查询词典 tolerance limit

Worm Lead form tolerance：蜗杆螺纹导程公差表

Worm Total Accumulated Pitch Variation 蜗杆总的积累齿距变化量 | Worm Lead Variation Tolerance 蜗杆螺纹导程变化公差 | Worm Lead form tolerance 蜗杆螺纹导程公差表

Worm Lead Variation Tolerance：蜗杆螺纹导程变化公差

Worm Total Accumulated Pitch Variation 蜗杆总的积累齿距变化量 | Worm Lead Variation Tolerance 蜗杆螺纹导程变化公差 | Worm Lead form tolerance 蜗杆螺纹导程公差表

Tolerance of dimensions for stampings：冲压件尺寸公差

烧结奥氏体不锈钢结构零件技术条件 Standard specification for sintered austenitic stainless steel st... | 冲压件尺寸公差 Tolerance of dimensions for stampings | 冲压件角度公差 Tolerance of angles for sta...

tolerance zone for shaft key way：轴槽公差带

轮槽 boss key way | 轴槽公差带 tolerance zone for shaft key way | 轮槽公差带 tolerance zone for boss key way

School Failure Tolerance Scale：学业失败承受力量表

school failure tolerance 学业失败承受力 学业失败承受力 | School Failure Tolerance Scale 学业失败承受力量表 | school group 学校群体

Pos. Tolerance：正公差

Part Type: : 元件类型 | Pos. Tolerance: 正公差 | Neg. Tolerance: 负公差

acceptance tolerance limit：可接受的宽限度

acceptance test 接受性测试 | acceptance tolerance limit 可接受的宽限度 | acceptance 接受

My tolerance of your impoliteness is limited：(我对你的无礼的忍耐是有限的. )

4) These plants are tolerant of extreme heat. (这些植物能耐酷热. ) | 5) My tolerance of your impoliteness is limited. (我对你的无礼的忍耐是有限的. ) | 11. limit n. 限制 v. 限制

low of cosines：余弦定律

lot tolerance fraction defective 批容许废品率 | low of cosines 余弦定律 | lower approximate limit 下近似极限

natural sufficient statistic：自然充分统计量

自然尺度 natural scale | 自然充分统计量 natural sufficient statistic | 自然允差界限 natural tolerance limit

locating center punch：定位中心冲头

lining 内衬 | locating center punch 定位中心冲头 | locating pilot pin 定位导梢

Humours：(幽默) (幽默) 幽默

13 Euphemism (委婉) (委婉) 委婉 | 14 Grotesque (怪诞) (怪诞) 怪诞 | 15 Humours (幽默) (幽默) 幽默