密度

The appropriate conditions were shown:The green tablets were shaped under 300 MPa uniaxially and sintered up to 1 300 ℃ then kept at that temperature for 4 hours.

在最佳烧结条件下烧结的HAP陶瓷，烧结密度达2.81 g/cm3，相对密度达89%。SEM照片显示为紧密排列的六边形晶粒的集合体。

The metastable phase equilibrium of the quaternary system Na(superscript +)∥Cl(superscript -), CO3(superscript 2-), B4O7(superscript 2-)-H2O was studied at 273 K by isothermal evaporation method, the solubility and density of the equilibrium solution of this system were determined and the metastable equilibrium phase diagram was plotted in line with the experimental data. The phase diagram of the system consists of three univariant curves, three crystallization fields and one invariant point.

采用等温蒸发法研究简单四元体系Na∥Cl，CO3(上标 2-)，B4O7(上标 2-)-H2O273K时的介稳相平衡，并测定该体系273K平衡液相中各组分的溶解度及密度，该体系的介稳相图和密度组成图显示：该四元体系在273K时的相图由3条溶解度单变量线、3个结晶区及1个共饱和点组成。

Whereas, in the unrecovered sample which was heated by laser for short time, although the＜001＞∥ND subgrains growth could be observed, but the growing preference was not so sharp as that in the recovered case.

通过透射电镜对铜的微观亚结构形貌观察与取向分析表明，在初始晶粒为15μm、经88％冷轧的样品中发现，冷轧基体中存在清晰的亚晶粒间界，并存在＜001＞∥ND取向区域；＜001＞∥ND亚晶周围聚集有＜011＞∥ND、＜112＞∥ND和＜123＞∥ND取向亚晶；＜001＞∥ND亚晶内具有较低的位错密度，而其它取向亚晶位错密度相对较高。

In the traditional clustering methods based on grid and density,the interval and the density valve needs to be input with unsmoothed cluster,wrong judgement of clustering boundary.

传统的基于网格与密度的聚类方法需要用户输入间隔距离和密度阀值参数，聚类的结果不平滑，不能很好地判断边界对象的网格归属。

To the materials , there are rare dislocations in their crystal grains; to the unstrengthened samples, there are many dislocations which well-distributed in their grains; and to the strengthened samples, there are a large amount of dislocations scattered along their grain-boundaries, that is, the dislocations form a dislocation wall which is of great dislocation density.

又经透射电子显微镜对各种样品微观组织结构进行分析，发现其位错组态明显不同：①原材料样品中的晶粒内仅存在有非常稀疏的位错线；②未经过强化的样品中可观察到大量均匀分布的位错，分布密度相对较高；③在经过低载锻炼强化的样品中，可观察到大量的晶粒内在晶界附近聚集着一道密度很高的位错墙。

The apparent degree of network chains for the different swollen extent of the same unswollen hydrogel sample increased linearly with the increase of swelling ratio, however, the apparent modulus did not decrease monotonously with the increase of swelling ratio. Furthermore, the dependence of apparent degree of network chains on swelling ratio had nothing to do with the swelling agent. The above results reflected the changes of entanglement and the contribution of entanglement under different swelling ratio, and the results could be explained with the theory of Flory-Erman's constrained junction model and LangleyGraessley relation.

发现同一水凝胶样品的不同溶胀程度试样经应力应变测试得出的表观网链密度随体积溶胀率的增加而线性增加，等效模量并不随溶胀程度的增加而单调减小，而表观网链密度的溶胀程度依赖性与所选用的溶胀剂无关，该结果反映了不同溶胀程度下缠结的变化及缠结对弹性的不同贡献，并可由Flory-Erman的constrained junction模型及Langley-Graessley公式得到解释。

From packaging business card printing and membership card making ink dispersion system, small particle size of pigment particles adsorption of resin and solvent relatively significant pigment particles is more than likely, it is often represented as density gets smaller, large-size variable density of pigment particles will cause the pigment particles; and handlethe under-metaphysical upfloat fluoroaracil colors of and form the business card printing and membership card making ink and floating.

从敌国包装制卡和会员卡制息油不朱凑拢编制看，小粒径的颜料粒子吸附的树脂和溶剂相不不不不不差给比不小的颜料粒子不小得众，不常表示为密度变小，不小粒径的颜料粒子密度变不小便会酿成颜料粒子的下沉；而下粒径的颜料上浮而构成了制卡和会员卡制息油不朱的浮色本体。

The results indicated that immobilized E2 protein remarkably raises the level of phosphorate-tyrosine in Raji cells , but the soluble E2 protein hasn't obvious impact to phosphorylation of tyrosine of Raji cell. It was presumed that immobilized E2 protein was resembled to natural viron enveloped E2 protein and may more efficiently interact with CD81 molecule.

这可能是因为固相化的E2蛋白类似天然的病毒颗粒，在构象上要更接近于天然的病毒颗粒表面E2蛋白，而且固相化后的E2蛋白在单位体积的密度要高于可溶性的E2蛋白单位体积的密度，使其能够更充分的与细胞表面的CD81分子相互接触作用。

In practice, asphalt concretes are compacted to a certain percentage (typically greater than 90%) of their theoretical maximum density,(i.e., the density of a voidless mixture of the asphalt cement and aggregate).

尤其是沥青混凝土要压至他们理论最大密度的特定的百分率（比如90％以上），例如，沥青胶泥和聚合物的有效混合物密度？

By regression of experimental data, therules of the linkage between these factors, which will provide a theoretical basis for designing BBP with different scales.3 Using thermal analysis technology and dynamic thermogravimetry, the paper studies combustion kinetic characteristics of 3 types of agricultural crops at different rate of temperature rise, and thus, achieved dynamic parameters of these fuels at different rate of temperature, established dynamic model of straw combustion, which reflects the dynamic process in the fast combustion area.4 Characteristics of straw briquette combustion was experimented, focusing on the impact of straw type, temperature, air supply, and density, diameter, and weight of briquette on the combustion speed, and the following conclusions were drawn:(1) combustion of straw briquette fuel is static permeation diffusion combustion;(2) temperature has a larger impact on the speed of straw briquette combustion than air supply; the higher the combustion temperature is, the faster volatilizable component separates out, and the less steady the combustion is;(3) density of briquette fuel has impact on the speed of volatilizable component separation and therefore the combustion speed;(4) increase of diameter and weight of briquette fuel increases the average combustion speed in the initial stage, and that in the later stages is comparatively steady;(5) the proportion of volatilizable component in straw briquette fuel is high, therefore, the temperature control during combustion under the rational ventilation condition is essential to ensure its safe combustion.5 Using the above-mentioned results of experiments and theoretical analysis, and based on thought of hydraulic driven and bi-direction compression, the hydraulic system and compression parts of the HBP BBP are re-designed in terms of industrialization.

利用热分析技术，采用动态热重实验法，对我国的三大农作物秸秆在不同升温速率下的燃烧动力学特性进行了较系统的研究。得到了各原料在不同升温速率下的动力学参数；建立了秸秆燃烧的动力学模型，该模型反映了秸秆迅速燃烧区的动力学过程。 4 对秸秆成型燃料的燃烧特性进行了试验研究。着重研究了秸秆河南农业大学博士学位论文巫的种类、温度、空气供给量、成型燃料密度、直径、质量对成型燃料燃烧速度的影响并得出如下主要结论：①秸秆成型燃料的燃烧方式属于静态渗透式扩散燃烧。②秸秆成型燃料燃烧速度受温度的影响大于通风量燃烧速度的影响：燃烧温度越高，挥发分析出速度越快，燃烧平稳性愈差。③成型燃料密度影响成型燃料挥发分的析出速度，影响燃烧速度。④成型燃料直径和质量的增加，使得燃烧初期的平均燃烧速度增大，中后期的平均燃烧速度相对平稳。⑤秸秆成型燃料含挥发分比例高，因此合理配风下的控温燃烧是保证其完全燃烧的关键。 5运用已取得的试验和理论分析结果，以液压驱动、双向成型为基础，从产业化的角度对HBP型成型机进行了液压系统和成型部件的改进设计；同时采用了二级预压机构，使该成型机的生产率达到 500kg.hd；单位能耗 60kwh。上'左右，磨损件修复周期 300小时左右，基本解决了影响生物质固化技术在国内推广的技术难题。

Since historical times,England ,where the early inhabitants were Celts, has been conquered three times .

从有历史以来，英国，在此地早期居住的是凯尔特人，已经被征服了三次。

Bluetooth OBEX File Transfer Enables the sending and receiving of files on your phone via Bluetooth.

蓝牙OBEX文件移动允许经过蓝牙传送和接受文件。。。。