交流电源

1101B. The unit incorporates an RF Signal Generator, FLEX/POCSAG Encoder, IF Frequency Counter, AC Millivolt Meter, IF Signal Generator and a 1.5 VDC power supply.

该装置包括一个射频信号发生器，flex/pocsagencoder，如果频率计数器，交流毫伏表，如果信号发生器和一个1.5伏直流电源。

Disturbing Voltage is estimated equivalently according to the measurement of the typical numerical values between the leakage voltage and leakage resistance from the equipment of the oscillograph and the millivoltmeter based on the working frequency disturbance model.

在工频干扰模型基础上，通过对示波器和毫伏表的电源变压器漏电阻和等效漏电压典型值的测量，估算了工频干扰电压的幅度，从而说明电子测量系统各设备间共地连接的必要性，并介绍了共地方式在交流电桥等实践中的应用实例。

The quality of the neutral line and its grounding will influence directly to the operation of the combined hi-frequency switching mode power supply.

交流供电线路中的中线及中线接地质量的好坏，对通信用高频开关组合电源的工作有直接影响，实际应用中经常出现因中线及中线接地故障造成设备损坏，因此需加强对中线的维护。

The output voltage of power supply is AC sinusoidal wave. When the sinusoidal peak-to-peak applied voltage is about 9kV and its frequency is about 10kHz, the APSGD will appear, and the luminescence thickness of plasma is less than 1mm. This experiment result agrees well with the calculated results.

实验中电源输出的电压波形为交流正弦波，在峰-峰值电压为9kV时发生沿面辉光放电的电压频率为10kHz，同时等离子体发光厚度低于1mm，上述实验结果较好得验证了理论计算的结果。

Design methods of frequency conversion power supply and high voltage reactor in the equipment are discussed.

论述了装置中变频电源和高压电抗器的设计方法；进行了750 kV电压等级超高压电力变压器的交流耐压和局部放电试验，对试验数据进行了分析。

Under this direction, we developed a kind of inverter power supply, and the parameters are as follows:(1)the input of three-phase alternating current;(2)the output of sinusoidal wave;(3)the frequency of output: 5-25 kHz, which can be adjusted;(4)the voltage of output: 5-20 kV, which can be adjusted.

根据这个特点，我们研制了一种高频、高压的大功率逆变电源，参数如下：(1)三相交流输入；(2)输出正弦波；(3)输出频率：5～25kHz，可调；(4)输出电压5～20kV，可调。

20 Output smoothing In a practical circuit, when a capacitor is directly connected to the output of a bridge, the bridge diodes must be sized to withstand the current surge that occurs when the power is turned on at the peak of the AC voltage and the capacitor is fully discharged .

在实际电路中，当一个电容器直接连接到桥式整流器的输出端时，桥式结构中的二极管必须能够承受交流电压峰值时开启电源和电容完全放电所产生的电流浪涌。

Trigger circuit by adjusting the phase of the trigger pulse to control the on-off thyristor, which can be manually controlled to adjust the output voltage, and then, after step-down transformer can be used to obtain the magnetization of the magnetic low-voltage high-current power supply, mainly by the SCR the main voltage regulator circuit, trigger circuit, such as composition, is a broad application prospect of the exchange regulator controller.

通过调节触发电路的触发脉冲的相位来控制晶闸管的通断，从而控制输出得到可人工调整的电压，再经过降压变压器得到可用于磁化的低压大电流磁化电源，它主要由可控硅调压主电路、触发电路等组成，是一种具有广阔应用前景的交流调压控制器。

AC Power Supply System Communication Power Supply System exchanges generally are high-voltage power distribution, step-down transformer, Chai oil-fired units, UPS and low-voltage distribution screen composition.

通信电源的交流供电系统一般由高压配电所、降压变压器、柴油发电机组、UPS和低压配电屏组成。

The research work of this paper is divided into five parts: The first ,according to the work characteristics of ship's auxiliary boiler, this paper is to design applied project in the automatic control system of ship's auxiliary boiler; The second, according to the work request of the cargo winch of alternating three-speed change-pole speed-adjusting, this paper is to determine adopting the method of the PLC control; The third, this paper is to design PLC application in three -phase induction motor control, to give the ladder chart, program and input and output circuit diagram; The fourth, this paper is to research the method of the ship's combined starting screen automatic control with the PLC; The fifth, this paper is to inquire the possibility of apply the PLC in ship's engine room surveillance system; According to the comprehensive analysis of above actual example of ship's auxiliary machinery automatic system with the technique of PLC; not only can use the technique of PLC to replace traditional relay-contactor control technique in ship's auxiliary machinery automatic system, but also can get the conclusion of the former is more dependable and more clever than the latter, the maintenance is more convenient, thus develop a new path for ship automation.

本文研究的工作主要包括五个部分：第一，根据船舶辅锅炉的工作特点，设计PLC在船舶辅锅炉自动控制系统中的应用方案，主要有PLC选型及输入输出点的设计，画出系统控制梯形图并分析工作原理；第二，根据交流三速变极调速起货机的工作要求，确定采用PLC控制的方法，进行控制系统的硬件设计和软件设计，并分析工作原理：第三，设计了PLC在三相异步电动机控制中的应用，给出了控制梯形图、程序及输入、输出接线图；第四，研究了用PLC实现船舶组合起动屏自动控制的方法，进行了系统的电源设计和软件设计，给出系统工作流程图；第五，探讨了船舶机舱监视系统应用PLC的可行性，将继电器报警线路改为用PLC控制报警，给出系统硬件图和软件梯形图，并分析了PLC机的选型、抗干扰和应用PLC的经济效益和社会效益等问题。综合以上船舶辅助机械自动控制系统采用PLC技术的实例分析，可以得出船舶辅助机械自动控制系统不但可以使用PLC技术取代传统的继电器接触器控制技术，而且前者比后者更可靠、更小巧，维护保养更方便的结论，从而为船舶自动化开辟了一条新的路径。无忧毕业设计网 www.5ubs.cn

Chrysanthemum of 10 thousand birthday is lax to edaphic requirement, with the arenaceous qualitative loam with fecund, good drainage had better.

万寿菊对土壤要求不严，以肥沃。排水良好的砂质壤土为好。

He unstepped the mast and furled the sail and tied it.

他拔下桅杆，把帆卷起，系住。