冷却的

When chilled water is used to cool the mould, cycle time is related to wall thickness as follows.

在冰水冷却的条件下，冷却时间与壁厚有以下的关系。

The cooling unit vR-Zone extreme memory chiller is intended for cooling the memory to very low temperature.

冷却股轮带极端记忆式制冷机是为冷却的记忆，以非常低的温度。

The surface temperature distribution,the spraying cooling curve,and the heat transfer coefficient of spray cooling were obtained.

得到了加热表面温度分布、喷雾冷却曲线和喷雾冷却的换热系数等传热特性。

But another way to keep food cool without the need for electricity is to use an evaporative cooler.

另外一种不需要电力保存是食物冷却的方式是使用冷却蒸发器。

Although regeneratively cooled combustion chambers have proven to be the best approach for cooling large liquid rocket engines, other methods of cooling have also been successfully used for cooling thrust chamber assemblies.

虽然再生冷却燃烧室已被证明是最好的办法冷却的大型液体火箭发动机，其他方法冷却，也被成功地用于冷却推力室集会。

Through this material one could setup an overall impression of the study content and the study method.In order to investigate the basic heat transfer characteristics of regeneratively cooled scramjet, in the second chapter, one dimensional heat transfer model of regeneratively cooled scramjet was developed. In this model, N-R correlations were used to describe hot gas-side and coolant-side convection heat transfer. Simple model of gas properties was also used.

为了初步了解超燃冲压发动机再生冷却传热的基本特征，第二章建立了超燃冲压发动机再生冷却的一维传热数理模型，采用了准则关系式描述燃气侧和冷却剂侧的对流换热，采用了简化的燃气物性模型，并对衬层材料、衬层厚度和冷却剂流量进行了参数研究。

In order to improve the marine storage battery 's distilled water cooling system, a new automatic control unit based on single-chip computer is developed.

针对船上蓄电池组蒸馏水冷却系统存在的缺点，开发了一种根据蓄电池温度对蓄电池组进行冷却或分层冷却的自动控制装置

The cooling forces are calculated by using the optical Blochequation and dressed-state reperetation.Especially,the evaporative cooling,by whichthe Bose-Einstein condensations of atoms are realized,are studied theoretically.

用光学布洛赫方程和缀饰态图象分析了基本冷却力，随后对多普勒冷却、亚多普勒冷却和亚单光子反冲极限冷却的机制及实验方法进行了全面地研究，尤其对实现玻色-爱因斯坦凝聚的蒸发冷却作了原理性分析。

The internal regenerative cooling is a new cooling technique of the thrust chamber.

一、内部再生冷却的物理描述内部再生冷却是一种新的推力室冷却技术。

As the chamber pressure increases, the only cooling methods that can satisfy the requirements are regenerative cooling only or regenerative cooling combined with film cooling.

作为商会的压力增加，只有冷却方法能够满足要求，再生冷却的唯一或再生冷却结合膜冷却。

Objective: To study the effect of polycythemia on blood oxygen saturation.

裴蕾目的：观察RBC剧增而引起的高粘血症对血氧饱和度的影响。

Based on SIMPLER algorithm in the curvilinear body-fitted coordinates, the calculations were performed for Pr=0.7, Re=10~1000 on non-orthogonal non-staggered grids which are generated by elliptic equation systems.

采用曲线坐标系下压力与速度耦合的SIMPLER算法，数值研究了周期性渐扩渐缩波纹通道内脉动流动与换热情况，流动Re数的范围为10~1000，Pr数为0.7。