topographical features

topographical features的基本解释

-

地貌, 形势

与topographical features相关的网络例句 [注：此内容来源于网络，仅供参考]

In view of the fact that the maps of the two sides are not fully identical in their representation of topographical features the two parties have agreed that the actual features on the ground shall prevail, so far as the location and alignment of the boundary described in section one is concerned, and that they will be determined as far as possible by bgint survey on the ground.

鉴于这样的事实，即在地图上的双方并不完全一致，在其任职地形特点，双方都一致认为实际特点，在地面上为准，到目前为止，由于位置及路线描述的边界，在第一个方面，并表示，他们将决心尽可能bgint调查，在地上。

The topographical parameters have been analyzed by taking into account the thermal effect during the friction process. As the results, three kinds of typical topographical features have been observed for the worn surfaces of C G iron with various P content. Namely, C G iron with 0.05% P, 1.30% P, and 0.70% P show worn surfaces characterized by groove ridge, peak pits and their combined topography. The C G iron specimen with peak pits type worn surface topography showes the lowest wear rate and highest friction coefficient, while that with groove ridge type worn surface topography shows the highest wear rate and lowest friction coefficient. The groove ridge type worn surface has a relatively large value of surface height deviation and void volume ratio and negative large value of skewness, which is contrary to the peak pits topography.

结果表明：度销磨损表面主要呈现犁沟型、孤岛型及二者的混合型3种形貌特征，其中具有孤岛型磨损表面形貌特征的试样的摩擦系数较高，磨损率较低；而具有犁沟型磨损表面形貌特征的试样的摩擦系数最低，磨损率最高，分析表面形貌参数发现：犁沟型表面形貌具有最大的表面高度偏差和表面空隙率及高负值的表面高度分布参数；而孤岛型表面形貌的表面高度偏差和表面空隙率最小，表面高度分布参数为高正值。

The stone pillars and stalactites are widely spread and the tunnels shows off the cave's topographical features.

万丈窟内的石柱和钟乳石蔚为壮观，并向同一方向双重、三重发展，呈现出熔岩洞的地形特点。