粘着的

Of, relating to, or being a language in which words are formed primarily by means of agglutination .

粘着法构词的关于，属于或作为一种其单词最初是由粘着法构成的语言的

Manchu language already changed into analytic language,while Oroqen remains agglutinative.

满语和鄂伦春语同属阿尔泰语系满—通古斯语族，但由于分化的年代久远，两种语言的类型已经有了差异，满语从粘着语逐渐走向分析语，而鄂伦春语仍然是典型的粘着语。

Further study of this paper has shown that reason for"camel peak"phenomenon in the adhesion-creep test curves is difference between sliding-and static coefficient of friction and discussed the analytic formulae for line contact as well as one direction slip and special correction Lemk's method for point contact when their change is considered as stage jump function.

通过进一步的理论研究指出造成轮/轨粘着率与弹性滑移率实验曲线呈"驼峰"状的原因是滑动区和粘着区的动、静摩擦系数变化，给出了当它们为阶跃变化时线接触条件下的解析解和对点接触情况的独特的"修正"Lemke算法。

Firstly, the wheel-rails adhesion during braking is researched, and the optimal adhesion is proved to be existed at the inflexion point of speed.

在本文中，首先研究制动过程中轮轨间的粘着分析，指出轮轴速度曲线的拐点即是粘着最佳位置。

The adhesion wear of the coatings is somewhat different from the sintered or cast materials, which could be explained in terms of interlamellar cracking and flaking off of lamellae.

涂层的粘着磨损显示出不同于块体材料的粘着磨损的特点，表现为粘着力引起涂层层间裂纹扩展和层状颗粒剥离。

The Ti_3SiC_2-SiC multiphase ceramic were fabricated by in situ synthesis under hot isostatic pressing.The examinations indicate that,the dominant wear mechanisms change with load increasing under unlubricated conditions,it is main abrasive wear under low load,and it is main adhesion wear under high load.Lubricating oil improves the friction coefficient and wear rate of Ti_3Si...

结果表明：干摩擦条件下随载荷的变化，占主导地位的磨损机制将发生变化，在低载荷下以磨粒磨损为主，高载荷下以粘着磨损为主；同干摩擦相比，润滑油对摩擦副的摩擦磨损性能的改善均很显著；Ti3SiC2/SiC复相陶瓷的磨损主要由粘着和微断裂引起的。

To master fluid mosaic model of cell membrane;peripheral proteins and integral proteins;the type of extracellular matrix;Collagen;glycosaminoglycan and proteoglycan;elastin; Occliding junctions;anchoring junctions;desmosome hemidesmosome、the structure and function of adhesion belt and focal adhesion;cell coat;cadherins;selectin;Ig-superfamily; integrins

掌握生物膜的流动镶嵌模型；膜周边蛋白和膜内在蛋白；细胞外基质的类型；胶原纤维；糖胺聚糖和蛋白聚糖；弹性蛋白；封闭连接；锚定连接；桥粒与半桥粒、粘着带与粘着斑的结构与功能；细胞外被；钙粘素；选择素；免疫球蛋白超家族；整联蛋白

The results show that, for the elasto-plastic contact of tip-substrate approach and separation process, the material plastic yielding in the atomic level is still governed by the von Mises criterion. For the adhesion of flat-ended wedges, continuum mechanics can be still applied down to a few lattice constants within the contact region, and give reasonable results, apart from the discrepancies near the contact edges. Moreover, adhesion hysteresis occurs during unloading due to the atomic steps, where the unloading curve does not coincide with the loading one. This in turn supports the presumption proposed by Pollock for the adhesion of stepped spheres.

本文首先对针尖—基体模型的弹塑性接触机理进行了深入研究，指出在原子水平上材料的塑性屈服仍由Von Mises准则控制；对平底锥冲头粘着接触的模拟表明，除了在接触区边缘附近有一定差别外，接触力学方法在接触区内几个晶格常数范围内仍能给出令人满意的结果；由于原子台阶效应，加载与卸载曲线不重合，出现粘着滞后，证实了Pollock关于具有纳米阶梯结构的球体粘着滞后现象的推测。

A thin layer of water between the mica surfaces increased the pull-off force three fold comparing with the dry contact.

在粘着研究中，法向分离力(pu ll-off forces)是衡量粘着强度的重要标准，准确地捕捉分离力的值和变化规律对于研究微观接触力学和粘着行为都具有十分重要的意义。

EDAX and talysurf. There were four wear regimes for KRF/GCI, during the starting friction period abrasion was dominant, when the process of the formation and break of transfer layers was balanced the main wear mechanisms were adhesion and fatigue, mild melt wear was found at higher temperature. For KRF/MMC, the dominant wear mechanisms were ploughing and microcuting during the running-in, when transfer layer formed, the film-film adhesion at the interface became dominant and mild melt wear occurred also at high temperature.

对于KRF/GCI，在摩擦的起始阶段主要是二体磨粒磨损，当表面转移膜的形成与破坏形成动态平衡时，粘着磨损和疲劳磨损是主要磨损机理，摩擦表面温度较高时，产生严重的粘着磨损和轻微的熔融磨损；而KRF/MMC在跑合过程中，SiCp对较软材料的犁削、微切削是主要摩擦磨损机理，转移膜形成后，表面的膜—膜粘着则为主要摩擦磨损机理，高温下也会发生轻微的熔融。

Objective: To study the effect of polycythemia on blood oxygen saturation.

裴蕾目的：观察RBC剧增而引起的高粘血症对血氧饱和度的影响。

Based on SIMPLER algorithm in the curvilinear body-fitted coordinates, the calculations were performed for Pr=0.7, Re=10~1000 on non-orthogonal non-staggered grids which are generated by elliptic equation systems.

采用曲线坐标系下压力与速度耦合的SIMPLER算法，数值研究了周期性渐扩渐缩波纹通道内脉动流动与换热情况，流动Re数的范围为10~1000，Pr数为0.7。