查询词典 wrinkles

This is how you safely and effectively eliminate your wrinkles.

这是你如何安全有效地消除你的皱纹。

You can use two methods to get the wrinkles out of your fabric, keeping it looking professional.

您可以使用两种方法获得了你的皱纹布，保持它寻找专业。

In this post, you'll discover what truly causes wrinkles and how you can manage them.

在这后，您会发现什么真正的原因皱纹以及您可以如何管理它们。

The objectives of this paper were to investigate the simulation and design of continuous multiple-station rolling forming process for a U-Section Steel Bar by CAE software-DEFORMTM Due to the limitation of elements number using a short strip 120mm went through all the stations to simulate the real continuous rolling forming on factory The roller gap was fixed as 0 30mm roll speed was 20 rad/sec and progressive angles were all equal for each rolling process which were the formed angle divided by by the number of station Three rolling processes were selected with 6 9 and 12 stations respectively During simulation processes two cases occurred Case A the strip was through a single station Case B the strip across two stations Because the strip laterals side was stretched and twisted during the process The model of case B closer to the practical process than case A and the calculated stress and strain on the tip of U section for case A were lower than these for case B by up to 15% From the result of case B for each process the stress for 12-station process was smallest 9-station process second and 6-station process next Because less-station can save larger cost and forming time but the bigger stress and strain for 6-station caused wrinkles on lateral sides not found on 9-station and 12-station Therefore 9-station process was a more suitable design than 12-station process smaller stretched and twisted and stress The progressive angles for 12-station was 7 5?

本文主要是以DEFORMTM有限元素软体模拟U型钢片连续道次成型与单一道次成型以确认单一道次模拟的是否可取代连续道次模拟之研究。因DEFORMTM 软体对於网格元素上的限制故使用较短素材120mm通过所有的成型站以模拟工厂实际连续成形方法。辊轮间隙固定为0 3mm；辊轮转速为20 rad/sec；弯曲角度的方法为将成型角度平均除以成型站数。有三种辊轮成型方式被选择分别为6站，9站，与12站。在模拟的过程中有两种现象会产生 Case A，素材通过单一成型站。Case B，素材会通过两个成型站。因为在模拟过程中素材的两端会有拉应力与扭力。Case B的模拟比Case A像实际的制程，并计算应力与应变在U型断面的Tip部中可发现Case A比Case B低约15%。从Case B的每站的结果可以得知，12站的成型应力最小，9站次之，6站最后。

If the alarm check cocks closed, the alarm is still sound, it should check whether the verification cock tightly closed, in the alarm valve annular tank whether the accumulation of obstacles, alarm valve under the rubber flap is aging or wrinkles.

若警铃校验旋塞关闭后，警铃仍发声，则应检查校验旋塞是否关紧、在报警阀的环形水槽上是否积聚了障碍物、报警阀瓣下的橡胶是否老化或皱褶。

The series of rolls of paper for pure bamboo pulp and paper, the characteristics of cleanliness are high, good gloss, high strength, good evenness, wrinkles delicate, soft, comfortable, ash-free and tasteless, with a rally good, strong water absorption characteristics.

各系列卷纸为纯竹浆纸，特点是洁净度高、光泽好、强度高、匀度好、皱纹细腻、柔软舒适、无灰无味，具有拉力好、吸水力强的特点。

Prince Andrey went into a plain, neat study, and saw at the table a man of forty with a long waist, with a long, closely-cropped head, deep wrinkles, scowling brows over brown-green, dull eyes, and a red, over-hanging nose.

安德烈公爵走进一间陈设简单而整洁的办公室，他在桌旁看见一个四十岁的人，长长的腰身，长长的脑袋，头发剪得短短的，脸上的皱纹很深，紧皱的双眉下面露出绿褐色的眼睛，红红的鼻子半悬垂着。

Because of the unique fitting mode of hydraulic drawing, early wrinkles of conical parts (very likely to wrinkle in ordinary deep drawing) fit orderly to punch under the action of counter pressure as the punch moves down ward, thus wrinkle-free parts can be obtained.

由于充液拉深方法独特的贴模方式，使普通拉深方法极易起皱的锥形件成形初期产生的皱随着凸模向下运动在对向液压的作用下顺次贴向凸模，从而可以得到无皱的零件。

Its surface should be flat and smooth, and should be free of defects such as wrinkles, avulsions, particulate matter, blisters, pinholes and contaminations.

1.1 外观：薄膜表面应柔软平整光洁，不应有折皱、撕裂、颗粒、气泡、针孔和外来杂质等缺陷，薄膜边缘应整齐无破损。

It also can release nutrients according to the needs of different cortexes, to enable the skin around eyes absorb nutrients just as sponge absorbs water during one night, improve both real and false wrinkles.

并可根据不同皮层的需要释放养分，使眼周皮肤在一整夜的时间里如海棉吸水般吸收营养成分，使真性皱纹和假性皱纹都得到明显改善。

Objective To investigate the effects of interleukin-1 β converting enzyme gene on the biologic characteristics of ovarian cancer cells.

目的 探讨白细胞介素-1 β转换酶的表达，对卵巢癌细胞生物学特性的影响。

Campylobacter: This illness is the most commonly identified cause of diarrheal illness in the world.

弯曲：这种病是最常见的原因查明腹泻病，在世界上。