涂胶的

Then the paper deduced the quench development characteristic of MgB2 tape by all the above study. The work environment cooled by GM cooler is an adiabatic environment. However the environment cooled by liquid helium is incomplete an adiabatic environment. In order to simulate the adiabatic environment, the tape was remodeled as follows. The tape is bundled by vitreous riband in half pile mode, and the angle of the tape and the riband is 45 degree. Then use cryogenic epoxy hardener to coat the surface of the riband.

上述的三个工作环境中，制冷机传导冷却工作环境是绝热工作环境，而后两者并非是绝热工作环境，为了模拟带材的绝热工作环境，对带材作如下处理：用玻璃丝带对已固定好电压引线的带材以半叠包的方式缠绕一圈，玻璃丝带与带材成45度夹角，然后用低温环氧胶均匀涂抹在玻璃丝带的表面，随后用烘箱烘烤已涂匀环氧的带材18-24小时，最后取出带材直到低温环氧完全固化。

Methods The 3-5 generation fibroblasts were inoculated in 24-well with rat-tail collagen. A denuded area was made when the 3 generation of the fibroblasts was influent into a monolayer. Cells were then exposed to the presence of various concentrations of viper venom, mitomycin C, and the cells migrated into the denuded area were counted evely 6 hours.

将培养的第3~5代人结膜下成纤维细胞接种于涂有鼠尾胶原的24孔板中，待细胞生长融合后在培养板上划线，造成无细胞的裸露区，分别加人不同浓度的蛇毒制剂、丝裂霉素C及二者的混合液，每6h观察记录移行至裸露区的细胞。

In comparison with the conventional method of coating on the tool surface, carbide powders were coated with boehmite sol when dispersed in the mixture of boehmite sol and ethanol. The coated powders were then dried, separated, and hot-pressed. The sol preparation techniques were optimized in experiments and the property of the sol was studied at the same time.

本文从提高硬质合金刀具的耐磨性、探索新型刀具涂层方法入手，突破了在刀具表面进行涂层的传统方法，提出了用溶胶－凝胶法在硬质合金碳化物粉末表面涂覆一薄层氧化铝陶瓷制成复合粉末，然后热压制备刀具材料的新方法，开发成功一类新型的陶瓷涂层硬质合金复合刀具材料。

Since historical times,England ,where the early inhabitants were Celts, has been conquered three times .

从有历史以来，英国，在此地早期居住的是凯尔特人，已经被征服了三次。

Bluetooth OBEX File Transfer Enables the sending and receiving of files on your phone via Bluetooth.

蓝牙OBEX文件移动允许经过蓝牙传送和接受文件。。。。