引出的

To explore more efficient ion extraction methods used in atomic vapor laser isotope separation, RF resonance method of ion extraction is studied by theory and PIC simulation.

为了探索用于AVLIS的更为有效的离子引出方法，对等离子体的RF共振离子引出方法进行了理论研究，用PIC方法对其进行了模拟。

To study the effects of factors such as electromagnetic field and electron temperature on the ion extraction characteristics (extraction time, collision loss ratio) in atomic vapor laser isotope separation, 2-D electron-equilibrium model was used to analyze and simulate the ion extraction process.

为研究各因素对原子蒸气激光同位素分离中离子引出特性的影响，采用二维流体理论电子平衡模型分析计算了引出过程中外加恒定电磁场和电子温度等因素对离子引出特性的影响。

Simplier and more efficient ion extraction methods for atomic vapor laser isotope separation AVLIS were evaluated using a 2-D electron-equilibrium model to compute and compare three electrostatic methods the parallel electrode method, the Π type electrode method, and the improved M type electrode method.

为探索用于原子蒸气激光同位素分离AVLIS的简单有效的离子引出方法，用二维流体理论电子平衡模型计算比较了3种静电场方法平行板电场法，Π型电极法，改进M型电极法计算发现，二维流体理论电子平衡模型并不能很好地描述Π型电极法对另外两种静电场方法，计算了不同外加电压、不同的初始原子密度和不同的目标同位素丰度等条件下的离子引出情况从计算结果可以看出，改进M型电极法不论是从离子引出时间还是从碰撞损失率，都要比平行板电极法好得多当外加电压较高或初始原子密度较高时，这种好处就更加明显因此，改进M型电极法是一种可供实际采用的比较好的静电场方法

Electrothermal pipe ""-shaped opening for the two lead electrodes, the bottom plate from the heat extraction.

电热管的""形开口处为两根引出电极，从发热盘的底部引出。

The course introduces the concept of electric field through the localization of Coulomb force of charges.

本课程从电荷库仑力的定域化引出电场，再结合运动电荷的相对论理论引出磁场。

Thus, once we have the first derivative, we get all higher derivatives free.

因此，一经我们有那第一的引出，我们免费获得所有的较高的引出之物。

The threshold and latency of CDM-CEP was 85±3.54 dB and 6.59±0.41s in normal control group,90±5.0 dB and 6.68±0.31 s in artificial perilymph group,but could not induce CDM-CEP at 120dB level still in neomycin group.

在短声刺激下，正常大鼠引出CDM-CEP的阈值为85±3.54 dB，阈值时的潜伏期为6.59±0.41s；新霉素组大鼠120dB仍无法引出CDM-CEP；人工外淋巴液组大鼠引出CDM-CEP的阈值为90±5.0dB，阀值时的潜伏期为6.68±0.31s。

In this dissertation, InGaAs/InGaAsP/InP MQW microdisk laser and its characterization were presented. Some conclusions are as following: the characteristics of lasing threshold was discussed by using rate equation. The dependent relations between threshold and cavity volume, spontaneous emission coupling efficiency β were investigated. The whispering gallery mode and spontaneous emission in a microdisk geometry were then studied. Almost all spontaneous emission was coupled into the lowest order TE mode when the normalized thickness of photonics well was between 0.15 and 0.5. The design principle and device process of InGaAs/InGaAsP/InP MQW microdisk laser were presented. The microdisk lasers with the diameter of 8μm, 4. 5μm and 2μm were succesfully fabricated by using etching techniques. The pulse lasing thresholds for the microdisk with the diameter of 8μm and 4. 5μm were 170μW and 15μW, a record results compared with the published in the literature. The cw lasing threshold for a 2-μm-diameter microdisk was only a few μW. We haven't found similar report up to now. To solve the problem of directional output in a microdisk laser, the power coupling efficiency in a double disk geometry was investigated with the theory of waveguide mode couple. A new structure of electrically pumped microdisk laser with output waveguide was designed, making a foundation for the practical use of microdisk laser.

本文主要研究InGaAs/InGaAsP/InP多量子阱半导体碟型激光器的研制和特性表征，并取得如下结果：利用速率方程理论讨论了激光器激射阈值的特性，分析了阈值与腔体积和自发发射耦合系数β之间的关系；讨论了微碟光子阱结构中的自发发射特性和微碟中WGM模式特性；光子阱结构在其归一化厚度在0.15-0.5之间时，几乎全部自发发射进入到最低阶TE模式中；研究了InGaAs/InGaAsP/InP多量子阱微碟激光器的结构设计原理和器件的制备工艺；利用刻蚀方法成功制备出直径分别为8μm、4.5μm、2μm的碟型微腔激光器；直径8μm和4.5μm的微碟脉冲光泵浦激射阈值分别为170μW、15μW，是目前所见文献报导中比较低的；直径2μm的微碟连续光泵浦激射阈值仅几μW，目前尚未见到达到类似结果的研究报导；为解决微碟激光器激射光定向引出的问题，通过波导耦合模理论分析了双层碟之间功率耦合效率；据此设计了新型带耦合输出波导的电泵浦微腔激光器，为进一步研制可实用的电泵浦微腔激光器打下基础。

Some technical problems arose during the debugging of the accelerator. The ion source did not produce arc. The accelerator tube cracked. The control system was out of order. The transporting capacity of the charge belt degraded. The corresponding reasons were analyzed and some measures were adopted to solve the problems. The drawing voltage was raised to its predetermined position after the ion source produced arc and should be reduced to zero before turning off the accelerator. Transition flange was lathed and the accelerator tube was re-assembled. The control equipment at high voltage was shielded. TVS diodes were installed at the input and output ends.

调试中出现了离子源不起弧、加速管破裂、控制系统失灵和输电带输电能力降低等技术问题，分析了出现这些问题的原因，然后分别采取了相应的措施加以解决：变换工作流程，在每次关机前先把引出电压降为零，开机时等离子源起弧后再把引出电压升到预定值；对过渡法兰进行车加工，重新封装；对高压端的控制设备采取屏蔽措施，在输入、输出端使用TVS二极管，对控制软件进行抗干扰设计；对绝缘气体进行循环干燥等。

Influences of the errors such as jitter time between the kickers, deviation of the integrated magnetic field etc.

回顾了圆形加速器中的各种注入、引出方式，讨论了同注入引出系统相关的新技术。

At the rear was an innovative combination transaxle with the gearbox, clutch, differential, and inboard-mounted drum brakes.

在后面是与变速箱，离合器，差的创新结合变速，和内侧安装鼓式制动器。

For more people can apprecaite and have the master work, there is reproduction painting appears in the market, the large various selection of paint,the high saturation of color plus the plentiful sfumato, to make the reproduction perfect copy and detail as original painting, so as to meet the requirment of amateurs who love art paintings,they do not need to pay high price to get classical paintings.

颜料色域广，色彩饱和度高，色彩层次丰富，图像色彩还原真实，能完美的复制原作，满足艺术爱好者欣赏，艺术爱好者们不用支付昂贵的价格就能拥有经典油画。