全波整流

First introduction whole wave commutate electric circuit of work principle, immediately after introduction the electric capacity filter the function characteristics of an electric circuit, and in the electric circuit adoption exaltation stability, exaltation temperature stability and limit flow a type over flow protection electric circuit of concrete measure with insure an electric circuit safety stability of work.

首先介绍了全波整流电路的工作原理，接着介绍了电容滤波电路的性能特点，然后引入了具有放大环节和辅助电源的串联可调式稳压电源，并在电路中采用了提高稳定度，提高温度稳定性及限流型过流保护电路的具体措施，以确保电路安全稳定的工作。

Meanwhile, circuit is similar to reversing xm's phase after full-wave rectification.

同时，电路在a~b段相当于对 39 全波整流后反相，解调后的频率为原调制波的二倍。

According to the requirements for alternating current sampling, four feasible schemes (full-wave rectification, double 4051, raised analog ground and adder technique) are systematically contrasted in this dissertation. The hardware and software of this instrument are also analyzed in great detail.

本文围绕交流直接采样的技术要求，详细地对比分析了四种可行性设计方案，其中包括全波整流、双4051、模拟地抬高及加法器方式，并对其硬件实现和软件编程进行了详细的分析与论证。

The envelope detection has twoquestions: One, the demodulation main process is carries on thehalf-wave or the full-wave rectification to the amplititude-modulatedsignal, is unable from the detector output distinction modulationsignal phase.

包络检波有两个问题：一是解调的主要过程是对调幅信号进行半波或全波整流，无法从检波器的输出鉴别调制信号的相位。

A multi-channel representation of the input image was obtained by a bank of Gabor filters, corresponding to multiple scales and multiple orientations. Full-wave rectification of each channel and contrast gain control among the channels were performed sequentially to get orientation feature maps with multiple scales and multiple orientations.

从输入图像出发，采用Gabor算子建立多尺度、多方位的多通道图像，通过全波整流和各通道间的对比度增益控制，得到多尺度、多方位的方位特征图，这些特征图的线性组合则为显著性图。

The primitive signals of EMG is processed by DasyLab 6.0 software, band-pass filtering, low-pass filtering (10Hz) and full-wave rectification, also obtain the integration EMG through integration analysis. Moreover, the greater EMG in the landing action is regarded as the basis for standardization (100%).

原始肌电讯号经由DASYLab 6.0软体分析，进行10~500HZ的band -pass滤波处理、10Hz低通滤波与全波整流上翻后，并以运算功能键的程序处理，得到积分肌电量肌电讯号，以动作时期之最大肌电值为基准值(100％)，进行标准化处理。

Body weight is used as the basis for standardization to obtain ground reaction force values and impulse values. The original signal of EMG from Rectus femoris, Biceps femoris long head, Tibialis anterior and Gastrocnemius lateral head is processed by DASYLab 6.0 software to band-pass (10-500Hz), full-wave rectification and low-pass filtering (10Hz), after using the formula root mean square to get the root mean RMS value, divided by total gait cycle as the basis for standardization (100%).

肌电讯号由DASYLab 6.0软体分析股直肌、股二头肌、胫骨前肌、腓肠肌等肌群之原始肌电讯号后，进行10-500Hz的band-pass滤波处理，经全波整流上翻、10 Hz低通率波平滑化处理，再利用均方根（root mean square， RMS）公式运算后，可得均方根振幅，并以步态周期中最大肌电值进行标准化处理。

This is a multisim10 to do with a multimeter, using the full-wave rectifier, welcome to draw on.

详细说明：这是一个用multisim10做的一个万用表，用的全波整流，欢迎借鉴。

EMG signal analysis software from DASYLab 6.0 rectus femoralis, biceps femoris, tibialis anterior , the gastrocnemius and other muscles of the original EMG signal, the 10-500Hz to the band-pass filter processing, the full-wave rectifier on the turn, rate of 10 Hz low-pass smoothing wave treatment, and then by the integral operation, the available IEMG values, and divided by the integral interval of time, come to the average EMG EMG signal amplitude, and action cycle the largest standardized EMG values.

肌电讯号由DASYLab 6.0软体分析股直肌、股二头肌、胫骨前肌、腓肠肌等肌群之原始肌电讯号后，进行10-500Hz的band-pass滤波处理，经全波整流上翻、10 Hz低通率波平滑化处理，再经积分运算后，可得积分肌电值，并除以积分区间之作用时间，得出肌电讯号的平均肌电振幅，并以动作周期中最大肌电值进行标准化处理。

According to the object of processing signal and investigating on of the properties of PCG, a method of preprocessing the PCG signal, i. e.,"rectification"is developed. This method stresses the basic contradiction of "location". Extracting the characteristic of preprocessed PCG by wavelet analysis, we achieved the object of self-locating the first heart sound and the second heart sound .

针对信号处理的目的和对信号本身特点的分析研究，提出对PCG信号进行预处理，即&全波整流&，突出&定位&这一基本矛盾，再对预处理后的PCG信号作特征提取的小波分析，从而实现了第一心音〓和第二心音〓的自定位。

Further more, the simplified analysis method on stressed-skin effect of corrugated steel sheet is also discussed in detail.

此外还比较详细地探讨了蒙皮效应的简化分析方法。

If I had known her telephone number,I would have called her.

要是我知道她的电话号码，我就打电话给她了。