长度

Study results indicate that the horizontal projection length of diagonal cracks cannot be predicted accurately when considering shear span ratio and strength ratio of longitudinal steels to stirrups separately. However the horizontal projection length can be well predicted through integrating these two influence factors due to their well representation of the entire process of diagonal cracks' occurring and development.

分析结果表明，单独考虑剪跨比和纵筋－箍筋强度比都不能很好地预测斜裂缝水平投影长度，而将两者结合能够较好地反应斜裂缝出现和发展的全过程，从而准确地计算斜裂缝水平投影长度。

The ratio of the circumference to the diameter of a circle .

圆周长度与圆的直径长度的比。装箱单三份。

Pitch is a combination number of a one-to-two ratio indicating the spline proporti******; the upper or first number is the diametral pitch, the lower or second number is the stub pitch and denotes, as that fractional part of an inch, the basic radial length of engagement, both above and below the pitch circle.

径节分数：径节分数是由两个数组成的一个比率，它表示的是花键的比例；设这个比率为A/B，则在这个分数中第一个数A表示的是花键的径节，第二个数B表示的是残余径节，径节表示的是在节圆上方的键齿在半径方向上的结合长度，残余径节表示的是在节圆下方的键齿在半径方向上的结合长度。

The results showed:（1）Accompanied with decreasing of light intensity, leaf length, width and leaf thickness of Dichondra repens increased initially and then decreased. They were up to the peak under 76.19 % transparency. The length of petiol extended with the decreasing of light intensity, but the leaf morphology of Dichondra repens was no significant effect.

结果表明：（1）随着光照强度的降低，马蹄金叶片的长度、宽度及厚度均表现出先增大后减小的趋势，在76.19％光照强度下达到最大值；叶柄长度随着光强的减弱而增长，叶片的形态并未发生显著变化。

A rubber composition for a tire improving friction performance on ice, comprising 0.5 to 20 parts by weight of a nonmetallic fiber having an average fiber diameter of 1 to 100 μm and an average fiber length of 0.1 to 5 mm, and 0.5 to 30 parts by weight of a filler having at least 2 projections and an average length of the projections of at least 10 μm based on 100 parts by weight of a diene rubber, and a pneumatic tire comprising the same.

提供了一种改善冰上摩擦性能的轮胎用橡胶组合物，以及含有该橡胶组合物的充气轮胎。一种轮胎用橡胶组合物，以100重量份的二烯橡胶为基准，还含有0.5～20重量份平均纤维直径为1～100μm并且平均纤维长度为0.1～5mm的非金属纤维，以及0.5～30重量份的具有至少2个突起并且平均突起长度至少为10μm的填料，以及一种含有该橡胶组合物的充气轮胎。

The sexual character of male youngsters were not synchronization.The penile length and dimeter were 15~18 years in park term,whichwas later than other area in our country.

不同年龄男青少年性特征的调查发现，睾丸容积、阴茎长度、喉结和腋毛、胡须的发育特征并不完全同步，我地区男青少年阴茎长度增长的高峰期在15～18岁，比我国有的地方晚一点。

The fiber length distribution of taker-in droppings and card strips under such conditions as three kinds of pin taker-in and one kind of saw-tooth taker-in at speeds of two doffer and four taker-in level are tested with roller cotton fiber length analyzer.

用罗拉式纤维长度测量仪对3种梳针刺辊和1种锯齿刺辊在二档道夫速度和四档刺辊速度的不同工艺条件下的刺辊落棉和盖板花纤维长度分布进行了检测。

To discuss the effect of pin carding plate on fiber length distribution in the card slivers,length tests to the card slivers under different carding plate gauge,taker-in speed and doffer speed using pin carding plate and saw-tooth carding plate under the card taker-in by USTER AFIS single fiber tester were done.

为探讨梳针分梳板对生条中纤维长度的影响，用AFIS单纤维测试仪，对在梳棉机刺辊下分别加装梳针分梳板和锯齿分梳板时在不同分梳板隔距、刺辊转速、道夫转速条件下所加工的生条进行长度检测。

Because the director and the length of the next guide in the maximum length between, so as result of the lateral process logistics cocks movement is not a problem, but this type of director the required tolerance, unlike the double top stem guide as strict.

因为上导向器和下导向器之间的长度位于最大长度，因此由于工艺物流造成的侧向旋塞运动不是一个问题，而且这种类型的导向器所要求的容许偏差，不像双顶部阀杆导向器的那样严格。

The experimental apparatus consist of L-valve and downcomer made by the transparent Plexiglas columns, 80 mm i.d.

本实验采用循环式流体化床，使用内径 80mm 之压克力圆管，制成水平长度为 380 mm 之 L-valve 和长度为 1120mm 之下降管。

Chrysanthemum of 10 thousand birthday is lax to edaphic requirement, with the arenaceous qualitative loam with fecund, good drainage had better.

万寿菊对土壤要求不严，以肥沃。排水良好的砂质壤土为好。

He unstepped the mast and furled the sail and tied it.

他拔下桅杆，把帆卷起，系住。