胶合的

These theories are agglutinate, reduplicate and can be combined as a whole with a uniform research platform or learning frame.

这些理论在很大程度上是胶合的、重复的，是可以构建一个统一的研究平台或学术框架加以整合的。

This will help in aligning a piece to be glued on the back.

这在排列将帮助在后面将胶合的片断。

When the distance kept increasing beyond 15 mm, the bond strength continued to decrease, and reached the lowest point of 1.11 MPa at the distance of 40 mm.

相距15 mm时板的胶合强度最大（1.71 MPa），距离为40 mm时胶合强度最小（1.11 MPa）。

Most of optic a l systems consist of a number of singlet a nd doublets, of which the singlet c a n be considered a s a speci a l doublet.

摘要大多数光学系统都是由若干单透镜和双胶合透镜组成的，单透镜可以看成是双胶合透镜的特殊情况。

This article will help with the production, design and construction of glued laminated timber structure.

本论文的研究结果对我国自行生产胶合木以及设计、建造胶合木结构具有一定的现实意义。

Then the light intensity transmission of polarizing prisms with the incidence of random spatial light beam is studied. Both experimental and theoretical results indicate that the light intensity transmission of air-spaced polarizing prisms are affected more by the change of random spatial incident angle than dielectric-spaced polarizing prisms.

结果表明：胶合层间的多光束干涉对棱镜光强透射比的影响不可忽略，对于空气隙型偏光棱镜，由于空气隙间多光束干涉的影响，光强透射比随任意角度变化较大，而用胶合介质胶合的棱镜，其透射比对空间入射角不是很敏感。

The main reason why quarter-sawn board of Birch had smaller dry compressing shear strength than flat-sawn board of Birch in normal conditions was that Birch had different shear strength to the grain between quarter-sawn board and flat-sawn board. Meanwhile xylary rays in flat-sawn board were transversely cut and left a lot of pores in the flat-sawn board, so adhesive can enter these pores and turn into adhesive nail. While these pores provided a kind of tunnel for water, so cause this phenomenon that wet compressing shear strength of flat-sawn board of Birch was smaller than that of quarter-sawn board of Birch. The possible reason why quarter-sawn board of Oak had greater dry compressing shear strength than flat-sawn board of Oak in normal conditions was that ratio of springwood on quarter-sawn board and flat-sawn board was different.

造成柞木径切板的常态压缩剪切强度比弦切板的常态压缩剪切强度大的主要原因是，在径切板和弦切板上早材胶接的比例不同，径切板的胶合强度试件上早材胶接的比例相对少，而弦切板的胶合强度试件上早材胶接的比例比径切板的胶合强度试件上早材胶接的比例相对大，由于早晚材胶接过程中强度决定于早材，这部分胶接强度比较低，这就使得柞木径切板的常态压缩剪切强度比弦切板的大；同时在柞木弦径面胶接过程中由于实际胶接面积的不同也能造成弦径面上API胶粘剂与之形成的化学键的数量不同，这也是造成柞木径切板的常态压缩剪切强度比弦切板的大的原因之一。

The critical scuffing temperature of friction pairs is not constant and changes with the friction pair operational conditions.

本文研究的成果可用于摩擦副临界胶合的计算，指导摩擦副胶合设计，指导添加剂和润滑油的设计，并为工程选用添加剂提供理论及试验依据。

The abrupt change in temperature is one of the main characteristics in scuffing. Studies have showed that friction pair temperature plays an important role in scuffing.

温度突变是胶合发生的主要特征之一，有关研究表明摩擦副温度对胶合发生起着重要作用，因此，从摩擦副的温度来着手研究胶合现象是胶合研究领域的一个重要方向。

Card board / Pallet (mainly cards have glue boards and logs, pallets) as a modern enterprise, relying on manual handling products have passed the age, it is now stresses "fast","prospective","stable", most of the use of mechanical handling of goods , this card on the board and ultimately, according to different requirements, the use of different prices for different weights and different logs into boards and laminated card board cards.

卡板 /栈板（主要有胶合卡板和原木卡板）作为现代企业，靠人工装卸产品的年代已经过去了，现在是讲&快&、&准&、&稳&，大多采用机械搬运货物，这样卡板就少不了，根据要求不同、使用不同、价格不同以及承重量不同分为原木卡板和胶合卡板。

Graf, without question, is the greatest women's player in history.

格拉芙，现在，毫无疑问是女子网坛历史上最伟大的选手。

If not, you will have to look around at all your important data.

如果没有，您将需要检查所有的重要数据。