颜色强度

Results Two different ligations resulted in different changes in both morphology of hepatic roght lobe and signals on T1WI ,T2WI and DWI. In Group A, hepatic right lobes resulted in coagulation necrosis with no significant morphological change, but distinct hyperintensity on T2WI and DWI appeared. In Group B, after 24h and 72h of ligations, right lobes were atrophied and darkled, the rest lobes became hypertrophied.

结果 两种血流阻断法引起肝右叶形态及T1、T2及DWI信号发生了不同变化：A组肝右叶即发生凝固性坏死，体积大小无明显变化；T2WI及DWI上表现为明显高信号。B组术后24、72h后右叶体积变小，颜色变暗，左叶代偿性变大；T2WI上肝右叶为中等略低信号，T1WI呈略高信号，DWI上信号强度明显降低。

In order to prevent destruction of fenestrae overall sense of the box and to allow more light boxes look, SANAA outside in a box covered with gauze-like aluminum network, it will as sunlight intensity, time and weather differences, while Silver, gray, white and a variety of color change.

为了不让窗孔破坏了盒子的整体感，以及让盒子有更轻盈的外观， SANAA 在盒子外覆盖一层薄纱般的铝网，它会随著阳光照射强度、时间和天气的不同，而有银、灰、白多种颜色变化。

Two series of polyurethane acrylate grafted acrylic resins (Acr-g-TPU-PETA and Acr-gPPU-PETA) self-emulsifying systems are obtained by grafting -NCO group modified polyurethane acrylates with acrylic copolymer prepared from n-butyl acrylate, styrene,βhydroxyethyl methacrylate and acrylic acid The self-emulsifying systems showed Newtonian fluidity with viscosity closed to that of water, the solid contents were around 30% The T〓 of 15～4℃ for dried film before photocuring favored film formation at room temperature DSC and DMA results showed that PU-PETA is compatible with acrylic resin in the grafted resin The TG and dTG curves for Acr-g-PU-PETA samples were substantially different from the corresponding blends, and the brodened dTG peaks for photocured grafted resin suggest that there might be multiple interactions among chain segments The photocued film of the grafted resins self-emulsifying system exhibited good overall properties with polyurethane acrylate grafts ranging from 30% to 50%, and Acr-g-TPU-PETA series showed better properties than Acr-gPPU-PETA series The adhesion of the photocured film was 1～2 grade, impact strength was 50kg-cm and flexibility was 1mm The Shore hardness and the adhesion of the film decreased markedly if PETA was replaced by HEMA as photoactive group due to the lower C=C double bond content in the grafted resin The polyhydroxy amine-linked thioxanthones photoinitiators can be evenly dispersed in self-emulsifying system without color spot appearing in the dried film The films photocured with IV〓～IV〓 generally exhibited higher Shore hardness, gloss and solventresistance than that cured with Irgacure 2959 and did not induce the rusting of the iron substrate Pigmenting with titanium oxide had no effect on the photocuring The polyhydroxy amine-linked thioxanthone IV〓 and IV〓 can be new candidates for the formulation of titanium oxide pigmented photocurable water-borne coatings for their pale-yellow appearance and slight interference with the color of the coatings WB 4759 with high water-solubility coalesced and separated from the dried resin film, and even induced the rusting of iron substrate.

以丙烯酸丁酯，甲基丙烯酸-β-羟乙酯，丙烯酸及苯乙烯合成厂丙烯酸共聚树脂，并与含-NCO端基的聚氨酯丙烯酸酯接枝反应，经水性化后，得到两个系列（Acr-g-TPU-PETA和Acr-g-PPU-PETA）各5个不同配比的丙烯酸树脂接枝聚氨酯丙烯酸酯自乳化体系，粘度与水相近，为牛顿流体，固含量30％左右。光固化前干燥涂膜的玻璃化转变温度在-15℃～4℃之间，有利于室温下成膜。DSC及DMA谱表明两种树脂基本相容。Acr-g-PU-PETA的热失重行为明显不同于共混材料，接枝样dTG峰明显宽化，表明接枝样中链段之间的相互作刚有多重性，丙烯酸树脂与聚氨酯之间有一定的相容性。接枝树脂自乳化体系光固化涂层的综合性能以聚氨酯丙烯酸酯成分为50％～30％者相对较好，且以Acr-g-TPU-PETA系列更理想。光固化膜的附着力为1～2级，冲击强度为50kg·cm，柔软性多为1mm。以HEMA代替PETA作为接枝树脂的活性基团，碳—碳双键密度太低，光固化膜交联点太少，硬度和附着力均较差。多羟基胺连硫杂蒽酮光引发剂能均匀分散于树脂自乳化体系和接枝树脂干膜中，不出现色斑，光固化膜肖氏硬度一般高于以Irgacure 2959为光引发剂的光固化膜，光泽度及耐丁酮溶剂性能均有所提高，不会诱导铁基生锈，钛白着色对光固化结果几乎没有影响。本论文所合成的多羟基胺连硫杂蒽酮光引发剂IV〓与IV〓为浅黄色，对光固化涂层的颜色干扰较小，为配制钛白着色光固化水性涂料提供了新的光引发剂。水溶性太强的WB 4759在干膜中易聚结析出，且对所附着的铁基有诱导锈蚀作用。

Some of the yellows with higher intensity of colour are as rare as the pinks and blues and command unusually high prices.

一些高强度的黄颜色都是难得的蓝调与pinks高昂的价格和指挥。

Tip 5: A mirror material is very similar to Chrome: Black diffuse color, no specular highlights and Raytrace 100% in the reflection map.

提示5：镜像材质和铬材质非常像：黑色的漫反射颜色，没有反射高光已经反射贴图里的100%强度的光线追踪。

I plant production Lianhua license folder emery cloth for innovative thin folder emery cloth (weight 29 grams / square meters), optional country produced by large enterprises high-quality high-strength polyester fiber as raw materials, weaving equipment, using new high-speed rapier loom, complemented by modern sophisticated weaving technology, and give full consideration to the needs of the production pipeline for the edge of latitude and longitude lines encryption, weaving a cloth to the color white, Rally, and shells and resin with high affinity and strong and well ahead of similar products.

我厂生产的联华牌夹砂布为创新型的薄型夹砂布（克重29克/平方米），选用国家大型企业所产优质高强度涤纶纱作为原料，织造设备采用新型高速剑杆织机，辅之以现代精细织布工艺，并且充分考虑管道生产的需要进行边缘经纬线加密，织出的布以颜色亮白，拉力大，弹度高和与树脂的亲和力强而远远领先同类产品。

In other words they define the color and intensity of light reflected back when it strikes a surface.

换句话说，它可以表现出物体被光照射到而显出的颜色和强度。

The more concentrated and opaque a wine's color, the higher its intensity.

葡萄酒颜色越浓缩和不透明，强度就越高。

I would like to use this sensor and microprocessor to achieve LED color measurement and display. the design of a microcontroller system to detect LED color and intensity of the program.

我想利用这种传感器和单片机来实现LED颜色的测量和显示，设计一种单片机系统来检测LED色彩和强度的方案。

Using this technique you have a lot of control over the positioning of your lights, intensity, color, and much more, making it quite a good system to use for shadows.

使用这个技术你可以对灯光进行很多控制，位置，强度，颜色，更重要的是它提供了生成阴影的一个绝好的系统。

Since historical times,England ,where the early inhabitants were Celts, has been conquered three times .

从有历史以来，英国，在此地早期居住的是凯尔特人，已经被征服了三次。

Bluetooth OBEX File Transfer Enables the sending and receiving of files on your phone via Bluetooth.

蓝牙OBEX文件移动允许经过蓝牙传送和接受文件。。。。