三轴的

Diven by the driving shaft,the barrel with the ematerials loaded performs cycling compound movements of translation,rotation and tumbling,which make the materials move annularly,radially and axially along the barrel boby ,thus achieving mutual flow,spread,accumulation and mixing of material for the purpose of fully mixing.

装料的筒体在主动轴的带动下，作周而复始的平移、转动和翻滚等复合运动，促使物料沿着筒体作环向、径向和轴向的三向复合运动，从而实现多种物料的相互流动、扩散、积聚、掺杂，达到均匀混合的目的。

A solid figure having24 equal faces, every three of which correspond to one face of an octahedron.

斜方晶有三个或三个以上类似的面，且各面均平行于一根轴的一种晶体形式

Establishing a geometric model of pump shaft with Three-dimensional modeling software and considering force condition to determine the boundary Conditions, after a reasonable simplification, then the modeling is inputted for ANSYS strength analysis combined with the traditional strength theoretical calculations of the shaft to get the result of stress and strain calculations and static stress and strain diagram.

应用三维造型软件建立了泵轴的几何模型，经过合理的简化，分析受力情况确定边界条件，在ANSYS软件中进行分析，结合传统的强度理论计算对泵轴的强度进行了计算和求解，得到了应力和应变的计算结果。

Turn-table is one of the devices which are used to simulate aerocraft's performance on the ground .

引言三轴飞行模拟转台是飞行器控制系统地面半实物仿真设备之一，属于复杂的机电系统，它存在很多不利于系统性能提高的因素，诸如电路参数的漂移、轴系间的力矩耦合、负载变化等，这些都容易引起参数时变。

Meanwhile, the three-dimensional analytical s olutions of piezoelectric materials under actions of the axial force vertical to polaxis were investigated to obtain the displacement and voltage distribution u nder this situation.

同时，还考察了受垂直于极性轴的轴向力的压电材料的三维解析解，得到了这种情况下的位移和电势分布情况。

It is found that the changes resulted from the inclination of the moving mirror consists of three parts: the stationary OPD due to the optical beam deflection,the offset OPD due to the different ray in the direction perpendicular to the optical axis,and the offset from the center of the deflected beam to the optical axis.

结果表明，光束偏转带来的误差分为三部分：光束偏转导致整体增加的恒定光程差，垂直光轴方向因不同光线而引入的偏移光程差以及偏转光束中心相对于光轴的偏移量。

By means of triaxial tests, uniaxial compressive tests of a prism and bending tests of a reinforced cement-soil beam, elastic and deformation modulus of cement soil are studied and the relationships between deformation modulus and compressive strength are obtained.

通过三轴试验、棱柱体单轴抗压试验及加筋水泥土梁的抗弯试验，研究了水泥土的弹性模量及变形模量，得到了变形模量与抗压强度之间的关系，并分析了试验方法对变形模量测试结果的影响。

Rapid development and expansion of the scale of the company, with advanced production equipment, measuring five-line, two CNC vertical milling machine, a three-axis milling machine, CNC coordinate measuring machine, one Taiwan.

公司规模快速发展壮大，拥有先进的生产设备，测量划线机五台，数控立式铣床两台，三轴数控铣床一台、三坐标数控测量机一台。

Test the accelerometers which is fixed in three-axis rotary table on the ground.

第三，在地面进行加速度计的三轴转台实验。

The drained behavior of Hokksund sand under low confining pressure was studied through static triaxial test, and the samples were prepared through the dry sedimentation method. The test results were corrected through the membrane effect which is often neglected under high confining pressure, the correction to axial stress for dense sample under a cell pressure of 10 kPa is equal to 12%.

采用干样沉降法制备样品，选用静三轴仪对松砂和密砂样在10kPa 至100kPa的低围压下的排水行为进行了实验研究，并对实验结果作了橡皮膜校正，在围压为10kPa的密砂实验中，轴向应力的校正值可达到12%。

Chrysanthemum of 10 thousand birthday is lax to edaphic requirement, with the arenaceous qualitative loam with fecund, good drainage had better.

万寿菊对土壤要求不严，以肥沃。排水良好的砂质壤土为好。

He unstepped the mast and furled the sail and tied it.

他拔下桅杆，把帆卷起，系住。