程序块

The absolute storage address of the beginning of a ''.

一个程序或数据块开始的绝对存储器地址。

In this paper we introduce a finite element program design method for solving 3 D thoracic electrical field distribution,based on Borland C++ for DOS and using isoparametric element of arbitrary hexahedron.In the process of solving final finite element equation,this paper uses the method of blocking and 'getting big number' to deal with total coefficient matrix and boundary conditions.

本文介绍了一种采用等参数8节点任意六面体单元来求解人体胸腔三维恒定电场分布的有限元程序设计方法，程序的编制基于BorlandC＋＋ForDOS的编程环境，在对最终形成的有限元代数方程的求解过程中采用了分块处理总系数矩阵及"取大数"处理边界条件的方法。

TL084MJ Pinout: 3.3V Operation with 5V Tolerant Buffers ACPI 1.1, PC99/PC2001 Compliant LPC Interface with Clock Run Support Serial IRQ Interface Compatible with Serialized IRQ Support for PCI Systems 15 Direct IRQs Four 8-Bit DMA Channels ACPI SCI Interface nSMI Shadowed write only registers Internal 64K Flash ROM Programmed From Direct Parallel Interface, 8051, or LPC Host 2k-Byte Lockable Boot Block Can be Programmed Without 8051 Intervention Three Power Planes Low Standby Current in Sleep Mode Intelligent Auto Power Management for Super I/O ACPI Embedded Controller Interface Configuration Register Set Compatible with ISA Plug-and-Play Standard (Version 1.0a) High-Performance Embedded 8051 Keyboard and System Controller Provides System Power Management System Watch Dog Timer 8042 Style Host Interface Supports Interrupt and Polling Access 256 Bytes Data RAM On-Chip Memory-Mapped Control Registers Access to RTC and CMOS Registers Up to 16x8 Keyboard Scan Matrix Two 16 Bit Timer/Counters Integrated Full-Duplex Serial Port Interface Eleven 8051 Interrupt Sources Thirty-Two 8-Bit, Host/8051 Mailbox Registers Thirty-six Maskable Hardware Wake-Up Events Fast GATEA20

TL084MJ引脚说明： 3.3V工作电压为5V容错缓冲器的ACPI 1.1，PC99/PC2001符合LPC接口与时钟运行支持-兼容串行接口与串行的IRQ IRQ的支持PCI系统- 15直接的IRQ - 4个8位DMA通道- ACPI的SCI接口- nSMI -阴影只写寄存器内部的64K的Flash ROM -直接从程序并行接口，8051，还是LPC主机-的2K字节可锁定引导块-可在不干预程序8051三力飞机-低待机电流在休眠模式-智能型自动电源管理的超级I / O的ACPI嵌入式控制器接口配置寄存器设置兼容的ISA拆开的播放标准（版本1.0a）高性能嵌入式8051键盘和系统控制器-提供系统电源管理-系统监视狗定时器- 8042型主机接口-支持中断和轮询访问- 256字节数据RAM -片上存储器映射控制寄存器-获取实时时钟和CMOS寄存器-最多16x8矩阵键盘扫描- 2个16位定时器/计数器-综合全双工串行接口- 11个中断源8051 - 32个8位，Host/8051邮箱寄存器- 36个可屏蔽硬件唤醒事件-快速GATEA20

The contents of the course include: what operating system are, what they do, how they are designed, and where they came from; a general history and explanations of computer system, and some discussion on hardware and the relation between operating system and other software; concept of process, process states and process control block, process queue, management of processes; concepts of sequent programming and parallel programming, process synchronization and its application, process communication; scheduling level and job state transition, job scheduling, process scheduling, and methods for scheduling; deadlock and its necessary conditions, deadlock prevention, control and recovery of deadlock; fixed partition, multiple partition and replacement partition memory management, swapping and overlays; page, segmentation and segmentation with paging storage management, basic concept of virtual memory management, and page, segmentation and segmentation with paging memory management.

课程的内容包括：计算机系统概述、操作系统的形成、发展、功能、特性、类型和发展趋势；操作系统的硬件环境、操作系统与其它系统软件的关系；进程的概念、进程的状态和进程控制块、进程队列、进程的管理；顺序程序设计和并行程序设计概念、进程间的同步与互斥、同步机构应用、进程间通信；调度的层次和作业状态转换，作业的调度、进程调度、调度算法；死锁问题的提出、死锁的必要条件、死锁的预防、避免、控制和恢复；固定分区、可复分区、多重分区内存管理技术以及覆盖技术和交换技术；分页域、分段域、段页域存储管理技术、虚拟存储管理的基本概念、分页域、分段域、段页域虚拟存储管理。

In our article looking at XBOX 360's graphics processor, the ATI Xenos, we saw the first implementation of a unified shader core, whereby both Pixel Shader programs and Vertex Shader programs are executed over the same hardware block, as opposed to having separate vertex and pixel shader engines – its expected that ATI's PC graphics accelerator for DirectX 10 will also feature a unified shader architecture and NVIDIA are now talking about such a platform (having initially said that they believe separate discrete units would be more optimal in terms of processing performance).

ATI Xeons， XBOX 360的图形处理器，第一块采用统一着色核心的产品。为什么顶点着色程序和像素着色程序都在同一硬件上完成，而不是分别采用顶点着色引擎和像素着色引擎？预期ATI对应于DirectX 10的PC图形加速器也将以统一着色架构为特色。NVIDA现在也在研究这样的平台（起初声称分开的离散单位在处理表现上会更理想^。^）。

Based on the experience of compiling the program, the paper discussed some topics which should been taken note of while compiling a plane member structure FEM program that took the geometric nonlinearity into account as well as the material nonlinearity. With this program, the paper analyzed the effect of the factors on the anti-bending capability of externally prestressed concrete beams and come into some useful conclusions. The factors included: the rate of ordinary steel bars, the initial prestress of the external tendons, the shape of the external tendons, the position and number of deviators and the number of segments.

结合编程实践，本文讨论了编写考虑几何非线性和材料非线性的平面杆系有限元程序应该注意的一些问题，并应用所编的程序，对体外预应力混凝土梁的抗弯性能进行了普通钢筋配筋率、体外索的初始张拉力、体外索的配筋形式、转向块的布置和节段的数目等五个影响因素的分析，得出了一些有益的结论。

The flexural capacity, deformation and failure modes of beams with different parameters can be analyzed using the program, such as types of plan and prestressed tendons(extrenal prestessed tendons, internal unbonded prestressed tendons, internal bonded prestressed tendons), jacking and effective stress in external prestressed tendons, configuration of the deviators, properties of tendon, ratio of span to effective depth of the beam and load pattern, initial loading state at tendon jacking, etc.(3) Nonlinear behaviors of the concrete beam prestressed with external or internal unbonded tendons were studied by the program developed.

本程序可以对任意截面型式的预应力(体外预应力筋、体内无粘结预应力筋、体内有粘结预应力筋)混凝土梁和普通钢筋混凝土梁进行非线性全过程数值分析计算，程序可以就转向块的布置方式、体外预应力筋纵断面形状、体外筋有效预应力的大小及材性、张拉预应力筋时梁的持荷状态等因素对体外预应力混凝土梁在外荷载作用下的强度、变形特征、破坏模式等的影响进行分析研究。

Fully automatic burn free block machine adopt PLC control system, it can set the various actions through adjust the flow, press etc technique parameters by touch screen,, achieve machine-human talking, the control system mainly included three units,(1) fully automatic batching and mixing control system (2) brick forming machine, pallets transferring control system (3) stacking block machine control system

全自动砌块成型免烧砖机PLC控制系统；切块成型机的全过程采用PLC智能控制，可通过触摸屏设定各个动作的流量、压力等技术参数，实现理想的人机对话。控制系统主要包括3个控制单元组成：（1）配料搅拌全自动程序控制系统，（2）成型主机、运输板机、升、卸板机自动程序控制系统，(3)码垛机控制系统。本系统的电器元件均为进口的品牌产品，如日本三菱、欧姆龙、德国西门子等，性能可靠，故障率低。

Such parameters as the percentage of ordinary reinforcment, amounts and configuration of unbonded prestressed tendons, the ratio of span to depth and the loading patterns were considered. Based on the results, the fomula for the eqivalent length of deformation zone on the beams at ultimate were developed. A simple formula was developed for the ultimate mid-span deflection of concrete beams with concept of equivalent length of deformation zone, and the deformation of beam before internal reinforcement yielding was predicted by the traditional formula for the deformation of partically prestressed concrete beam. Then an analytical model was deduced for analyzing the ultimate stress increment in those concrete beams prestressed with external or internal unbonded tendons based on the mid-span deflection.(4) Testes were carried out on a thin-walled concrete box beam presressed with external CFRP tendons to study its short-term performances under uniform load, long-term behaviors under uniform load, and full-time performance under four-point load in turn.

3以体内非预应力钢筋配筋率、体外预应力筋配筋率、体外预应力筋布置形式、预应力度、跨高比、荷载形式等为参数，用非线性分析程序对体预应力筋混凝土梁进行了参数分析，依据分析结果提出了以综合配筋指标和预应力度为参数的等活动房效变形区长度的计算公式，进而提出了基于等效变形区长度的极限挠度计算公式；体内非预应力钢筋屈服前的挠度计算采用常用的部分预应力混凝土梁挠度计算公式；依据试验和非线性数值计算结果，将不同转向块布置形式的体外预应力混凝土梁简化为跨中一个转向块的体外预应力混凝土梁，推导了基于跨中挠度的体外预应力筋应力增量的简化计算公式。

BLK. You can select a vertical block or "column" of text that is separated by spaces or tabs (as you might see in text pasted from e-mails, program listings, or other sources), using OOo's block selection mode.

您可以使用OOo的的块选择模式，选择由空格或制表符分隔的垂直文本块或&一栏&的文本（如你可能复制于电子邮件、程序清单、或其他来源的文本）。

Further more, the simplified analysis method on stressed-skin effect of corrugated steel sheet is also discussed in detail.

此外还比较详细地探讨了蒙皮效应的简化分析方法。

If I had known her telephone number,I would have called her.

要是我知道她的电话号码，我就打电话给她了。