整管猛烈发热，如果此时没有过流保护措施，调整管就要被烧坏，电源整流管也将受到巨大威胁或损坏。

It design an overloading protection equipments base on the characteristic of the Super High-speed rotating equipment ,which are fit for a certain super high-speed rotating equipment,,and analysing the mechanical characteristic of the super high-speed rotating part by the finite element method.

针对超高速旋转设备的工作特点，设计了适合超高速旋转设备使用的过载保护装置，并利用有限元方法分析了超高速旋转条件下的转子力学特性；对包括模态、冲击响应、谐响应等在内的过载保护器动态特性以及工作过程中产生的不平衡量和摩擦热等影响过载保护装置正常工作的因素进行了分析计算。

But have something, these things between the good friend are information won't overload, if added very much very much good friend in disorder,meet overload, but now won't overload, when so you watch this news, your heavy visual range on the feeling is spent seeing the thing with a common very big information content than you is to want tall, in post of hair of a lot of people in BBS, big forum can send ten note one day, this is the circumstance of an information overload actually, but why a lot of people still are willing is bubble inside?

但是有一些东西，好友之间的这些东西一个是信息不会过载，如果乱加了很多很多好友会过载，但是现在不会过载，所以你看这个信息的时候，感觉上你的重视程度就比你看一个普通的信息量很大的东西就是要高，在BBS里很多人发帖，大的论坛一天能发十几万帖，这个其实就是一个信息过载的情况，但为什么还有很多人愿意泡在里面？

Instantaneous power, and过载能力strong load factor should be 3 ~ 4, to speed up performance

瞬时功率大，过载能力强、过载系数应为3～4，加速性能好。

The reliability analysis method of multi-overstress is introduced based on that of single overstress, and the Bayesian reliability growth model to analyze the SRM overtime test is proposed.

在单应力过载可靠性分析方法基础上，引入多应力过载，考虑多应力相关和不相关两种情形，丰富了发动机部件过载试验分析理论。

Finally, calculate in series power flow of a line after overload line tripping to confirm the parallel transmission section of overload line.

线路过载后，依序比较回路中线路与过载线路的潮流方向，以判定其是否属于过载线路的并行输电断面。

Regarding the thermobaric explosive further tests, the research showed that the compressive stress was 6.699MPa; The tensile stress was 0.716MPa; Heat sensitivity was 288℃(5s); The anti-overload capacity may withstand 1.0×104g launch overloads and smaller than 2×105g the impact deceleration overload; first decomposition temperature was 251.9 ℃, highest exothermic peak temperature was 286.9 ℃; In the compatibility, except the ceresin and Oxidant, the ceresin and the F rubber, the ceresin and Al compatible rank could reach to second level of compatibility, the others could reach to the first level of compatibility.

对此粘结-钝感体系包覆的温压炸药样品进一步测试研究显示：抗压强度为6.699MPa；抗拉强度为0.716 MPa；热感度为288℃（5s爆发点）；抗过载能力为可承受1.0×104g的发射过载和小于2×105g的撞击减速过载；安定性为分解温度251.9℃，最高放热峰温度286.9℃；内相容性为除蜡类钝感剂+氧化剂，蜡类钝感剂+F橡胶，蜡类钝感剂+Al相容性等级为2级相容性较好外，其他组分间相容性均为1级，相容性很好。

与过载相关的网络解释 [注：此内容来源于网络，仅供参考]

Overload breakage：过载断裂

overload alarm control 过载警戒控制 | overload breakage 过载断裂 | overload capacity 过载容量

Mot overload：马达过载 可编程 无 不可

Drv overload 驱动器过载 可编程 无 不可 | Mot overload 马达过载 可编程 无 不可 | BU overload 制动电阻过载 可编程 无 不可

Mot overload：马达过载

Drv overload 驱动器过载 | Mot overload 马达过载 | BU overload 制动电阻过载

OCS OverloadControlSubsystem：过载控制子系统

OLCA OverloadControlClass 过载控制类别 | OCS OverloadControlSubsystem 过载控制子系统 | OE OverrunError 超限错误

overload factor：过载因数

overload efficiency 过载效率 | overload factor 过载因数 | overload indicator 过载指示器

overload test：过载试验

overload resistance抗过载性 | overload test过载试验 | overloading过载

overload relay：过载继电器

利用电磁接触器加装过载继电器(Overload Relay)或积热继电器(Thermal Relay)此为限制电流大小方向著手,当马达过载时所产生的热量使得保护继电器作动,而使接触器跳脱,而达到保护之功用,一般选用110%~125%压缩机马达过载电流跳脱

BU overload：电机过载

drive overload:变频器过载 | BU overload:电机过载 | data lost:制动单元过载

overload circuit breaker：过载断路器

overload capacity 过载容量 | overload circuit breaker 过载断路器 | overload coefficient 过载系数

overload circuit breaker：过载断路器,超载断路器

overload circuit ==> 过载电路 | overload circuit breaker ==> 过载断路器,超载断路器 | overload circuit-breaker ==> 过载断路器