查询词典 tolerance limit
- 与 tolerance limit 相关的网络解释 [注：此内容来源于网络，仅供参考]
-
Tolerance upper limit：容忍上限
Tolerance lower limit, 容忍下限 | Tolerance upper limit, 容忍上限 | Torsion, 扰率
-
fault-tolerance computing：容错计算
fault-tolerance approach | 容错方法 | fault-tolerance computing | 容错计算 | fault-tolerance system | 容错系统
-
fault-tolerance approach：容错方法
fault-tolerance | 容错 | fault-tolerance approach | 容错方法 | fault-tolerance computing | 容错计算
-
resulting from lack of tolerance：因缺乏耐性所致
residual tolerance 残留耐量 | resulting from lack of tolerance 因缺乏耐性所致 | rolling tolerance 轧制公差
-
tolerance for indistinctness：不清晰度容限
tolerance for aberration 像差容限 | tolerance for indistinctness 不清晰度容限 | tolerance in alignment 对准公差
-
tolerance for indistinctness：不清楚度容限
tolerance for aberration 像差容限 | tolerance for indistinctness 不清楚度容限 | tolerance in alignment 对准公差
-
Lot tolerance fraction defective (LTFD)：批容许不良率
Lot tolerance failure rate (LTFR) 批容量故障率,批容量失效率 | Lot tolerance fraction defective (LTFD) 批容许不良率 | Lot tolerance fractional reliability deviation (LTFRD) 批容许可靠度变异
-
Lot tolerance fraction defective (LTFD)：批允差不良率
批允差故障率 lot tolerance failure rate (LTFR) | 批允差不良率 lot tolerance fraction defective (LTFD) | 批可靠度拒收水准 lot tolerance fractional reliability deviation (LTFRD)
-
perpendicularity tolerance：垂直度公差
平行度公差 parallelism tolerance | 垂直度公差 perpendicularity tolerance | 倾斜度公差 angularity tolerance
-
roundness tolerance：圆度公差; 不圆度公差
rolling tolerance 轧制公差 | roundness tolerance 圆度公差; 不圆度公差 | run-out tolerance 跳动公差; 摆差
- 相关中文对照歌词
- Breaking Point
- N.L. Party
- Puppet On A String
- Say Brah
- Say Brah (Radio)
- Up To The Limit (Live)
- Up To The Limit
- Push It To The Limit
- Sky's The Limit
- Push It
- 推荐网络解释
-
seal oil pressure：密封油压
"seal of bearing ","轴承密封" | "seal oil pressure ","密封油压" | "seal ring ","密封环,止漏环"
-
osteographer：骨论学家
choreographer舞蹈动作的设计者 | osteographer骨论学家 | glyphographer电刻者
-
drum switch：滚筒开关,转鼓开关
drum storage || 磁鼓存储器 | drum switch || 滚筒开关,转鼓开关 | drum test || 转鼓试验