实验设计

A total number of 27 machining conditions were designed to be conducted in a random sequence.

实验条件依实验设计有27种组合，实验顺序随机产生的顺序进。

On the basis of the previous results and according to the central composite experimental design principles,the method of response surface method with 3 factors and 3 levels was adopted.then the factors influencing the technological parameters were determined by means of regression analysis.response surface and contour were finally graphed with the extraction rate as the response value.resultsthe optimum conditions of lycium barbarum polysaccharides extraction were as follows:the ratio of material to solvent of 1∶32,extraction temperature of 84℃ and extraction time of 2.3 h,one time extraction.conclusionthe yield of lycium barbarum polysaccharides is 11.10% under the optimum conditions.

方法在单因素实验基础上选取实验因素与水平，根据中心组合（box-benhnken）实验设计原理采用3因素水平的响应面分析法，依据回归分析确定各工艺条件的影响因子，以多糖提取率为响应值作响应面和等高线。结果在分析各个因素的显著性和交互作用后，得出枸杞多糖水浸提的最佳工艺条件为：料液比1∶32；浸提温度84℃；浸提时间2.3h；浸提1次。结论在最佳工艺条件下，枸杞多糖的实际提取率可达11.10%。

In this paper, aiming at the extraction of Sargassum fusiorme polysaccharide, experiment factors and levels were firstly selected by one-factor tests. Next, on the basis of this and according to the Box-Benhnken center-united experimental design principles, the method of response surface analysis with 3 factors and 3 levels was adopted.

针对羊栖菜多糖的提取，通过单因素实验选取实验因素与水平，根据Box Benhnken的中心组合实验设计原理，在单因素试验的基础上采用三因素三水平的响应面分析法，依据回归分析确定各工艺条件的影响因子，以多糖提取率为响应值作响应面和等值线图。

In the second experiment, the design of tow stype and crossover experiment was still adopted. Experimental subject and grouping method were same as the first experiment.

第二部分实验仍采用随机两阶段交叉实验设计方法，实验对象和分组方法同前，所不同的是进行情绪状态的评估。

This paper puts forward an experimental model with the first-order response surface method and the design of experiments to study the impact of factors on dynamic performance of PEMFC. These factors include clamping pressure, fuel gas pressure and flux. The model is finally validated by volt-ampere experiments.

本文通过正交实验设计，利用一阶响应面法得到各因素对电池性能影响的实验模型，综合考虑了装配压力、燃料气体压力和流量对自增湿、自呼吸型PEMFC动态性能的影响，并结合伏-安特性实验进行了验证。

Condition filter experiments for determination of the iron by phenanthroline spectrophotometry in the genral textbook are single factor experiments, and there are some problems in the experimental design.

普通教材中邻二氮菲分光光度法测定铁条件选择实验都是单因素条件实验，不够全面，实验设计中也存在一些问通。

With Platycodon root as experiment material, on the base of single factor experiments (extraction time, extraction temperature and so on), then through the experimental design of response surface methology, the conditions of extraction are studied.

以桔梗为实验材料，在提取温度、提取时间、料液比等单因素实验的基础上，利用响应曲面实验设计法对桔梗皂甙提取条件进行研究，并通过回归方程和响应曲面，得到了最佳提取工艺。

With Platycodon root as experiment material and Platycodon extract,sucrose,citric acid and β-cycloheptaamylose as experiment factors,on the base of Response Surface Methodology Analysis,researches on optimal prescription of Platycodon health protection beverage were conducted.

以桔梗为实验材料，以桔梗提取物、β-环状糊精、蔗糖和柠檬酸为实验因素，利用响应曲面法进行实验设计，对桔梗保健饮料的最佳配方进行研究，并对最佳配方进行感官评价验证，理化指标检测和微生物学检测。

The experiment design and method of loose blasting funnels are introduced in this paper, and an analysis of the test results is carried out.

介绍了爆破漏斗的实验设计和实验方法，并对实验结果进行了分析。

Response surface and contour were finally graphed with the extraction rate as the response value.

在单因素实验基础上选取实验因素与水平，根据中心组合实验设计原理采用三因素三水平的响应面分析法。

Since historical times,England ,where the early inhabitants were Celts, has been conquered three times .

从有历史以来，英国，在此地早期居住的是凯尔特人，已经被征服了三次。

Bluetooth OBEX File Transfer Enables the sending and receiving of files on your phone via Bluetooth.

蓝牙OBEX文件移动允许经过蓝牙传送和接受文件。。。。