压力分布规律

And density grads along a cross-section perpendicular bisector were used to analysis secondary flow. Abnormal mechanism of inner wall temperature distribution in a large specific region in inclined upward tubes at supercritical pressures was discussed.

并利用截面中垂线上的密度梯度定量分析二次流变化的规律，讨论超临界压力下大比热区内倾斜光管内壁温分布异常的机理。

According to the experimental data, it is found that the circumferential diffierence of heat transfer characteristics occurres due to the effects of thermal acceleration and buoyance in the inclined smooth tube at supercritical pressure.

实验结果表明：在超临界压力区域，倾斜光管内可能由于受到热加速度和浮力的综合作用，倾斜光管传热特性沿周向是不均匀分布状态，通常管内顶部的壁面温度比底部高，在大比热区发生传热恶化和传热强化的现象，低质量流速和高热负荷条件下会发生传热恶化现象，高质量流速下会发生传热强化，避免壁温发生飞升；内螺纹管内的传热特性在不同焓值区域表现不同，在远离拟临界焓值的低焓值区域和高焓值区域，呈现出相似的规律，而在接近拟临界焓值区域时，传热得到强化。

The elastic stress diagram design method is behind the times and cant meet the command in practice.In the paper the author collected and analyzed a large amount of data about the SLRCP on several typical domestic model experiments and the projects in practice. By summarizing and analyzing the data, the author set up a typical computing model and analyzed the model by the software ANSYS, by reading the output data of the stress and the crack from the program, combined with the experimental results, the author summarized the destroy procession of the stock. The paper also discussed the influence of other main factors to the crack and the stress besides the internal water pressure, such as the concrete material, the dimension of stock and the way of laid-out steel bars.

本文通过对大量实际工程中的坝后背管资料的收集、归纳和分析，选取了具有代表性的计算模型；用有限元软件ANSYS计算了典型坝后背管结构在实际内水压力作用下的应力分布和裂缝发展情况；以国内几个有代表性的模型试验和有限元计算的成果为依据，分析了在内水压力作用下钢衬钢筋混凝土压力管道管壁裂缝的特点，并尝试总结出此种管道的裂缝出现的原因及其发展规律，同时确定了坝后背管结构极限状态的新的定义方式——以坝后背管的裂缝宽度来定义。

Directed against stress properties of lining structure of loess highway tunnel, the paper selects three loess highway tunnels as relying engineering according to buried depth and soil properties, and takes field observation synthetically for the first time, which pays more attention to researches on the change regulations of pressure acting on first lining and invert, axial force of lattice girder, contact stress between first and second lining, concrete strain of second lining verse the time and distributions in different positions.

针对黄土公路隧道衬砌结构受力特性，根据埋深和土质情况，选取三座黄土公路隧道为依托工程，首次开展了大规模系统的现场测试，着重研究了一衬和仰拱围岩压力、格栅拱钢筋轴力、一衬和二衬接触应力以及二衬混凝土应变时间变化规律及分布特性。

An optimized fuel mixture ratio is obtained for the test bomb. Experimental results show that the cloud dispersion effect of multi-component solid fuel mixture is better than trinitrotoluene's of the same mass.

实验结果表明，该多元固态混合燃料的云雾分散效果明显优于相同质量的TNT，其爆炸场超压呈衰减-增长-再衰减的变化规律，且具有非常相似的压力场分布。

In imitate, be aimed at accept rice diamond grow environment, in enraging reaction gas with respect to pure argon, below condition of pressure of different power input, different gas, the metabolic rule that the plasma that forms in deposit room distributings undertook imitate, the corresponding imitate result that issues its and general and hydric atmosphere is compared relatively.

在模拟中，针对纳米金刚石的生长环境，就纯氩气反应气体中，不同的输入功率、不同气体压力条件下，沉积室中形成的等离子体分布的变化规律进行了模拟，将其和一般氢气气氛下的相应模拟结果相对比。

And objective parameters (texturized degree, color, hardness, springiness, chewing, water absorption, yield, etc.) were investigated in the high moisture soy protein extrusion process, and the statistical models of system and objective parameters were built, using the step-by-step regression analysis; A comprehensive evaluation of the products, and the process optimization of high moisture extrusion were obtained,using factor analysis; Secondly, residence time distribution and soy isoflavones losses kinetics were studied in the high moisture extrusion; Finally, chemical bonding process, the micro-structure and protein secondary structure changes were investigated in the texturization of soy protein, then the mechanism assumptions of texturization soy protein by moisture extrusion were proposed.

本文对大豆蛋白高水分挤压组织化技术和机理进行了研究，研究内容包括：首先采用系统分析法，研究了大豆蛋白高水分挤压过程中，挤压机操作参数(螺杆转速、物料水分、喂料速度和机筒温度)对系统参数(系统压力、扭矩、单位机械能等)、目标参数(组织化度、色泽、硬度、弹性、咀嚼性、吸水率、产量等)的影响规律，建立了各因变参数的统计模型；采用因子分析法对产品进行了综合评价，并对高水分挤压组织化工艺进行了优化；其次，研究了大豆蛋白高水分挤压中的停留时间分布以及大豆异黄酮的损失动力学；最后，研究了大豆蛋白组织化过程中化学键、微观结构和蛋白质二级结构的变化规律，提出了大豆蛋白高水分挤压组织化的机理假设。

To a quick-flange of pressure vessel, using finite element analysis on the basis of Pro/E and ANSYS, drawing its stress characteristics.

通过Pro/E和Ansys对压力容器快开门法兰进行了有限元应力分析，得到了其受力特性和应力分布规律，并对其进行了应力强度评定。

The vertical pressure acted on rod is also studied. Its size and distribution rules confirm the shearing force theory.

对拉杆上所受的垂直压力进行了研究，其大小及分布规律有力地验证了剪力理论。

Firstly, the related parameters are distributed periodically in the falling film and their periods all equal to that of vacillation of fishing vessel. Secondly, the film tangent and radial velocity components are not zero because of vacillating additional inertia forces and furthermore, in one vacillation period, most parameters are distributed quite regularly in the tangent and radial directions. Thirdly, when other parameters are kept constant, the falling film absorption is enhanced if the amplitude or the period of vacillation is moderately decreased and this result conforms to the theoretical qualitative analysis. Finally, falling film absorption changes with the solution parameters at inlet and system pressure and the change trend is very similar to what happened in the static tube.

首先，降膜内相关参数分布具有周期性且周期等于摇摆振动周期；其次，摇摆附加惯性力使液膜沿吸收管周向和径向流速不为零，而且单位摇摆周期内各参数沿周向和管长方向分布比较规律；再次，当其他参数一定时，适当减小摇摆幅度和摇摆周期，液膜吸收能力将增强，这与理论定性分析相当吻合；最后，改变溶液入口参数及吸收压力，相应的吸收情况有所改变，其趋势与静止状态下的降膜吸收非常一致。

The big eared hedgehog, the little owl, the sand gecko, the three-toed jerboa, and every show needs a villain - saw-scale - the viper!

大耳刺猬，小猫头鹰，沙壁虎，三趾跳鼠，每场戏都需要反派角色：蝰蛇。

Plasmodiophora brassicae ; resting spores ; density gradient centrifugation of sucrose ; ultrasonic disruption

根肿；休眠孢子；蔗糖密度梯度离心；超声波破碎