配合量

An approach by applying the capacitance-sensing principle to measure the interior vertical profile of a high aspect ratio micro part, such as a hole with 1.0mm diameter, is proposed and implemented.

本论文提出一新型、结构简化之电容感测式探针，配合自行开发的量测系统进行具有高深宽比特徵的微孔垂直轮廓量测。

In part one, the properties of catalysts such as iodine, platonic complex, transitional metal oxide and vanadium-containing heteropolyacid were studied in oleum and the process conditions were also analyzed.

催化剂开发中，制备了系列铂配合物催化剂和含钒杂多酸系列催化剂，并对制得的含钒杂多酸系列催化剂进行了XRD、IR、TG表征，确证了催化剂的组成、结构等，考察了催化剂中含钒量不同的催化剂其催化性能与含钒量的关系。

This study refers to the conditions of practical powder metallurgy manufacture process, and proceeds to experiments and gear precision measurements as well as investigation on the effects of two parameters, powders and pitch circle radius, on gear precision. The relationship between gear parameters and gear surface deviations was derived from the mathematical model for the involute helical gears and the analysis of gear surface deviations.

本论文将采用实际上粉末冶金螺旋齿轮的制程条件，进行试作实验与齿轮精度的量测，以探讨粉末及螺旋齿轮之节圆半径这两个制程参数对於齿轮精度的影响；同时应用齿轮创成原理所推导之螺旋齿轮数学模式，配合齿面变异分析，求得齿轮设计参数改变量与齿面变异量之关系。

And to verify the blood flow rate measurement system, we design a verifying experiment. By using hydraulic system to generate the test flow, we complete the engineering verification of the multi- functional sphygmograph blood flow rate measurement system.

此外，为改善现有线性弹性管血流量公式，并配合非线性动态血液顺应性，本研究推导一非线性血流量公式，同时建立测试流量产生平台，来产生此量测模式所需之测试流量，并建立测试实验来验证此一量测模式之可行性。

In order to analyze the airborne LiDAR data corresponding to single trees and stand heights in the forestry area, we set up samples to measure tree heights of Alnus formosana, Cryptomeria japonica, and Chamaecyparis formosensis in the Alishan area. We build the Canopy Height Model based on the data from the airborne laser scanning system. Single Tree heights were estimated by averaging the CHM values within a 0.5m radius, and six different sizes of sample stands (5×5, 10×10, 12.5×12.5, 15×15, 17.5×17.5, and 20×20) were set up to extract the average heights within the area as the calculated value.

本研究於阿里山地区设置样区，针对台湾赤杨、柳杉、红桧等树种进行立木树高之量测，配合该样区之空载光达影像资料，建立树冠高度模型(Canopy height model， CHM)，探讨空载LiDAR在森林地区对於单木树高与林分高的量测情形；单株立木高系以样区立木位置为中心，萃取0.5 m 圆形环框范围内之CHM平均值为其推估值；光达林分高则以6种林分面积(5 m×5 m、10 m×10 m、12.5 m×12.5 m、15 m×15 m、17.5 m×17.5 m、20 m×20 m)萃取范围内之CHM平均值为其推估值。

The proportion of liquid to solid should be above 6:10 for high conidial yield. The maximum conidial yield was 28.9×10^8 spores/g when inoculation proportion of liquid to solid was 8:10.

玉米粉和麦麸组合是该菌的良好营养源，与不同载体配合均可使产孢量达到20×10^8孢子／g以上；以小米提供营养的不如麦麸加玉米粉，当小米与载体的质量比大于3：1可获得15×10^8孢子／g的产孢量。

The operation parameters include different starfruit weight, flow rate, extraction time, extraction pressure, extraction temperature, different addition volume of ethanol cosolvent, ethanol concentration and other extraction way.

以杨桃量、泄压流速、萃取时间、萃取压力、萃取温度、共溶剂乙醇的添加量与不同萃取方式等为操作变因，配合一次一变因法来进行探讨，以找出最佳萃取条件。

It was observed that not only histidine, but also histidine-Co and histidine-Ni could induce and substitute some Cu and Zn from Cu_2Zn_2SOD, eventually influence the activity of this metalloenzyme. Histidine- metal ion complexes have stronger ability than histidine to displace the bound metal ion from SOD. In addition, the amount of foreign metal ion binding to the SOD was less than that of metal ion lost from SOD. It obviously means that there was apoenzyme in the solution.

实验结果表明： Cu2Zn2SOD酶不仅与组氨酸，而且还可以与组氨酸－CoⅡ）和组氨酸－Ni(Ⅱ相互作用，Cu2Zn2SOD酶中的部分Cu和Zn被诱导和置换出来，并相应地影响了酶的活性；组氨酸－金属离子配合物的作用比组氨酸强，酶活性降低也更明显；酶中结合的外来金属离子的量比从酶上被诱导和顶替下来的金属离子的量要少，说明在溶液中有脱辅基酶的存在。

Bush and stern tube to meet the Fit, over surplus of about 0.05mm.

衬套与艉管的配合为过盈配合，过盈量约为0.05mm。

Differential scanning calorimetry and polarizing microscope were used to probe the liquid crystal properties of the serial complexes.

采用差示扫描量热法和偏光显微镜研究了该系列配合物的液晶性能，发现8个配合物具有液晶性。

Since historical times,England ,where the early inhabitants were Celts, has been conquered three times .

从有历史以来，英国，在此地早期居住的是凯尔特人，已经被征服了三次。

Bluetooth OBEX File Transfer Enables the sending and receiving of files on your phone via Bluetooth.

蓝牙OBEX文件移动允许经过蓝牙传送和接受文件。。。。