throttle pull rod

throttle pull rod的基本解释

-

节流杆, (蒸汽机车)节汽门拉杆

与throttle pull rod相关的网络例句 [注：此内容来源于网络，仅供参考]

In view of the defects in conventional engine throttle manipulator system,A digital throttle control scheme was put forward in the paper, the throttle handle mechanism and step motor transmission-mechanism was designed,the control program is compiled, and the computer control is realized by pushing and puling throttle handle to change fuel pump governor throttle opening.

0引言传统的发动机燃油泵油门操纵系统是由机械传动的，虽然结构简单，但存在很多缺陷：传动部件较多，更换任何附件后都必须重新调节整个系统的协调性，而且调节较为复杂；可靠性不高，存在传动死角；误差较大，不利于远程传动。

Throttle Design accord with SY/ T5127-2002, API Spec 6A sum API Spec 16C request, Points structural form Can divide into Can mode throttle and Stationary type throttle, Fixes throttle valve casing and Can transfer throttle valve casing Can exchange.

节流阀JLK、JLG系列）的设计符合SY/T5127-2002、API Spec 6A和API Spec 16C要求，按结构形式可分为可调式节流阀和固定式节流阀，固定节流阀体与可调节流阀体可以互换。

First of all, the principle of the traditional throttle pedal is driven by cable-driven throttle to control engine power output, the current most advanced vehicles have been imported electronic throttle, its principle is based on servo motor control section of valve switching point of view, but the two operators who encounter the accelerator pedal stuck failure, life-saving methods should be the same, unless the electronic throttle with automatic reset power design, special or adapted vehicles is another matter.

首先，传统油门的原理是藉由脚踏板拉动钢索驱动节气门，藉以控制引擎动力输出，目前的高级车种大多已导入电子式节气门，其原理是以伺服马达控制节汽门开关角度，但两者如遭遇油门踏板卡死失效，救命的方法应该是一样的，除非电子式节气门有断电自动复位设计，特殊或改装车种则另当别论。

与throttle pull rod相关的网络解释 [注：此内容来源于网络，仅供参考]

hand brake pull rod guide anchor：手制动拉杆吊

hand brake pull rod chain 手制动拉杆链 | hand brake pull rod guide anchor 手制动拉杆吊 | hand brake pull rod guide 手制动拉杆导架

脱掉 pull on 穿上：pull off

pull in (列车等)进站 | pull off 脱掉 pull on 穿上 | pull out 拔出;(列车等)驶出

throttle positioner：节气门缓冲器

节气门位置开关? throttle position switch | 节气门缓冲器 throttle positioner | 节气门定位器? throttle positioner