slagging furnace

与slagging furnace相关的网络例句 [注：此内容来源于网络，仅供参考]

Bumer of this type is favorable for primary air-coal flow ignition and flame stability, as well as low Nox emissions. Flue gas re-circulation is employed to prevent furnace slagging and opposed-fired burner arrangement is capable of reducing residual swirl of furnace exit flue gas.

该炉燃烧器有利于煤粉气流的着火和火焰稳定；低Nox燃烧，有利于环保；与烟气再循环配合有利于防止炉膛结焦；前后墙布置切圆燃烧方式减少了炉膛出口气流的残余旋转，使水平烟道烟气流速分布更趋均匀。

The causes of furnace slagging in PG650t/h Boiler are analyzed, and some measures are presented to prevent.

分析了PG650t/h锅炉结渣的原因，提出了相应的技术对策。

After coal blending, the ignition and slagging behaviors of said coal have been obviously improved, temperature field in the furnace and slagging tendency being also obviously improved, but having certain influence upon the drying capacity of coal pulverizer.

配煤后，其著火和结渣特性得到明显改善，炉内温度场及结渣情况明显改善，但对磨煤机乾燥出力有一定影响。

Integrating full numerical simulation method of furnace with coal characteristic analysis, the paper makes a more complete prediction of furnace slagging. The aerodynamic field, gas temperature field and original ash layer temperature field are studied.

本文采用炉内过程全模拟的方法，对炉内的空气动力场、烟气温度场和原生灰污层表面温度进行分析，并结合煤灰结渣特性判别准则，对炉内结渣状况作出较为完整的预报。

This paper presents a strategy to investigate this influence by introducing heat resistance to represent fouling and slagging on furnace walls.

该文通过引入热阻来代表锅炉壁面的积灰结渣从而合理描述这种影响。

与slagging furnace相关的网络解释 [注：此内容来源于网络，仅供参考]

slagging in furnace：炉膛结渣

矿热炉:submerged-arc furnace | 炉膛结渣:slagging in furnace | 渗碳炉:carbon potential furnace