扳手

Screw torque wrench should be control led early, early completion of the screw bolts should be well marked for confirmation.

初拧扳手应是可以控制扭矩的，初拧完毕的螺栓，应做好标记以供确认。为防止漏拧，当天安装的高强螺栓，当天应终拧完毕。

Multi-Axial Crosslink Plate, the midline screw is tightened using SW5.5 Wrench (11302017)after the

如果使用活动横联装置，拧紧两边的横连顶丝后再用SW5.5扳手

Bearing and shaft fastening methods are: the outer sleeve with eccentric spherical bearing, the eccentric sets Presentation at the bearing inner ring of the eccentric stage, along the axis of rotation direction of tightening eccentric sleeve, and then wrench tighten the screw Hexagon eccentric sleeve on the set screws can be.

轴承与轴的紧固方法是：对带偏心套的外球面轴承，将偏心套套在轴承内圈的偏心台上，沿轴的旋转方向拧紧偏心套，再用内六角螺钉扳手拧紧偏心套上的紧定螺钉即可。

Screw torque wrench should be controlled early

初拧扳手应是可以控制扭矩的沉头内六角螺栓，初拧完毕的螺栓，应做好标记以供确认。

The positions of the contact pins may be regulated precisely with one regulating tool and one spanner to screw corresponding screw bolts.

各插针的位置可通过一调整工具和一扳手旋动相应的螺柱来精确地调校。

Use hexagonal spanner to screw the screw off, and take out the used and scrap cutting knife.

用六角扳手拧开螺丝，取出废旧裁切刀。

TOHNICHI: screw driver, spanner, torque meter, torque tester.

东日： 扭力起子、起力扳手、扭矩表、瓶盖扭力测试仪。

The post of the screw is attached to the hex end

螺钉杆部和GSS III上钉扳手的六角头

Mounted coupling: first in the motor shaft mounted on the head ring, mounted on coupling half, and then in the shaft coupling client and loaded block chute and Plum wrench tightening bolts (lifting shaft 3 ~ 5 mm and to provide mechanical seal prestressed); and then loaded up the other half on the coupling screw Hexagon screw must be tightened.

装联轴器：先在电机轴头上装上挡圈，装上一半联轴器，再在泵轴端和联轴器槽内装上挡块并用梅花扳手拧紧螺栓（吊起泵轴3~5毫米并提供机械密封预应力）；再装上另一半联轴器拧上内六角螺钉必须拧紧。

Mounted coupling: first in the motor shaft fitted with ring head, fitted with coupling half, and then end in the shaft and the coupling block bed fitted with Plum wrench tightening bolts (lifting shaft 3 ~ 5 mm and pre-stressed mechanical seal); and then loaded onto the other half of the coupling screw Hexagon screw must be tightened.

装联轴器：先在电机轴头上装上挡圈，装上一半联轴器，再在泵轴端和联轴器槽内装上挡块并用梅花扳手拧紧螺栓（吊起泵轴3~5毫米并提供机械密封预应力）；再装上另一半联轴器拧上内六角螺钉必须拧紧。

Since historical times,England ,where the early inhabitants were Celts, has been conquered three times .

从有历史以来，英国，在此地早期居住的是凯尔特人，已经被征服了三次。

Bluetooth OBEX File Transfer Enables the sending and receiving of files on your phone via Bluetooth.

蓝牙OBEX文件移动允许经过蓝牙传送和接受文件。。。。