查询词典 working face

The research shows that gas concentration shows generally an increasing tendency along the working face airflow direction, from 0.095% to 0.18%, under the effect of gas drainage points, up-and-down changing locally; gas distribution in a transect of working face is unequal, under the effect of gas emission, ventilation and drainage, the gas concentration near coal wall is larger than that near goaf, which is a concave function distribution within a distance of 1876.5 m from the inlet of working face, after greater than 76.5m, which is a decreasing distribution from coal wall to goaf.

研究表明，该工作面瓦斯体积分数沿风流方向总体呈逐渐增加趋势，介于0.095%~0.18%之间，受瓦斯抽放点的影响，局部有起伏变化；工作面横断面瓦斯体积分数分布不均匀，受瓦斯涌出、通风和抽放的影响，靠近煤壁侧瓦斯体积分数要高于采空区侧，在距离进风口约18~76.5 m范围内为凹函数分布，大于76.5 m之后，从煤壁至采空区为单调下降函数分布。

This mine is in after geological to 21212 working face, 31605 working face, 21604 working face condition and mine situation undertake on-the-spot perambulate, made corresponding exploitation plan a few days ago, strive to be below the case with geological complex condition, reclaim the coal that can pick more as far as possible, the mine that makes good triangle coal and working surface ending work, reclaim with what utmost land increases coal resource rate.

该矿在对21212工作面、31605工作面、21604工作面地质条件和开采情况进行实地勘查后，日前制定了相应的开采方案，力争在地质条件复杂的情况下，尽可能将可采的煤炭多回收，并做好三角煤的开采和工作面收尾工作，以最大限度地提高煤炭资源的回收率。

Mathematical models of shearer parameters and noise of coal working face, shearer parameters and temperature of coal working face were established according to appropriate hypothesis and predigestion. Based on established models, corresponding simulation programs were compiled, and simulation research was proceeded.

通过必要的假设与简化，建立了采煤机参数与工作面噪声和温升之间关系的数学模型，编制了相应的计算机模拟程序，利用所建模型进行了模拟研究。

According to a typical fully mechanized sublevel caving working face, this paper analyses the function of all equipments of this working face as a whole and researches the automatic control system of equipments of this working face with application of neural network theory.

本论文根据现有的一套综放工作面设备，对其各个部分的功能进行了分析，并应用人工神经网络技术进行了控制系统的研究。

In accordance with the case of large mining depth in Xingdong coal mine, study on coal floor strata failure depth test of working face 2121 was carried out by water injection test. According to variation of unit injection quantity and distance between testing boreholes and working face advance, coal floor strata failure depth was determined by continual water injection and intermitted monitoring.

摘要： 针对邢东矿大采深的情况，利用现场底板注水试验对2121工作面底板采动破坏深度进行了测试研究，依据单位注水量的动态变化以及注水孔与采线之间的距离关系，确定了底板破坏深度。

According to the threedimensional coordinates of any point on the working face measured by total station, CASIO measurement program can exactly work out the overbreak and underbreak volume of any point on the working face.

采用普通全站仪，可以测得隧道掌子面上任意点的三维坐标，然后通过手持CASIO计算器测量程序计算，即可精确算得此点相对该里程设计断面的超欠挖值。

On the basis of the mechanism research of nozzle spraying, the measurement of the particle size of droplet which produced by nozzle atomization, the dust examination on the working face and the simulation of dust along the whole working face, the author puts forward a optimized dust-laying system of support spraying, and it has obtained a good dust-laying effect dust-laying work.

由于综放工作面的产尘量较采用其它生产工艺的采煤工作面的产尘量要大，因此，从保护现场作业人员职业安全健康以及企业安全生产的角度考虑，必须将综放工作面的粉尘浓度控制在可容许的范围以内。

Based on the actual conditions of the 5342 fully mechanized caving face of Wulan Coal Mine, the 3-D distribution of gas in the face is tested by measuring points arrangement in the stereo grid. The isograms of gas distribution of the face are drawn. Gas concentration nadir distribution curve along the working face incline direction is drawn by method of seeking function minimum points. The method of calculating gas emission components ratio of the face by means of the curve is brought forward.

针对乌兰煤矿5342综放工作面的实际条件，采用立体网格状的测点布置，对该工作面瓦斯体积分数三维分布进行了测定，绘出了瓦斯分布等值线图，采用求函数极值点的方法，得出了工作面沿倾向瓦斯体积分数最低点分布曲线，提出了基于瓦斯体积分数最低点分布函数的瓦斯涌出分量比例计算方法。

It was shown that coal seam floor failure depth of working face 2121 was 32.5 to 5 m, approximately three times as deep as that of shallow working face(in genera l,9.15 to 12.0 m). Coal seam floor failure depth increased with mining depth. Potential risk of water inrush through coal seam floor of working face 2121 is much higher for deep mining than for shallow mining.

试验结果表明：该工作面底板破坏深度为32.5~35 m，比300 m采深以内的工作面实测深度(9.15~ 12.0 m)增加2倍以上，说明随着开采深度的增加，煤层底板采动破坏深度呈明显增大的趋势，因此，在水压和破坏深度二者同时增加的条件下，2121工作面深部煤层开采的突水危险性远远大于浅部煤层。

According to the state of the working coal seam where the working-face 706 of Xiaonan Mine exists and the characteristics of present routine technical measures taken to prevent and father the spontaneous combustion, the theory of fuzzy comprehensive appraisal is applied to analyze the plan about fire-protection technique for the working-face 706 of Xiaonan Mine.

根据晓南矿706工作面开采煤层的情况及目前常规的防治自燃技术措施的特点，运用运用模糊综合评判理论，对该工作面开采进行自燃防治方案进行的分析，综合考虑影响防火的各种因素，给出了一种新颖、简单、科学评价方法，提出了该工作面防火技术的最佳方案，取得了理想的防治效果。

But in the course of internationalization, they meet with misunderstanding and puzzlement.

许多企业已经意识到了这一点，但在国际化的进程中，仍存在一些误区与困惑。

Inorder toaccomplish this goal as quickly as possible, we'll beteamingup with anexperienced group of modelers, skinners, and animatorswhosenames willbe announced in the coming weeks.

为了尽快实现这个目标，我们在未来数周内将公布与一些有经验的模型、皮肤、动画制作小组合作。