结构层

词组短语

structure sheaf

与结构层相关的网络例句 [注：此内容来源于网络，仅供参考]

As a result, if the iridescence is produced by thin-film interference, not only the thickness of lamellar structure must be defined within a certain nanometer, but also the refractive index need to be different between lamellar structure. In other words, the chemical composition, refractive index and thickness of exsolution lamellae need form to trinity, such as labradorite, albite, andradite and orthoamphibole. If the iridescent color is produced by grating-diffraction, the lamellar structure just needs to be arrayed regularly, the spacing of the edges of lamellar structure needs to be regular and narrow, but not necessarily within the range of the wavelength of visible light, such as shell of abalone, pearl and opal.

薄膜干涉式晕彩不仅要求宝石内部结构层的厚度必须在一定的纳米范围内，而且结构层内部的折射率也必须有所差别，也即，当结构层由两相组分出溶而成，其化学成分、折射率和结构层厚度形成三位一体时，符合薄膜干涉式晕彩，如拉长石、钠长石、石榴石和角闪石；而光栅式衍射晕彩则仅要求结构层排列规则，边缘狭窄但不需要窄到可见光波长范围内，能使入射光的振幅或位相，或两者同时产生周期性空间调制的结构即可，如鲍贝壳、珍珠和欧泊。

The relationship between inter-story torsion angle and torsion deformation ratio is deduced base on the rule of irregular plan structures in China tall building technical specification. Considering the inter-story ratio limitation of different performance levels under different earthquake hazard levels, a series of torsion angle demand curves are established and a new method named as Torsion Angle Capacity Spectrum is put forward for the PBSD of irregular plan frame structures.

从现行规范对平面不规则结构的限制条件出发，推导出了结构层间扭转角与扭转位移比的关系式，结合框架结构在不同性能水平下的层间侧移角限值，建立了平面不规则框架结构在不同地震作用水平下的扭转角需求曲线，提出了扭转角能力谱法。

The main theorem of this paper is to, firstly, on the grounds of experience preliminarily estimate the parameter of the pavement nonlinear model, simulate the process with computer procedure, and check the result with the data collected in sit, then set the aim function and the superiority back-calculation method, if the function is not satisfied, it is to the method adjust the parameter and make the model impend the actuality, If the function is satisfied, it is to end the process, and record the stress, deformation, displacement and the parameter as the actual condition.

本文分析的主要原理：首先根据经验，初估路面结构层应力应变非线性参数，利用计算机程序模拟承载板试验测回弹弯沉的过程，通过现场实测的弯沉数据来检核该模拟过程的真实性，设定目标函数，选定适当的优化反算方法，当目标函数不满足时，即利用该优化反算方法调整本构模型参数，使得模型能够逐步向真实解逼近，当目标函数得到满足时，则认为此时反算得到的路面结构层的应力、应变、位移场为真实的应力、应变、位移场，所推算得到的非线性应力应变模型为真实的路面结构层应力应变模型。

These planes are respectively the planes of Discord, Segregation, Hopelessness, Shame, Fear, Usury, Anti-Matter, Disharmony, Joylessness, Altruism, Hierarchical Structure, Judgment, Anarchy and Hatred.

这些层面分别是不和谐层、种族隔离层、失望层、羞耻层、恐惧层、剥削层、反物质层、失调层、悲哀层、利他主义层、等级结构层、批判层、无秩序层和憎恨层。

In this paper eighteen examples, which are designed strictly owning to currently Codefor seismic design of buildings of my country, are used to analyze the structure earthquakeresponse under the horizontal seismic load (nabla load distribution pattern) by Push-overanalytical method. The corresponding structural influencing coefficient, the displacementamplification factor, the overstength and ductility factors are analyzed taking into accountthe factors changing, such as level number, span length, span number.

本文严格按我国《建筑抗震设计规范》设计了18个多层钢框架，并以此为例，采用Push-over方法分析了结构在水平荷载作用下的地震反应，得出了多层钢框架的结构影响系数、结构延性和超强系数以及位移放大系数，并讨论了这些系数随着结构层数、跨度及跨数的变化规律。

The finite element method is employed to analyze the shearing stress of the concrete bridge decks with waterproof layer.

应用有限元法，对设防水层的水泥混凝土桥桥面沥青铺装结构进行剪应力计算，分析了防水层的厚度、模量、泊松比、沥青混凝土铺装层厚度和模量等参数对结构层剪应力的影响，认为层间最大剪应力主要取决于面层厚度和防水层模量，相同的防水层模量通过增加面层厚度是降低层间剪应力的最有效手段。

The paper through the mechanism which produces to the asphalt road surface water harm carries on the induction to summarize, as well as the different type bituminous mixture water stability has carried on a series of contrasts experiment to several kind of different aggregates and the asphalt adherency, has analyzed the aggregate and the asphalt adherency and the bituminous mixture water stability; Meanwhile moves the water action mechanism take the pavement structure in as the key point, in the basis room experiments to the design half rigid base bituminous mixture test sample carries on washes out the experiment, the observation test sample and washes out when the number of times increase along with the time variation the basic unit wash load situation, has analyzed the water to the bituminous pavement various structures level damage rule; To immerses under the condition using the ANASYS finite element software the bituminous pavement structure level the stress to carry on the analysis computation, and analyzed the bituminous pavement according to the computed result to produce the unboiled water harm the rule, further to understand the structure level produced the unboiled water harm the rule.

本论文通过对沥青路面水损害产生的机理进行归纳总结，对几种不同集料和沥青的粘附性以及采用不同抗剥落措施的沥青混合料的水稳性进行了一系列对比试验，分析了集料与沥青的粘附性及沥青混合料的水稳定性，并对水稳性试验进行了评价；同时以路面结构中的动水作用机理为重点，依据室内试验对设计的半刚性基层沥青混合料组合试件进行冲刷试验，观察试件随时间变化和冲刷次数增加时基层的冲刷量情况，分析了水对沥青路面结构层的损坏规律；利用ANSYS有限元软件对浸水前后沥青路面层底应力进行分析计算，并根据计算结果分析了沥青路面产生水损害的规律，进一步了解结构层产生水损害的规律。

The two-dimensional structural units (such as silicon-oxygen tetrahedral sheet, octahedral sheet), interlayer space are assembled according to the sphere close packing manner, and the close packing layers parallel to {0001}. There are several mechanisms to release the difference in size while the silicon-oxygen tetrahedral sheet and octahedral sheet assemble the TO and TOT-type structural layers. The two types of structural layers with different interlayer space fitted together in six kinds of assembling modes and formed six kinds of crystal layers. The combinatorics analysis of the two-dimensional structural units revealed that there may be 28 kinds of TOT type interstradified minerals in six kinds of polysomatic assembling modes of interatradified structure. The structural layer is symmetrical for octahedron sheet in the structure of interstratified minerals and shows polarity characteristics.

结果表明，不同二维结构单元体（包括硅氧四面体片、八面体片、层间域的构筑基本符合球体紧密堆积原理，紧密堆积层平行{0001}；四面体片与八面体片构筑TO和TOT结构层时采取多种机制消除二者在二维尺寸上的差异；两种模式的结构层与不同类型的层间物组装形成六种组装模式的晶层；并通过二维结构单元体的组合规律的分析，计算出可能存在的28种TOT型间层结构，它们分属于6种间层结构多体性组装模式；间层结构中，结构层对于八面体片是不对称的，并在属性上表现出极性特征；间层矿物的晶层类型可用6种多体性组装模式加以表达。

Combining material strength theory and using 3D finite elements model, detailed analysis of loading, thermal, coupled stress condition in joint area of overlay is given effected by stress-absorbing interlays parameters of thickness, modulus, with in-place pavement sensors, it was generalized max temperature changes.

首先，运用材料强度理论，通过三维有限元方法分析了荷载及温度作用下接缝区应力吸收层沥青加铺结构层内应力随吸收层厚度、模量参数的变化规律，此外，通过对现场温度场的测定，确定了湖北地区路面结构的最大降温差。

Based on STEP standard and IDEF method, on the basis of function layer, product information model and its structures with three layers (i. e. function layer, generic part layer, generic structure layer) were built.

基于STEP标准和IDEF产品建模方法，提出了基于功能层的产品信息建模和产品信息模型的三层结构：功能层、广义零件层和广义结构层。

与结构层相关的网络解释 [注：此内容来源于网络，仅供参考]

clad：包覆层

另一个改进是在LED的结构内部,在p型包覆层(Clad)的下部设计了使用金属材料的反射层. 由此使得在发光层中发出的光中,进入底板内侧的光会通过反射层的界面反射到LED的表面. 反射层的反射率为70%. 关于使用金属材料设计反射层的结构,

Structural instrument panel：结构仪表板

Stroke|(悬架)减振器,冲程 | Structural instrument panel|结构仪表板 | Structural layer|结构层

RBS：资源分解结构

* 层次化编码定义:企业项目结构(EPS)、项目工作分解结构(WBS)、企业组织结构(OBS)、资源与角色结构(RBS)、费用分解结构(CBS)等* 50层工作分解(WBS)结构,每层的编* 尚需工作(ETC)的估计方式用户可选* 资源分解结构(RBS)层次图

structure morphism：结构射

structure group 结构群 | structure morphism 结构射 | structure sheaf 结构层

structure sheaf：结构层

structure morphism 结构射 | structure sheaf 结构层 | structure theorem 结构定理

tomography：层析

对用能量损失近边结构(ELNES)分析电子结构也有涉及. 3、透射电镜图像只是样品的投影结构. 理论上说,电子三维层析(tomography)可解决之. 电镜随谈之三:能谱(EDS)的一些问题3、透射电镜图像只是样品的投影结构. 理论上说,电子三维层析(tomography)可解决之.

tectosphere：大地构造圈,地壳结构层

构造体 tectosome | 大地构造圈,地壳结构层 tectosphere | 构造地层 tectostratigraphic

stacking fault：堆垛层错

[简介]2009年5月9日 堆垛层错(stacking fault)是广义的层状结构晶格中常见的一种面缺陷. 它是晶体结构层正常的周期性重复堆垛顺序在某二层间出现了错误,从而导致的沿该

laminar air stream：层状空气流,层流空气流

lamellar structure || 层状结构,层状组织,片状结构,片状组织 | laminar air stream || 层状空气流,层流空气流 | laminar boundary layer || 片状边界层,层流边界层

Three-tier structure：三层体系结构

三层体系结构:three-tier-frame | 三层体系结构:Three-tier Structure | 三层体系结构:three-tier architecture