- 更多网络例句与折皱变形相关的网络例句 [注：此内容来源于网络，仅供参考]
-
Beijingensis under three droughttreatments, normal, moderate and severe stresses. The results showed:(1) the canker disease ofboth cultivars was serious gradually with increased drought;(2) the bark tissue cells sufferedplasmolysis, more evident with the severity of drought stress;(3) under the drought andinoculation with B. dothidea, cells of two cultivars damaged at different degree, mailyrepresented in the changes of organelles, such as chloroplast swollen and distorted, number ofmitochondria increased and membrane system indistinct; then organelles suffered furtherdamagement with inoculation time, thinned mitochondrias stroma, decreased cristae, crumpledand partly broken membrane of chloroplasts with stroma exosmosis. At last, the chloroplastspartly disorganized;(4) the hyphae growed mainly intercellular in resistant cultivar and notonly intercellular but also intracellular in susceptible cultivar, which directly caused thenecrosis of cells;(5) under the severe drought, the damage of cells enhanced the infection ofpathogen and drought and pathogen stressed together and promoted the disease development;the damage from pathogen on cells was more serious than that from drought.
结果显示：(1)随着干旱胁迫程度的增加，2种杨树溃疡病害发生渐趋严重；(2)干旱胁迫下，杨树树皮组织细胞发生质壁分离，并随胁迫程度的增加而严重；(3)干旱胁迫下接种病原菌，2种杨树细胞发生不同程度的损伤，主要表现为细胞器发生较大变化，如出现叶绿体肿胀变形、线粒体数量增多，质膜模糊不清等现象；随接种时间的延长，细胞器受到进一步损伤，叶绿体被膜折皱，严重时局部破裂，基质外渗，并部分最终解体；(4)毛白杨中的菌丝主要在细胞间隙中穿行，而北京杨的菌丝除在细胞间隙中生长之外，侵入细胞内部也较多，直接导致细胞的解体；(5)干旱胁迫下细胞的损伤促进了病原菌的侵染，干旱和病原菌的双重胁迫加剧了病害的发生程度，并且病原菌侵染对细胞的破坏程度大于水分胁迫。
-
If there is joint on the back, in the lower right or fill a 20% discount after it has been causing wrinkles without distortion; vacuum packaging vacuum after the contents of the packin mouldedround radiofrequent nonanatomical tridimension on the surface, shape, surface roughness, would create a bar code reading of deformation cannot, therefore, be appropriate for the vacuum packing inner bag direct business card printing and membership card to make a bar code, you can increase the packin business card printing outside and membership card to make a bar code, and other graphics and text.
如背面中央有接缝，则印在右下方或印在填充后不起皱折、不变形处；真空包装抽真空后包装袋紧贴在内容物表面，呈不规则立体形状，表面不平整，会造成条形码变形不能识读，因此真空包装内袋不宜直接制卡和会员卡制作条形码，可增加一个外包装袋制卡和会员卡制作条形码及其他图文。
-
The hull body fractured and broken at about 1/3 of the length from the stem and in way, the shell plating, upper deck plating, inner bottom plating and internal structural members within the scope of about 10m torn or destroyed; the remaining shell plating, upper deck plating, inner bottom plating and internal structural members seriously indented and buckled or bent and deformed in different degrees.
船体从船首起约 1/3 处折裂破断，该处船壳板，上甲板，内底板，内部构件在约 10 米范围内撕裂或损毁；其余船壳板，上甲板，内底板，内部构件严重凹陷，皱折或不同程度上弯曲变形。
- 更多网络解释与折皱变形相关的网络解释 [注：此内容来源于网络，仅供参考]
-
Bloat：膨胀
5-2-4 膨胀(Bloat)工具 5-2-5 扇形扭曲(Scallop)工具 5-2-6 晶体休(Crystallize)工具 5-2-7 折皱(Wrinkle)工具 5-3 封套(Envelope)变形 5-3-1 使用默认封套变形 5-3-2 使用封套变形网格 5-3-3 使用对象进行封套变形 5-3-4 编辑封套变形 5-4 对象的变形 5-4-1 移动(Move)对象 5-4-2 旋转(Rotate)对象 5-4-3 缩放(Scale)对象
-
buckling deformation：失稳变形
buckling deformation 翘曲变形;失稳变形;皱折变形 | buckling deformation 失稳变形 | buckling factor 失稳因数
-
buckling deformation：翘曲变形;失稳变形;皱折变形
buckling deformation 翘曲变形 | buckling deformation 翘曲变形;失稳变形;皱折变形 | buckling deformation 失稳变形
-
scissors：剪刀
5-1-14 剪刀(Scissors)工具 5-1-15 美工刀(Knife)工具 5-1-16 修整 5-1-17 一般修整 5-2 液化变形工具 5-2-1 弯曲(Warp)工具 5-2-2 扭转(Twirl)工具 5-2-3 收缩(Pucker)工具 5-2-4 膨胀(Bloat)工具 5-2-5 扇形扭曲(Scallop)工具 5-2-6 晶体休(Crystallize)工具 5-2-7 折皱(Wrinkle)工具 5-3 封套(Envelope)变形 5-3-1 使用默
-
Twirl：扭转
5-2-2 扭转(Twirl)工具 5-2-3 收缩(Pucker)工具 5-2-4 膨胀(Bloat)工具 5-2-5 扇形扭曲(Scallop)工具 5-2-6 晶体休(Crystallize)工具 5-2-7 折皱(Wrinkle)工具 5-3 封套(Envelope)变形 5-3-1 使用默认封套变形 5-3-2 使用封套变形网格 5-3-3 使用对象进行封套变形 5-3-4 编辑封套变形 5-4 对象的变形 5-4-1 移动(Move)对象
-
wrinkle：皱
5-2-7 折皱(Wrinkle)工具 5-3 封套(Envelope)变形 5-3-1 使用默认封套变形 5-3-2 使用封套变形网格 5-3-3 使用对象进行封套变形 5-3-4 编辑封套变形 5-4 对象的变形 5-4-1 移动(Move)对象 5-4-2 旋转(Rotate)对象 5-4-3 缩放(Scale)对象 5-4-4 倾斜(Shear)对象 5-4-5 反射(Reflect)对象 5-4-6 扭曲(Distort)变形对象 5-4-7